Koss TWS150i Manual

Koss Ikke kategoriseret TWS150i

Læs nedenfor 📖 manual på dansk for Koss TWS150i (1 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 15 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/1

Method 1

Method 2

1. Charging case with battery life status lights

2. USB charging port

3. Earbud status light

4. Touch strip

5. Voice mic

6. Acoustical vent hole

7. L/R indicator

8. Magnetic charging contacts

Included

E Cushi sar on

E sarbud

Charging Cable

Chargi eng Cas

In u sstr ction

Start P r Onowe

Mo il hone an Head honeb e P s d p s

Pairing

Bluetooth Off

Answer Call

Connect Loion st Factory Reset

Incoming call

End Call P ay ause/Pl

Music

Reject Call:

Out of Connection Range

Open the charging case, the white lights will illuminate for 1 second.

The earbuds will automatically power on.

Earbuds Charging

Charging

Place e ea s i charging c e.th rbud n e th as

Ch ngargi : The left and right lights of the charging case will flash

Fu y ar : No charging case s are i dll ch ged light illum nate

Charging Case Light Language

LED statu whes n the cha inrg g case is cha inrg g

LED statu whes n cha inrg g case is not cha inrg g

Wh n e the power is below 30%, the left light flas esh .

Wh n e the power is 60 30%~ %, the left li alw ys ght is a on

and the center light flashes.

Wh n e the power is greater than 60%, the left a cend nter

li tsgh are alw ysa on and the ri t ght ligh f hlas es.

When the po 100%, wer is all 3 li tsgh remain on.

Safety and Care

Hold for 2 seconds

<10%

10%~30%

30%~60%

70%~100%

Wh n e the werpo is below 10%, the left li t gh f hlas es.

Wh n e the werpo is 10%~30%, the ft le light is on.

When the power is 30%~60%, th fe le t a cend nter li tsgh are on.

Whe n power is 70%~ 00%,1 all 3 li tsgh remain on.

LED Status When the Charging Case Charges

the Earbuds

The L side charging case light slowly flashes when the L earbud is charging.

The R side charging case light slowly flashes when the R earbud is charging.

When L and R earbuds are charged at the same time, the L and R charging

case lights slowly flash at the same time.

When the earbud’s batteries are full, the charging case lights

will indicate the battery power level for 5 seconds.

<30%

30%~60%

>60%

100%

Using earbuds at high volumes for extended periods of time may result in

permanent hearing damage. It is advised you keep volume levels moderate Model: 702334, 3.7V, 500mAh

GOLDEN CEL BATTERY CO. LTD.

Yinhu Industrial Park, Jiaoyitang Management Zone

Tngxia Town, Dongguan City, Guangzhou Province

to low at all times for your safety.

Do not use while driving a car, cycling, operating machinery, or performing other

activities that require hearing surrounding sounds.

Earbuds may not work properly under high temperature or high humidity conditions.

Do not use any corrosive cleaner/oil to clean the earbuds.

If the earbuds come in contact with liquids, quickly wipe away .If submerged in

water, do not turn the earbuds on until completely dried.

Tips: liquid submersion voids the warranty.

Keep the earbuds and packaging out of reach of children.

* Do t d a , s ke, sh or t e ry i o fire. Do t ex se no is ss leemb tri cru pu th batte nt no po

th tt conduct mater qu mperatue ba ery to ive ia , lils ids, fire, or high te res.

* Do t a ow l e s to h e two les of e ry. Do t no ll meta obj ct touc th po th batte no

cont nu th batte ha bu co orat on odor ani e to use e ry if it s lges, leaks, dis l i , s, or y

othe bnormar a lity.

* Do t use e ry r it s n submerged in water. no th batte afte ha bee

* If e ry is used i r ly, it may expl e or , ng s d th batte mp oper od leak causi burn an

othe ona njur th batt hou ca fu por pers l i ies. If e er y leaks, it s ld be re ll isy d sed of

acco th oca an gu at on conc rnrding to e l l ws la d re l i s e ing ry d sal.batte ispo

FC arnC W ing

- Reorient or relocate the receiving antenna

- Increase the separation between the equipment and receiver

- Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected

- iaCon th per ence rad o/ technsult e dealer or an ex i d i TV ic n r lp. The fo he

device s en eval d to et l RF sure r ir . The ha be uate me genera expo equ ement

device n be used in r le sure ition wi t res i i .ca po tab expo cond thou tr ct on

FCC RF exposure statement:

The i t es with C i ion ex sure mit set rth r equ pmen compli FC Rad at po li fo fo

uncont onm nt Th equ pmen houl an oper tero ed en rll vi e . is i t s d be inst ed all d a d

wi isth mini m dmu tanc 0c betwee th rad ato an ou bode 2 m n e i r d y r y.

Battery warning!

Double-tap

Double-tap on the L/R

touch s ip.tr

Long hold eth L/R touch s ip r 2 s s.tr fo econd

Double-tap on the L/R

touch s ip.tr

Power Off

P ce la th rbud nt the ea s i o e charging case and closed the lid

to a i y wer down earbuds.utomat call po

Product Overview

Po the f t s be in he wer on le t and righ earbud as descri d t

“Po O th id wer n” po on of rti is gu e.

Fi select et listnd nd a "KOSS TWS150i" in the lu B oo h t .

NOTE:

1. e the s uto the tWh n power is on, earbud will a -connect with las

c d d hi I th , onnecte evice wit n 10 seconds. f e connection fails

the s n e earbud will e ter pairing mod .

2. the t any , h l If ear ectebuds are t c no onn d o device t ey wil

aut tur af i s omatically n off ter 10 m nute

Next Track

Hold the right earbud touch strip for 2s

Hold the left earbud touch strip for 2s

Note: This function is not supported

when L earbuds are used alone.

Previous Track

D the t ch p au inouble tap L/R earbud ou stri to p se lay sic/p mu

sta y r sic ndb o mu mode.

Wh d: nd gh um on ondile se pau I icator li ts ill inate ce every 5 sec s

Wh ng: nd gh um on ondile layi p I icator li ts ill inate ce every 5 sec s

D pouble-ta

Specs

1. Bluetooth Version：Bluetooth V5.0

2. Input Power：5.0V 380mA

3. Charging time：< 2h

KOSS TWS150i

0：35

While earbuds are in an off state, touch and hold the touch strip of

both earbuds for about 3 seconds, lights will illuminate for 1 second

to show the earbuds are powered on.

* Protective film must be removed from earbuds

before they can be powered on and paired

Problem: If Bluetooth on source device is turned off, the earbuds will

automatically turn off after 10 minutes. If earbuds are disconnected, the

L/R earbuds’ red and white lights will flash alternately.

1. Open the lid of the charging case and allow both earphones to power

on.

2. While the earphones are in the charging case, tap the touch surface of

either the left or right earphone 3 times and allow both earphones to

power off. NOTE: Tap the touch surface of the earphone 3 times in

less than 1 second.

3. Remove both earphones from the charging case and close the lid.

4. Press and hold the touch surface of either the left or right earphone

until the LED flashes red 3 times (about 10 seconds).

5. Perform Step 4 with the opposite earphone.

6. Open the lid of the charging case and return both earphones. Close

the lid.

7. Factory reset complete.

Solution: Make sure that the source device’s Bluetooth is turned on; then

power on earbuds again.

Problem: If the connection between the device and the earbuds exceeds

the effective range, the earbuds will power off automatically after 10

minutes.

Solution: Make sure that device is in range, then power on earbuds.

TWS150i TRUE WIRELESS EARBUDS

INS RU IONT CT S

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates uses and can radiate radio frequency energy

and. if not installed and used in accordance with the instructions may cause harmful

interference to radio communications, however, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

Produkt Specifikationer

Mærke:	Koss
Kategori:	Ikke kategoriseret
Model:	TWS150i

Har du brug for hjælp?

Hvis du har brug for hjælp til Koss TWS150i stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Koss Manualer

28 August 2024

28 August 2024

28 August 2024

28 August 2024

28 August 2024

Koss KSC35 Wireless Manual

28 August 2024

Koss BTS1 Manual

28 August 2024

Koss CS340BT QZ Manual

28 August 2024

Koss BT330i Manual

28 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Senal SCI-3212MP Manual

22 November 2024

Matterport Pro2 3D Camera MC250 Manual

22 November 2024

Senal OLM-2S-P Manual

21 November 2024

Senal ME-220-CL Manual

21 November 2024

Senal ASM-4 Manual

21 November 2024

Senal CS-88 Manual

21 November 2024

Senal CSP-162 Manual

21 November 2024

Senal MXGN-ICS Manual

21 November 2024

Dubatti Board Two Manual

21 November 2024

Senal ASM-3 Manual

21 November 2024