Klark Teknik CT-1 Manual


Læs nedenfor 📖 manual på dansk for Klark Teknik CT-1 (2 sider) i kategorien Microfoon. Denne guide var nyttig for 2 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Quick Start Guide
MIC BOOSTER CT 1 / CM-1 / CM-2
Thank you for purchasing a Klark Teknik Mic Booster! These compact units add signicant gain boost to your passive microphone signal to
ensure strong, clear delivery to a mixing board, preamplier or interface.
*note – the CT 1 can also be connected directly to most microphones
Setup Procedure
Warning – either mute the mixer channel, lower the volume all the way, or turn o the speaker system before making connections.
1. Connect a fairly short balanced XLR cable (<30 feet) from the microphone to the input of your Mic Booster. Note that phantom power
cannot be passed to condenser mics, and therefore they shouldn't be used along with a mic booster unit.
2. Connect the output of the Mic Booster to a mixer, preamp, or interface via balanced XLR cable. Long cable runs can be used for
this connection if necessary, but high quality XLR cables with low capacitance are recommended to avoid high frequency degradation.
3. Engage phantom power on the mixer or other receiving equipment.
4. Check the gain setting on the receiving channel of your mixer or interface since the signal will be much greater than typical mic levels.
OutputInput
Dynamic or
passive ribbon
microphone
CT 1, CM-1, or CM-2
Mixer with phantom
power engaged


Produkt Specifikationer

Mærke: Klark Teknik
Kategori: Microfoon
Model: CT-1

Har du brug for hjælp?

Hvis du har brug for hjælp til Klark Teknik CT-1 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Microfoon Klark Teknik Manualer

Klark Teknik

Klark Teknik CM-1 Manual

23 August 2024
Klark Teknik

Klark Teknik CM-2 Manual

23 August 2024
Klark Teknik

Klark Teknik CT-1 Manual

23 August 2024

Microfoon Manualer

Nyeste Microfoon Manualer