FLIR N233VE Manual

FLIR Overvågningskamera N233VE

Læs nedenfor 📖 manual på dansk for FLIR N233VE (1 sider) i kategorien Overvågningskamera. Denne guide var nyttig for 64 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/1
PACKAGE CONTENTS: Installing the Camera Installing the Camera (continued)
3MP IP Vandal Dome Camera
N233VE
Quick Connection Guide
• Use an appropriate low voltage power cable to prevent fire or
electrical shock.
• Make sure to install the camera in an area that can support the
camera weight.
• There are no user serviceable parts inside the camera. Please do not
disassemble the camera.
• Do not clean the lens cover with an abrasive cleaning material. Please
use a lint free micro-fiber cloth to clean the lens cover.
• Camera is rated for outdoor use (IP66), but is not intended for
submersion in water.
Safety PrecautionsInserting the microSD Card
Resetting the Camera
Weights & Dimensions
Connecting the Camera
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
FCC Notice
1 2 3
Information in this document is subject to change
without notice. As our products are subject to continuous
improvement, FLIR Systems, Inc. and our subsidiaries reserve
the right to modify product design, specifications and
prices, without notice and without incurring any obligation.
E&OE © 2015 FLIR Systems, Inc. All rights reserved.
N233VE_QCG_EN_R1
1 x CD
1 x IP Vandal Dome Camera
Quick Start Guides
1 x Allen Key
3 x Mounting Screws 3 x Drywall Anchors
1 x Mounting Template
1 x RJ45 Waterproof Cap
0.8lb /
0.4kg
Weight
For support, visit
Latest software and manuals available on
www.flir.com/security/support
www.flir.com/security/support
A
A
A
B
B
B
C
C
C
D
D
E
E
Use the included mounting template to mark holes for
the mounting screws and camera cable.
Use the included Allen key to loosen the screws on the
dome cover. Remove the dome cover.
Remove the dome cover. Make sure the camera is powered on.
Remove the dome cover.
Slide the metal cover down to open it.
Reset button microSD slot
Insert the microSD card (not included)
into the slot.
Close the cover and slide it up to lock
the microSD card in place.
Replace the dome cover. Tighten the dome cover screws (3x).
Replace the dome cover. Tighten the dome cover screws (3x).
Press and hold the reset button on the camera base for 5 seconds to
reset the camera to default settings.
Drill holes for the mounting screws and camera cable.
Connect cables as shown in the section “Connecting the
Camera”.
Attach the camera base to the mounting surface using
the included mounting screws (3x).
NOTE: Use the included drywall anchors if installing into
drywall.
F
G
H
Set the position and angle of the camera.
Rotate the camera around the base (rotates 360°
before it is stopped).
Use a Phillips screwdriver to loosen the adjustment
screws on both sides of the camera module. Tilt the
camera module. Tighten both screws when finished.
Adjust the position of the camera lens by twisting the
camera lens housing.
Replace the dome cover. Use the included Allen key to
tighten the screws (3x).
Remove the vinyl film from the dome cover.
ATTENTION: Make sure IR LEDs are not blocked
by the dome cover to prevent IR reflection.
3.2” /
81mm
4.3” /
110mm
1 2 3
Power Input: If not using PoE, connect the camera to a
12V DC power source (370mA or higher required).
Alarm I/O (Optional): Connect alarm/sensor devices (not
included).
Ethernet Port: Connect the camera to an NVR or a router
or switch on your network using Cat5e or better Ethernet
cable (not included). PoE Class 3 supported.
NOTE: Install the included RJ45 waterproof cap if needed.
Audio I/O (Optional): See the Instruction Manual for
details.
1.
2.
3.
4.
1 2 34
1.
2.
3.
Mounting screws (3x)
Drywall anchors (3x)

Produkt Specifikationer

Mærke: FLIR
Kategori: Overvågningskamera
Model: N233VE

Har du brug for hjælp?

Hvis du har brug for hjælp til FLIR N233VE stil et spørgsmål nedenfor, og andre brugere vil svare dig


Overvågningskamera FLIR Manualer

FLIR

FLIR M42046 Manual

13 September 2024
FLIR

FLIR PT-117 Manual

8 September 2024
FLIR

FLIR Saros DH-390 Manual

4 September 2024
FLIR

FLIR T4350BN Manual

2 September 2024
FLIR

FLIR M500 Manual

25 August 2024
FLIR

FLIR Cloud N233BE Manual

25 August 2024
FLIR

FLIR Pinnacle DPV74TLUX Manual

19 August 2024
FLIR

FLIR G300 pt Manual

18 August 2024
FLIR

FLIR F-304 Manual

15 August 2024
FLIR

FLIR FB-393-O Manual

13 August 2024

Overvågningskamera Manualer

Nyeste Overvågningskamera Manualer

I-PRO

I-PRO WV-S2536LA Manual

17 December 2024
I-PRO

I-PRO WV-S2536LTA Manual

17 December 2024
I-PRO

I-PRO WV-S25500-F3L Manual

17 December 2024
I-PRO

I-PRO WV-S25500-F6L Manual

17 December 2024
I-PRO

I-PRO WV-S25600-V2L Manual

17 December 2024
I-PRO

I-PRO WV-S25500-V3L Manual

17 December 2024
I-PRO

I-PRO WV-S25500-V3LN1 Manual

17 December 2024
I-PRO

I-PRO WV-S25600-V2LG Manual

17 December 2024
I-PRO

I-PRO WV-S25700-V2LG Manual

17 December 2024
I-PRO

I-PRO WV-S25700-V2L Manual

17 December 2024