Hikvision DS-PK-LRT(433MHz) Manual

Hikvision Adgangskontrolsystem DS-PK-LRT(433MHz)

Læs nedenfor 📖 manual på dansk for Hikvision DS-PK-LRT(433MHz) (2 sider) i kategorien Adgangskontrolsystem. Denne guide var nyttig for 9 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Configure the address via DIP switch of the keypad before powering on the
system. The address should be in the range of 0 to 31. The address of each
keypad should be unique.
The binary value shown in the diagram is 00010, which means the decimal value
is 2. So the address of the keypad is 2.
One Beep
Two Beeps
Pressing keys/command med out or too long/Fault Prompt.
Valid command/Report uploaded.
Five Beeps Invalid command/Failed to upload the report in 60 s.
Rapid Beeps Zone alarm/keypad not registered.
Three Long Beeps and Two Short Beeps
Three Beeps
Keypad tampered.
Keypad registered.
a. Dimension
b. Wiring
Note: Hybrid control panel does not support Z1, GND, NO/NC, COM.
c. Install Keypad
(1) Gangbox Moung
(2) Wall Moung
It is required to insert the screw for tamper alarm.
Indicator
Key
Beeps
Wiring and Installaon
English
Diagram Reference
Product Information
Specification
Components and Beeps
1
3
Operaon Commands4
Address Sengs
2
1 2
3
Alarm Keypad
164.13 mm 30.96 mm
124.11 mm
a
b
c
Query
Set
Fault
Network
Armed/Disarmed
Alarm
Fire Panic One-Push
to Arm
Project Bypass Scoll Up
Scoll Down
Solid Green: No Configuraon
Flashing Green: In the Configuraon Status
Solid Green: All Enabled Channels Connected Normally
Flashing Red: Alarm Occurred/Tamper Alarm
Solid Blue: Armed Off: Disarmed
Off: No Alarm
Off: Part of or All Enabled Channels Connected Abnormally
Solid Orange: System Fault Off: No Fault
D- D+ 12V GND
D- D+ 12V GND
Control Panel
This product and - if applicable - the supplied
accessories too are marked with "CE" and comply
therefore with the applicable harmonized European
standards listed under the RE Direcve 2014/53/EU,
the EMC Direcve 2014/30/EU, the LVD Direcve
2014/35/EU, the RoHS Direcve 2011/65/EU.
2012/19/EU (WEEE direcve): Products marked
with this symbol cannot be disposed of as unsorted
municipal waste in the European Union. For proper
recycling, return this product to your local supplier
upon the purchase of equivalent new equipment, or
dispose of it at designated collecon points. For
more informaon see: www.recyclethis.info
The Input voltage should meet both the SELV (Safety
Extra Low Voltage) and the Limited Power Source
according to the IEC60950-1 standard. Please refer
to technical specificaons for detailed informaon.
BIN=00010
DEC=2
E.G
1 2 3 4 5
(1) GANGBOX MOUNTING
(2) WALL MOUNTING
Hybrid control panel does not support Z1, GND,
NO/NC, COM.
Scan the QR code a to get programming manual of Hybrid control panel.
HighbitLowbit
Slowly Connuous Beeps In the Entry/Exit delay status, the Delay zone armed,
or 2 min before auto arming/disarming starng.
Rapidly Connuous Beeps In the Entry/Exit delay status, the Delay zone
triggered, or 1 min before auto arming/disarming
starng.
UD15865B-B
©2020 Hangzhou Hikvision Digital Technology Co., Ltd. All
rights reserved.
About this Manual
The Manual includes instrucons for using and managing
the Product. Pictures, charts, images and all other
informaon hereinaer are for descripon and explanaon
only. The informaon contained in the Manual is subject to
change, without noce, due to firmware updates or other
reasons. Please find the latest version of this Manual at the
Hikvision website (hps://www.hikvision.com/).
Please use this Manual with the guidance and assistance of
professionals trained in supporng the Product.
Trademarks
and other Hikvision's trademarks and logos
are the properes of Hikvision in various jurisdicons. Other
trademarks and logos menoned are the properes of their
respecve owners.
Disclaimer
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS
MANUAL AND THE PRODUCT DESCRIBED, WITH ITS HARDWARE,
SOFTWARE AND FIRMWARE, ARE PROVIDED “AS IS” AND “WITH
ALL FAULTS AND ERRORS”. HIKVISION MAKES NO WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION,
MERCHANTABILITY, SATISFACTORY QUALITY, OR FITNESS FOR A
PARTICULAR PURPOSE. THE USE OF THE PRODUCT BY YOU IS AT
YOUR OWN RISK. IN NO EVENT WILL HIKVISION BE LIABLE TO YOU
FOR ANY SPECIAL, CONSEQUENTIAL, INCIDENTAL, OR INDIRECT
DAMAGES, INCLUDING, AMONG OTHERS, DAMAGES FOR LOSS OF
BUSINESS PROFITS, BUSINESS INTERRUPTION, OR LOSS OF DATA,
CORRUPTION OF SYSTEMS, OR LOSS OF DOCUMENTATION,
WHETHER BASED ON BREACH OF CONTRACT, TORT (INCLUDING
NEGLIGENCE), PRODUCT LIABILITY, OR OTHERWISE, IN
CONNECTION WITH THE USE OF THE PRODUCT, EVEN IF HIKVISION
HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES OR
LOSS.
YOU ACKNOWLEDGE THAT THE NATURE OF INTERNET PROVIDES
FOR INHERENT SECURITY RISKS, AND HIKVISION SHALL NOT TAKE
ANY RESPONSIBILITIES FOR ABNORMAL OPERATION, PRIVACY
LEAKAGE OR OTHER DAMAGES RESULTING FROM CYBER-ATTACK,
HACKER ATTACK, VIRUS INSPECTION, OR OTHER INTERNET
SECURITY RISKS; HOWEVER, HIKVISION WILL PROVIDE TIMELY
TECHNICAL SUPPORT IF REQUIRED.
YOU AGREE TO USE THIS PRODUCT IN COMPLIANCE WITH ALL
APPLICABLE LAWS, AND YOU ARE SOLELY RESPONSIBLE FOR
ENSURING THAT YOUR USE CONFORMS TO THE APPLICABLE LAW.
ESPECIALLY, YOU ARE RESPONSIBLE, FOR USING THIS PRODUCT IN
A MANNER THAT DOES NOT INFRINGE ON THE RIGHTS OF THIRD
PARTIES, INCLUDING WITHOUT LIMITATION, RIGHTS OF PUBLICITY,
INTELLECTUAL PROPERTY RIGHTS, OR DATA PROTECTION AND
OTHER PRIVACY RIGHTS. YOU SHALL NOT USE THIS PRODUCT FOR
ANY PROHIBITED END-USES, INCLUDING THE DEVELOPMENT OR
PRODUCTION OF WEAPONS OF MASS DESTRUCTION, THE
DEVELOPMENT OR PRODUCTION OF CHEMICAL OR BIOLOGICAL
WEAPONS, ANY ACTIVITIES IN THE CONTEXT RELATED TO ANY
NUCLEAR EXPLOSIVE OR UNSAFE NUCLEAR FUEL-CYCLE, OR IN
SUPPORT OF HUMAN RIGHTS ABUSES.
IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND
THE APPLICABLE LAW, THE LATER PREVAILS.
3
Legal and Regulatory Information
M del DS-P -L DS-P -LRTo K K
Numeric key
Fu c keyn on
Display
K o N A oeyf b / Tw -way keyf bo
Tamper switch
RS-485 i terfacen
S u do n
Tag/ ard readi g / Supp rtC n N A o
P wer supplyo
P wero
c sumpon on
Temperature
Humidity
Dime sin on
L W )( × × H
Weight
12 keys: 0 t 9, , o * #
8 keys: Pr ject/ uery/Bypass/ e-push to Q On o
arm/Fire/Pa ic/Scr ll up/Scr ll d wn o o o n
L D screeC n
10 t 90% o %
-10 t 55 °C o °C
164 mm 124 mm 31 mm× ×
2 2 g7
1
1
buzzer
12 , 0.15 V A
1.8 W
1. The addional force shall be equal to three mes the
weight of the equipment but not less than 50N. The
equipment and its associated mounng means shall remain
secure during the installaon. Aer the installaon, the
equipment, including any associated mounng plate, shall not
be damaged.
2. Install the equipment according to the instrucons in this
manual.
3. To prevent injury, this equipment must be securely
aached to the wall in accordance with the installaon
instrucons.
INSTALLATION CAUTION


Produkt Specifikationer

Mærke: Hikvision
Kategori: Adgangskontrolsystem
Model: DS-PK-LRT(433MHz)

Har du brug for hjælp?

Hvis du har brug for hjælp til Hikvision DS-PK-LRT(433MHz) stil et spørgsmål nedenfor, og andre brugere vil svare dig




Adgangskontrolsystem Hikvision Manualer

Adgangskontrolsystem Manualer

Nyeste Adgangskontrolsystem Manualer

Panduit

Panduit ACF05 Manual

2 Oktober 2024
Viking

Viking K-1200 Manual

30 September 2024
Viking

Viking K-1275-IP-EWP Manual

30 September 2024
Viking

Viking K-1770-IP Manual

30 September 2024
Viking

Viking K-1270-EWP Manual

30 September 2024
Viking

Viking K-1770-3-EWP Manual

30 September 2024
Viking

Viking K-1200-IP Manual

30 September 2024
Viking

Viking K-1705-IP-EWP Manual

30 September 2024
Viking

Viking K-1770-3 Manual

30 September 2024