Kunft KCHPS2339N Manual


Læs nedenfor 📖 manual på dansk for Kunft KCHPS2339N (14 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 9 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/14
instructions manual
manual de instrucciones
manual de instruções
chimney cooker
hood
KCHPS2339N
4
1. SAFETY INSTRUCTIONS
WARNING
Risk of Electric Shock
Do Not Open
Warning: to avoid the risk of electric
shock, do not remove the cover.
The interior does not contain any parts
that can be repaired by the user.
Ask for assistance from the Customer
Support Service.
Important Warnings
Before using your appliance read these ins-
tructions manual carefully and keep it in a
safe place as you may need to consult it in
the future.
Before turning on your appliance, and to
ensure a safe and correct operation, do not
use if:
- It has fallen to the ground;
- You notice any evidence of damage;
- Any anomaly occurs during its operation.
To avoid hazards or deterioration of your ap-
pliance through incorrect use it is advisable
to read these instructions thoroughly.
Your appliance may not be used for other
purposes than the ones intended and sole-
ly for household use. Any damage resulting
from using the appliance outside this scope,
chimney c
10
2.1.2. Model with Glass
1) The cooker hood should be placed at a distance of 65-75 cm (26-
30 inch) from the cooking surface for the best effect (See Pic 1).
2) Install the hook on a suitable place once the installation height is
xed and levelled. The xed position of the inside chimney bracket
is the place for the chimney (See Pic 2).
3) Fix the extensible pipe according to the lead direction and then put
the cooker hood on the hook (See Pic 3).
4) Put the glass according to the lead direction on the cooker hood
and then use the screws to x the glass. Also, lead the extensible
pipe outside the room. Meanwhile, adjust the height of the inside
chimney to the position of the inside chimney bracket and x it
with a screw. Ensure that the inside chimney can be exed freely
(See Pic 4).
5) Put the two chimneys together onto the cooker hood body.
Meanwhile, adjust the height of the inside chimney into the suitable
height and x the inside chimney to the inside chimney bracket
with a screw. Finally, x the body with the safety screw (See Pic 5).
Note: The two safety vents are
positioned on the back casing,
with a diameter of 6 mm.
Pic 4 Pic 5
Safety
screw
Pic 1
chimney c
Inside chimnery bracket
Pic 2 Pic 3
Hook
Extensible tube
20
rriente. Deje siempre que el aparato se en-
fríe antes de efectuar cualquier operación
de limpieza.
Para limpiar el exterior del producto, utilice
únicamente un paño suave y seco.
1.5. Precauciones generales
Siga las instrucciones de este manual,
que le ayudarán a instalar y poner correc-
tamente en funcionamiento este producto
y disfrutar de sus características avanza-
das. Guarde las instrucciones para refe-
rencia futura.
Lea todas las instrucciones antes de usar
el aparato.
Las operaciones de reparación o manteni-
miento deben ser realizadas únicamente
por profesionales autorizados.
Cualquier daño provocado por modica-
ciones manuales al producto no estará cu-
bierto por la garantía.
Si usa el producto para otros nes que no
sean para los que ha sido originalmente
diseñado, o si no está correctamente co-
nectado, el producto podrá sufrir daños y
la garantía quedará anulada.
campana e
22
2.1.1. Modelo sin vidrio
1) La campana extractora debe colocarse a una distancia de 65-75
cm (26-30 pulgadas) de la supercie de cocción para lograr un
mejor funcionamiento (véase la Imagen 1).
2) Tras denir la altura de instalación, instale el gancho en un lugar
adecuado; manténgala nivelada. La posición ja del soporte
interior de la chimenea es el lugar para la chimenea (véase la
Imagen 2).
3) Ajuste el soporte exterior de la chimenea y asegúrese de que la
altura de la chimenea interior se pueda ajustar libremente, así
como para ajustar el tubo extensible. Posteriormente, instale el
tubo extensible y la chimenea en la campana extractora (véase
la Imagen 3).
4) Coloque la campana extractora en el gancho (véase la Imagen 4).
5) Ajuste la altura de la chimenea
interior a la posición de su
soporte y fíjela con un tornillo.
Después de ajustar la posición,
je el cuerpo con un tornillo de
seguridad (véase la Imagen 5).
Nota: las dos aberturas de
seguridad están colocadas en
la carcasa trasera, con 6 mm de
diámetro.
1. Antes de iniciar la instalación, asegúrese de que el área esté limpia
para evitar la succión de los trozos restantes de madera y polvo.
2. El tubo de ventilación del aire no debe ser compartido con otros
aparatos tales como tubo de gas, tubos más calientes y tubos de
circulación de aire caliente.
3. La inclinación del tubo de ventilación debe ser de ≥120°, paralela
o por encima del punto de inicio, y debe conectarse a la pared
externa.
4. Después de la instalación, asegúrese de que el extractor está
nivelado para evitar que la grasa se acumule en uno de los
extremos.
Imagen 1
Correcto Incorrecto
campana e


Produkt Specifikationer

Mærke: Kunft
Kategori: Ikke kategoriseret
Model: KCHPS2339N

Har du brug for hjælp?

Hvis du har brug for hjælp til Kunft KCHPS2339N stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Kunft Manualer

Kunft

Kunft KHB3834 Manual

4 September 2024
Kunft

Kunft KHB3146 Manual

4 September 2024
Kunft

Kunft KBS7516 Manual

3 September 2024
Kunft

Kunft KMS-2661 Manual

3 September 2024
Kunft

Kunft KDVR3204 Manual

28 August 2024
Kunft

Kunft KTB5023 Manual

13 August 2024
Kunft

Kunft XJ10402 Manual

13 August 2024
Kunft

Kunft PAD625 Manual

12 August 2024
Kunft

Kunft KSC3040BK Manual

12 August 2024
Kunft

Kunft KCHPS2339N Manual

11 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer