JL Audio MVi-Hub Manual

JL Audio Grillplade MVi-Hub

Læs nedenfor 📖 manual på dansk for JL Audio MVi-Hub (2 sider) i kategorien Grillplade. Denne guide var nyttig for 14 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

CONNECTION GUIDE

with

Planning Your Installation

It is important that you take the time to read this manual thoroughly and that you plan your installation

carefully. It is very easy to damage electrical systems in modern vessels. Never assume that you have found

appropriate wires without consulting a reliable wiring diagram or without using proper test equipment. If

you are uncomfortable or unfamiliar with diagrams or testing methods, please enlist the services of your

authorized JL Audio dealer to perform the installation. Your authorized dealer has the training, expertise and

installation equipment to ensure optimum performance from this product.

If you have any questions regarding the instructions in this manual or any aspect of your amplifier’s

operation, please contact your authorized JL Audio dealer for assistance. If you need further assistance,

please contact the JL Audio Technical Support Department at technical@jlaudio.com/support.

Safety Considerations

• Install this product in a dry, well-ventilated location that does not interfere with factory installed systems.

• This product should never be submerged under water or subjected to high-pressure water spray.

• Do not install where it will be directly exposed to the elements, or in the engine compartment, or in any

areas of

extreme heat. Areas exposed to a heater or hot air should also be avoided.

• When selecting a mounting location, consider the orientation of the chassis and its associated connections.

When possible, route wiring and cables to direct condensation and moisture away from the amplifier.

• Securely mount this product so that it does not come loose in the event of a collision

or sudden jolt, or as a result of repeated vibrations during normal operation.

• Check before drilling to make sure that you will not be drilling into an exterior panel/hull, fuel tank, fuel line,

wiring harness, or other vital system.

• Do not run system wiring outside or underneath the vessel. This is an extremely

dangerous practice, which can result in severe damage/injury.

• Protect all system wires from sharp edges by carefully routing them, tying

them down and using grommets and loom, where appropriate.

• Secure all wiring as needed, using cable ties or wire clamps to

protect them from moving parts and sharp edges.

What is Included

(1) MVi-HUB

(1) Connection Guide

Product Description

The MVi-HUB is an accessory designed to provide network connectivity for up to six MVi amplifiers in a multi-amp system.

Networking greatly simplifies the configuration process by permitting the setup and/or tuning of all amplifiers using a single

TüN™ project file. (See section for more info.) Additionally, networking synchronizes DSP presets of all amplifiers What is TüN?

and distributes commands from a single Digital Remote Controller (DRC) across the entire amplifier network.

The MVi-HUB includes JLid-COMM ports to connect up to six amplifiers (one “Master” MVi amplifier and up to five “Slave” MV or

MVi amplifiers). Power for the MVi-HUB is provided by the connected amplifiers. Note: a “Master” MVi amplifier connection is

required for MVi-HUB operation. The MVi-HUB utilizes a proprietary JLid™ communication protocol via standard CAT5e network

cables (not included). Use only CAT5e type network cables and keep cable lengths as short as possible for optimum performance.

Audio signals are NOT transmitted via JLid-COMM connections.

The MVi-HUB has a dedicated JLid-CTRL port for the connection of a compatible accessory (sold separately). Refer to the JLid-

CTRL Port section on the next page for additional info.

Mounting Considerations

The MVi-HUB is equipped with keyhole style mounting

holes to simplify installations in confined spaces or

vertical-mount applications. Mounting screws may be

preinstalled, allowing connections to be made prior to

securing in its final location. See diagram at right.

When selecting the installation location, consider

the mounting orientation of the MVi-HUB and its

associated connections. If possible, position the

MVi-HUB vertically, with all connections pointing

downward. Wiring and cables should be routed to

direct potential condensation and moisture away

from its chassis. When installed in this manner, the

MVi-HUB achieves an IPX2 water-resistance rating.

Limited Warranty – Electronics (USA)

JL Audio warrants this product to be free of defects in materials and workmanship for a period of two (2) years from the original date of purchase.

This warranty is not transferrable and applies only to the original purchaser from an authorized JLAudio dealer. Should service be necessary

under this warranty for any reason due to manufacturing defect or malfunction, JL Audio will (at its discretion), repair or replace the defective

product with new or remanufactured product at no charge. Damage caused by the following is not covered under warranty: accident, misuse,

abuse, product modification or neglect, failure to follow installation instructions, unauthorized repair attempts, misrepresentations by the seller.

This warranty does not cover incidental or consequential damages and does not cover the cost of removing or reinstalling the unit(s). Cosmetic

damage due to accident or normal wear and tear is not covered under warranty.

Products installed as original equipment by boat manufacturers are covered by the boat manufacturer’s warranty, not JLAudio, Inc.

Warranty is void if the product’s serial number has been removed or defaced.

Any applicable implied warranties are limited in duration to the period of the express warranty as provided herein

beginning with the date of the original purchase at retail, and no warranties, whether express or implied, shall apply to

this product thereafter. Some states do not allow limitations on implied warranties, therefore these exclusions may not

apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.

If you need service on your JL AUDIO product:

All warranty returns should be sent to JL Audio ’s Amplifier Service Facility freight-prepaid through an authorized JL Audio dealer and

must be accompanied by proof of purchase (a copy of the original sales receipt). Direct returns from consumers or non-authorized

dealers will be refused unless specifically authorized by JL Audio with a valid return authorization number. Warranty expiration on

products returned without proof of purchase will be determined from the manufacturing date code. Coverage may be invalidated

as this date is previous to purchase date. Non-defective items received will be returned freight-collect. Customer is responsible

for shipping charges and insurance in sending the product to JL Audio. Freight damage on returns is not covered under warranty.

For Service Information in the U.S.A. please call

JL Audio Customer Service:

(954) 443-1100 9:00 AM – 5:30 PM (Eastern Time Zone)

JL Audio, Inc.

10369 North Commerce Pkwy. Miramar, FL 33025

(Do not send product for repair to this address)

International Warranties:

Products purchased outside the United States of America are covered only

by that country’s distributor and not by JL Audio, Inc.

Due to our policy of continuous product development, all specications are subject to change without notice.

MVi-HUB_MAN_070819

Produkt Specifikationer

Mærke:	JL Audio
Kategori:	Grillplade
Model:	MVi-Hub

Har du brug for hjælp?

Hvis du har brug for hjælp til JL Audio MVi-Hub stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Grillplade JL Audio Manualer

JL Audio ETXv3 M-MCPv3-DM Manual

8 September 2024

JL Audio MVi-Hub Manual

28 Juli 2024

JL Audio ETXv3 M-MCPv3-1.31 Manual

19 Juli 2024

JL Audio ETXv3 M-SWMCPv3-1.315 Manual

18 Juli 2024

Grillplade Manualer

Nyeste Grillplade Manualer

Yamazen EDH-W1300 Manual

31 Oktober 2024

Yamazen YGMD-WX130 Manual

31 Oktober 2024

Yamazen YMCP-S650 Manual

31 Oktober 2024

Yamazen YGMA-X100 Manual

31 Oktober 2024

Yamazen YHL-S100 Manual

31 Oktober 2024

Yamazen YHE-B132 Manual

31 Oktober 2024

Yamazen YGMC-FX130 Manual

31 Oktober 2024

Yamazen YGF-W130 Manual

31 Oktober 2024

Yamazen YOH-200 Manual

31 Oktober 2024

Yamazen YGMC-FXT130 Manual

31 Oktober 2024