Furuno FA-30 Manual


Læs nedenfor 📖 manual på dansk for Furuno FA-30 (3 sider) i kategorien Splitter. Denne guide var nyttig for 9 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/3
www.furuno.co.jp
FA-30 VHF SPLITTER
MOUNTING PROCEDURE
The VHF splitter enables the AIS receiver and VHF transceiver to share a single VHF antenna.
Note: The FA-30 can not receive AIS signal when the VHF transceiver is transmitting.
Equipment Lists
VHF Splitter: Type OP05-106, Code No. 000-011-704
Mounting procedure
1. Open the detachable cover.
2. Unfasten four screws to separate the
chassis from the mounting plate.
3. Disconnect plugs on J7, J12 and the
ground wire from pcb 05P0807 .
No. Name Type Code No. Qty Remarks
1 VHF Splitter Assembly OP05-106-1 001-024-100 1 Rear panel + pcb 05P0817
2 Installation Materials CP05-11301 001-024-110 1 Cable tie CV-70N, 1 pc.
View Side View
1. Put fingers on both sides and
pull outwards and lift up to
take off.
2
. Unfasten
four
screws.
3. Disconnect. Ground wi
re


Produkt Specifikationer

Mærke: Furuno
Kategori: Splitter
Model: FA-30

Har du brug for hjælp?

Hvis du har brug for hjælp til Furuno FA-30 stil et spørgsmål nedenfor, og andre brugere vil svare dig