Korg GA Custom Manual

Korg DJ udstyr GA Custom

Læs nedenfor 📖 manual på dansk for Korg GA Custom (7 sider) i kategorien DJ udstyr. Denne guide var nyttig for 22 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/7

Precautions

Location

Using the unit in the following locations can result in a malfunction.

• In direct sunlight.

• Locations of extreme temperature or humidity.

• Excessively dusty or dirty locations.

• Locations of excessive vibration.

• Close to magnetic elds.

Power supply

Be sure to turn the power switch to OFF when the unit is not in use.

Remove the battery in order to prevent it from leaking when the unit is

not in use for extended periods.

Interference with other electrical devices

Radios and televisions placed nearby may experience reception

interference. Operate this unit at a suitable distance from radios and

televisions.

Handling

To avoid breakage, do not apply excessive force to the switches or

controls.

Care

If the exterior becomes dirty, wipe it with a clean, dry cloth. Do not use

liquid cleaners such as benzene or thinner, or cleaning compounds or

ammable polishes.

Keep this manual

After reading this manual, please keep it for later reference.

Keeping foreign matter out of your equipment

Never set any container with liquid in it near this equipment. If liquid gets

into the equipment, it could cause a breakdown, re, or electrical shock.

Be careful not to let metal objects get into the equipment.

THE FCC REGULATION WARNING (for USA)

NOTE: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equip-

ment generates, uses, and can radiate radio frequency energy and,

if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

If items such as cables are included with this equipment, you must

use those included items.

Unauthorized changes or modication to this system can void the

user’s authority to operate this equipment.

Notice regarding disposal (EU only)

If this symbol is shown on the product, manual, battery, or

package, you must dispose of it in the correct manner to avoid

harm to human health or damage to the environment. Contact

your local administrative body for details on the correct dis-

posal method. If the battery contains heavy metals in excess

of the regulated amount, a chemical symbol is displayed

below the symbol on the battery or battery package.

Thank you for purchasing the Korg GA Custom chromatic tuner.

Merci d’avoir choisi l’accordeur Chromatique GA Custom de Korg.

Vielen Dank, dass Sie sich für das chromatische Stimmgerät GA

Custom von Korg entschieden haben.

Gracias por comprar el anador cromático GA Custom de Korg.

このたびは、コルグクロマチック・チューナー GA Customを

お買い上げいただきまして、まことにありがとうございます。

GA Custom

CHROMATIC TUNER

アフターサービス

修理および商品のお取り扱いについてのご質問、ご相談は、お客

様相談窓口へお問い合わせください。

お客様相談窓口

PHS等一部の電話ではご利用できません。固定電話また

は携帯電話からおかけください。

受付時間月曜～金曜 10:00 ～ 17:00

（祝祭日、窓口休業日を除く）

●サービス・センター :

〒168-0073　東京都杉並区下高井戸1-15-12

■お願い

保証書に販売年月日等の記入がない場合は無効となります。記入でき

ないときは、お買い上げ年月日を証明できる領収書等と一緒に保管し

てください。

保証書は再発行致しませんので、紛失しないように大切に保管してく

ださい。

コルグ　GA Custom 保証書

本保証書は、上記の保証規定により無償修理をお約束するものです。

お買い上げ日年月日

販売店名

IMPORTANT NOTICE TO CONSUMERS

This product has been manufactured according to strict specica-

tions and voltage requirements that are applicable in the country

in which it is intended that this product should be used. If you have

purchased this product via the internet, through mail order, and/or

via a telephone sale, you must verify that this product is intended

to be used in the country in which you reside.

WARNING: Use of this product in any country other than that for

which it is intended could be dangerous and could invalidate the

manufacturer’s or distributor’s warranty.

Please also retain your receipt as proof of purchase otherwise your

product may be disqualied from the manufacturer’s or distribu

tor’s warranty.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause

undesired operation.

CAN ICES-3 B / NMB-3 B.

The new seing will blink three times in the note name display indicat-

ing the calibration has been set. The GA Custom will automatically

return to tuner mode.

The calibration seing will be remembered even if the power is turned o. How-

ever, this seing will be reset to the factory default if the baeries are removed.

Setting the display mode

The GA Custom allows you to choose one of three display mode seings.

The factory seing is Regular mode.

1. PresstheDISPLAYbuon.

The current seing will blink for several seconds in the note display

(Light → Blink).

2. When the seing is shown in the note name display, press the

Displaybuonagaintosetthedisplaymode.

Each time you press the DISPLAY buon you will cycle through the

following seings.

1: Regular

Tune your instrument until the green LED in the LED meter is lit. The

blue LEDs at the right will light up if the pitch is high, and the blue

LEDs at the boom will light left if the pitch is low.

The pitch is sharp.In tune.The pitch is flat.

2: Strobe

Tune your instrument until the LEDs stop running. Since the strobe

meter has higher precision, it allows you to tune with greater accuracy.

The illumination will ow from left to right if the pitch is high, or from

right to left if the pitch is low.

The pitch is sharp.In tune.The pitch is flat.

3: Half-strobe

Tune your instrument until the LEDs stop running and only the green

LED is lit. The blue LEDs at the right will strobe if the pitch is high,

and the blue LEDs at the left will strobe if the pitch is low. When the

pitch is in tune, only the green LED is lit.

The pitch is sharp.

In tune.

The pitch is flat

3. Afteryou’vechosenthedisplaymodeyouwouldliketouse,wait

approximatelytwosecondswithoutpressinganybuons.

The note name display will blink two times, the display mode will

be set, and the GA Custom will automatically return to tuner mode.

The display mode seing will be remembered even if the power is turned o.

However, this seing will be reset to the factory default if the baeries are removed.

Specications

Scale: 12-note equal temperament

Range(sinewave): A0 (27.50 Hz)–C8 (4186 Hz)

Referencepitch: 436–445 Hz (1 Hz steps)

Precision: +/-0.1 cent

Inputimpedance: 1 M-ohm

Powersupply: Two AAA manganese dry cell, alkaline dry cell or NiMH

rechargeable baeries

Baerylife: approximately 50 hours: manganese dry cell

(A4 input continuously, display mode: Regular)

Dimensions: 99 mm(W) X 65 mm(D) X 16 mm(H)

3.90’’ (W) X 2.56’’ (D) X 0.63 ’’ (H)

Weight: 83 g/2.93 oz. (including baeries)

Includeditems: Two AAA baeries

• Specications and appearance are subject to change without notice for

improvement.

Parts of the GA Custom

Installing the batteries

Make sure to turn the power o before you install or replace the baeries.

When the baeries are almost depleted, the green LED in the tuning

LED meter will blink. When this happens, install new baeries as soon

as possible to ensure accurate tuning

1.Openthebaerycover,locatedonthebackofthetuner

2.Insertthebaeries,makingsuretoobservethecorrectpolarity.

3. Returnthebaerycovertoitsoriginalposition.

Battery

cover

Preparation

Connect the instrument to be tuned to the INPUT jack, and connect the

eect pedal, amp, etc., to the OUTPUT jack.

Turn o the power of all devices before you make any connections to avoid

damaging your equipment.

The INPUT and OUTPUT jacks are mono. Stereo (TRS) cables will not work.

When using the internal mic for tuning, make sure nothing is connected

to the INPUT and OUTPUT jacks. The internal mic cannot be used when

a device is connected.

Tuning

1. Pressthepowerbuon.Thepowerwillturnon/oeachtimeyou

pressthisbuon.

The calibration seing will appear in the note name display for a few

seconds (light blinking). →

In addition, the green LED in the tuning LED meter will light up.

If the power is left on for approximately 3 minutes without any user

input, it will turn o automatically.

2. Ifdesired,adjustthecalibrationand/orselectthedisplaymode.

3. Playasinglenoteonyourinstrumentandtuneitsothatthedesired

noteappearsinthenotenamedisplay.

The note name closest to the entered note appears in the note name

display.

4. TuneyourinstrumentusingthetuningLEDmeter.

The method for indicating whether your instrument is in tune, sharp

or at depends on which display mode you choose.

Even if the pitch is within the range of detection, it may not be possible to detect

the pitch of an instrumental sound that contains large numbers of overtones

or a sound that has a rapid decay.

Adjusting the calibration

The GA Custom comes from the factory with the calibration set to

A=440Hz. If an adjustment is necessary, you can do so within a range

of 436–445Hz.

1. PresstheCALIBbuon.

The current calibration seing will blink for several seconds in the

note namedisplay (Light → Blink).

2. While the current calibration seing is shown in the note name

display,presstheCALIBbuonagaintoadjusttheseing.

Each time you press the CALIB buon you will cycle through the

following seings.

0: 440 Hz, 1: 441 Hz, 2: 442 Hz, 3: 443 Hz, 4: 444 Hz, 5: 445 Hz,

6: 436 Hz, 7: 437 Hz, 8: 438 Hz, 9: 439 Hz

3. Afteryouhaveselectedyourdesiredcalibrationseing,waitap-

proximatelytwosecondswithoutpressinganybuons.

CALIB buttom

DISPL buttoAY

Power button

Battery cover

Note name

displa

Internal mic

OUTPUT jack

(mono)

INPUT jack (mono)

Tuning LED meter

Produkt Specifikationer

Mærke:	Korg
Kategori:	DJ udstyr
Model:	GA Custom

Har du brug for hjælp?

Hvis du har brug for hjælp til Korg GA Custom stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

DJ udstyr Korg Manualer

Korg SyncMetronome Manual

28 Maj 2024

23 April 2024

18 April 2024

8 April 2024

5 April 2024

1 April 2024

Korg Volca Sample 2 Manual

4 Februar 2024

Korg PX1T Manual

11 Januar 2024

Korg Toneworks AX3G Manual

9 Januar 2024

Korg A4501 Manual

4 Januar 2024

DJ udstyr Manualer

Nyeste DJ udstyr Manualer

Atomix Virtual DJ 5.1 Manual

19 December 2024

Denon DJ Prime 2 Manual

19 December 2024

Denon DJ X1850 Prime Manual

19 December 2024

Denon DJ MCX8000 Manual

18 December 2024

NUX PT-6 Manual

9 December 2024

Headliner Gigastand Manual

7 December 2024

Festo CPX-E-CEC-C1 Manual

17 November 2024

Festo CPX-E-CEC-M1-EP Manual

17 November 2024

Festo CPX-E-CEC-C1-EP Manual

17 November 2024

Festo CPX-E-CEC-M1-PN Manual

17 November 2024