James 68QUE Manual

James Højttaler 68QUE

Læs nedenfor 📖 manual på dansk for James 68QUE (1 sider) i kategorien Højttaler. Denne guide var nyttig for 8 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/1

Many of our speaker grilles rely on adhesive to keep them in-place. This adhesive must be applied after painting of the grilles is completed, for this

reason the adhesive is shipped unapplied when paintable grilles are specied in the order.

There are two types of paintable grilles currently supplied by James Loudspeaker. The supplied grille type depends on the product ordered. For

example, if you’ve ordered from the SXC, QXC, QX, and SLT series you’ll receive a grille and a grille frame with snap connections (grille pins) or

magnets. If you’ve ordered from the FXA, FXC, FXCQ, OW, UE, SA, Wedge or the SPL series, then you’ll receive a grille that uses strips of foam with

adhesive on the back. These foam pads apply consistent pressure to keep the grille in place. Instructions on how to install both grille types can be

found below:

PAINTABLE GRILLE INSTRUCTIONS

Once the grille is assembled, it can now be

installed on to the speaker enclosure to nish

the installation.

If supplied with foam adhesive, evenly line the

edges of the grille, as shown above, with the

foam making sure to fold the excess toward

the back of the grille to avoid the foam from

showing on then front when installed.

20180918

4B 2

After the paint has completely dried, sand

to roughen the areas where the adhesive is

to be applied. For grills with a grille frame,

sand the underside of the grille about -inch 1

in from the outer diameter of the grille. For

grilles without a grille frame sand the entire

raised lip of the grille.

Grille Frame

Once the sanding has been completed, use a

lint-free cloth or compressed air to clean the

sanded surface.

Once received the grille can be

painted to better match the

installation environment.

III

If supplied with a grille frame remove the tape

from the rear of the grille frame to expose

the adhesive, then ip the grille frame, rmly

and evenly press the side with the adhesive

onto the back of the grille to secure it into

place.

Produkt Specifikationer

Mærke:	James
Kategori:	Højttaler
Model:	68QUE
Bredde:	206.38 mm
Dybde:	101.6 mm
Højde:	1016 mm
Udgangseffekt (RMS):	200 W
Husmateriale:	Aluminium
Anbefalet brug:	Universel
Frekvensområde:	60 - 40000 Hz
Impedens:	4 ohm (Ω)
Diskanthøjttaler:	Ja
Antal drivere til diskant:	4
Sensitivitet:	96 dB
Diskant diameter:	25 mm
Bashøjttaler:	Ja
Antal bashøjttalerdrev:	4
Woofer diameter:	165 mm