KitchenAid W10188988 Manual


Læs nedenfor 📖 manual på dansk for KitchenAid W10188988 (4 sider) i kategorien Opvaskemaskine. Denne guide var nyttig for 9 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/4
For Drawer Dishwasher (Single and Double Drawer)
Door Panel Removal:
Attaching Handle:
4.Measure and mark the location of the handle. The vertical
location is customer preference. Mount the handle to the
customer-supplied custom outer door panel using the two (2)
mounting screws provided.
IMPORTANT: The screws must not extend beyond the back
surface of the panel. The screw holes should be countersunk for
the screw heads to be flush with the panel.
5. Install the door panel reversing steps 1, 2, and 3 of “Door
Panel Removal” section.
6. Repeat steps 1-5 to install the handle on the other dish
drawer (for Double Drawers).
Installation Instructions
Dishwasher Handle Accessory Kit
W10084565A
IMPORTANT: A qualified service technician should perform this
installation. Wear gloves and handle panels gently.
Custom Accessory Kit contains:
1 Handle
2 Mounting Screws
Installation Procedures
NOTE: If door panel must be removed to install new door handle,
follow steps below:
Door Panel Removal:
1.Open dishwasher door and use a T-15 Torx™ screwdriver to
remove three (3) to four (4) screws on each side - total of six
(6) to eight (8) screws. See below for location of screws to be
removed. Hold inner and outer door panels together until all of
the screws are removed.
2.Partially close dishwasher door and tilt out the outer door
panel. Lift up outer panel and remove. Set panel aside on a
towel or covered surface to avoid scratching.
Remove (8)
screws (some
models use only
(6) screws for
panel removal)
Attaching Handle:
1.Measure and mark the location for the handle. The handle
should be centered horizontally on the front of the customer-
supplied custom panel. The vertical location is customer
preference. Mount the handle to the custom outer door panel
using the two (2) mounting screws provided.
IMPORTANT: The screws must not extend beyond the back
surface of the panel. The screw holes should be countersunk for
the screw heads to be flush with the panel.
2.Install the custom door panel, reversing steps 1 and 2 of
“Door Panel Removalsection.
pin
Pin
Front of drawer
1.Remove the pins on both sides
of the dishwasher drawer by
pulling the pins straight out
with a pair of needle-nose
pliers.
2.Gently pull the bottom of the
panel away from the
dishwasher and then pull
down.
3.Remove the three (3) screws
on each side from the three
inner holes to access back of
front panel.


Produkt Specifikationer

Mærke: KitchenAid
Kategori: Opvaskemaskine
Model: W10188988

Har du brug for hjælp?

Hvis du har brug for hjælp til KitchenAid W10188988 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Opvaskemaskine KitchenAid Manualer

Opvaskemaskine Manualer

Nyeste Opvaskemaskine Manualer

Nabo

Nabo GSV 1046 Manual

21 November 2024
Nabo

Nabo GSI 1050 Manual

21 November 2024
Nabo

Nabo GSI 1047 Manual

21 November 2024
Nabo

Nabo GSI 1510 Manual

21 November 2024
Bosch

Bosch SMU50E65AU Manual

20 November 2024
Caple

Caple DI654 Manual

18 November 2024
Teka

Teka DW8 55 FI Manual

16 November 2024
Electrolux

Electrolux EEEM9420L Manual

15 November 2024