Kramer SKIC-8 Manual

Kramer højttalerstøtte SKIC-8

Læs nedenfor 📖 manual på dansk for Kramer SKIC-8 (2 sider) i kategorien højttalerstøtte. Denne guide var nyttig for 8 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/2
SKIC Speaker Mounting Kit
Congratulations on purchasing your Kramer SKIC Speaker Mounting Kit which used for is
securing in-ceiling speakers to the ceiling T-channel grid and comes in three sizes: SKIC-4 for
the Galil 4-CO, SKIC-6 for the Galil 6-CO for the and SKIC-8 Galil 8-CO.
The back can speakers are supported by a C-ring and two tile rails he tile rails prevent the (t
speakers from falling if the tile itself comes out or falls apart, as their ends catch onto the
T-grid). When mounting onto the ceiling tiles, use both supports. When mounting onto a
sheetrock ceiling, the C-ring alone is used to reinforce the ceiling material.
Be sure that the tiles can support the speaker. Smaller sized tiles or fiberglass-type tiles cannot
support the weight of the speakers. In such a case, the speakers will require additional support.
Each Speaker Mounting Kit includes: SKIC
Eight support ring screws, washers
and nuts
Two ceiling support rings (C-ring)
Four tile rails
Installing the Speaker Mounting Kit
The is installed after cutting the opening in the ceiling tile for the speakers. SKIC
To install the SKIC, as illustrated in the example in Figure 1, do the following:
1. Place the C-ring over the hole cut in the ceiling tile (on the “ceiling” side). Place it around
the hole so that the tabs located in parallel to the tile edges. are
Figure 1: Installing the Back Can Speakers
2. Place the tile rails the tile and snap them into the two tabs on the C-ring. on
Align the rails so that the ends extend over the T-channel grid.
3. Insert 2 screws through each tab on the C-ring to secure the rails.
4. Push the speaker into the ceiling hole until the front baffle rim is leveled with the ceiling.
5. Tighten the mounting tabs (see Figure 2).
When tightening the mounting tabs, the tabs automatically turn outward, thus clamping
the speaker to the wall from its rear side.
Note: Do not over-tighten the mounting tabs. It may cause damage to both the speakers
and the surface.
Figure 2: Tightening the Mounting Tabs
Specifications
DIMENSIONS:
Tile rails: 64.1cm x 2.2cm x 3cm ( .2 0.2. 25 ” x 0.87” x 97”) W, D, H
21.6cm x 8cm (8.5” x 3.15”)
Model
Outer Diameter
Inner Diameter
SKIC 4
18.5 ( ) cm 7.28”
14.2 cm (5.6”)
SKIC 6
24. 9.532 (cm ”)
20cm (7.9”)
SKIC 8
28.6cm (11.3”)
24.4cm (9.6 ) ”
DISTANCE
BETWEEN FIXING
POINTS:
SKIC 4: 19.1cm (7. ) approx. 5”
SKIC 6: 25.1cm (9. ) approx. 9”
SKIC 8: 29.5cm ( . ) approx.11 6”
WEIGHT OF
MOUNTING KIT
(FOR PAIR):
SKIC 4: 1.03kg (2.27lbs) approx.
SKIC 6: 1.08kg (2. lbs) approx. 38
SKIC 8: 1.14kg (2. lbs) approx. 51
SHIPPING WEIGHT
(FOR PAIR):
SKIC 4: 1.18kg (2.6lbs) approx.
SKIC 6: 1.27kg (2.8lbs) approx.
SKIC 8: 1.36kg (3lbs) approx.

Produkt Specifikationer

Mærke: Kramer
Kategori: højttalerstøtte
Model: SKIC-8

Har du brug for hjælp?

Hvis du har brug for hjælp til Kramer SKIC-8 stil et spørgsmål nedenfor, og andre brugere vil svare dig


højttalerstøtte Kramer Manualer

Kramer

Kramer SKIC-8 Manual

21 August 2024
Kramer

Kramer SKIC-4 Manual

21 August 2024
Kramer

Kramer SKIC-6 Manual

17 August 2024

højttalerstøtte Manualer

Nyeste højttalerstøtte Manualer

Nedis

Nedis SPMT5750BK Manual

3 Oktober 2024
Vogel's

Vogel's Sound 4203 Manual

27 September 2024
Vogel's

Vogel's Sound 4201 Manual

13 September 2024
Extron

Extron SMK VRE 48 Manual

6 September 2024
Sanus

Sanus BSWM3IWP Manual

6 September 2024
Sanus

Sanus WSWM3IWP Manual

6 September 2024
Valcom

Valcom V-9915M Manual

6 September 2024
Valcom

Valcom V-9912M Manual

6 September 2024
Valcom

Valcom V-9910 Manual

6 September 2024
Valcom

Valcom V-9904M-5 Manual

6 September 2024