Harley Benton MET-A07 Manual


Læs nedenfor 📖 manual på dansk for Harley Benton MET-A07 (1 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 11 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
USER GUIDE
MET-A07 ONBOARD PREAMP
MET-A07 Quick Start
MET-A07 Controls
Specification
1. Set the controls
Set off. Set the , , and volume bass middle treble presence
controls to center.
2. Plug in
Connect the MET-A07 to an amplifier or PA with a ¼-inch
instrument cable. The battery light will flash once quickly to
indicate it has switched on.
3. Tune up
Raise the and adjust the and volume bass, middle, treble
presence controls to your liking.
1. Volume volume - For the cleanest signal, set the knob as
high as possible, without causing distortion or feedback.
2. Bass - Boost here to add depth and weight to the sound
of the guitar.
3. Middle middle - Turn the knob all the way left for a smooth
“scooped out” tone at high volume levels. Raise the middle
knob to the right of center to add midrange “bite” to the
sound.
4. Treble - boost to cut through the mix. Cut to mellow and
subdue the sound.
5. Presence - control the frequency between 15K-20K.
6. Notch - anti-feedback control
7. Power - Play a single note by your instrument, the string
number and note name will shown on the display. The light
and indicator change as following:
8. Note: Chromatic mode / guitar mode / bass mode
9. Pitch: 433 – 447 Hz , step 1Hz
10. Battery - When low-battery indicator lamp lights, please
change the battery.
The system requires a 9-volt battery. Draw out the battery
case located next to the input jack and replace the battery
according to the +/- sign.
The guitar cable should be removed from the guitar when
it’s not in use, to keep the battery from draining.
http://www.mings.cn
pointer on the initial
position: tuner standby
pointer keeps in centre:
The note is accutage
pointer points left:
The note is low
pointer points right:
The note is hight
Nominal Input Level: -20dBV
Input Impedance: M Ohm22
Output Impedance: 3.5K Ohm (20Hz< ~20KHz)
Nominal Output Level: -12dBV
THD: Less than .05% (-20dBV input)
Noise Floor: -97dB
Dynamic Range: 102dB
Battery Life: (360mAH,9V) 60 hours (EQ Working, Tuner off)
Bass Control Frequency: 60Hz
Middle Control Frequency: 500Hz
Treble Control Frequency: 3KHz
Pres Control Frequency: 10KHz point control(±7dB,Q=1)
AUTO GUITAR
FLAT
AUTO GUITAR
FLAT
AUTO GUITAR
FLAT
AUTO GUITAR
FLAT
AUTO GUITAR
FLAT


Produkt Specifikationer

Mærke: Harley Benton
Kategori: Ikke kategoriseret
Model: MET-A07

Har du brug for hjælp?

Hvis du har brug for hjælp til Harley Benton MET-A07 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Harley Benton Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

MPM

MPM -48-CW-48 Manual

9 November 2024
Alpine

Alpine KAE-123C Manual

8 November 2024
IFM

IFM AC434S Manual

8 November 2024
Alpine

Alpine SBS-0515 Manual

8 November 2024
Alpine

Alpine KCE-103V Manual

8 November 2024
Alpine

Alpine KCE-104V Manual

8 November 2024
Advantech

Advantech ECU-1051TL Manual

8 November 2024
Alpine

Alpine DDC-R13A Manual

8 November 2024
Alpine

Alpine HCE-C200F Manual

8 November 2024
Alpine

Alpine CRM-1652RF Manual

8 November 2024