LogiLink AVM365 Manual

LogiLink Overvågningskamera AVM365

Læs nedenfor 📖 manual på dansk for LogiLink AVM365 (4 sider) i kategorien Overvågningskamera. Denne guide var nyttig for 18 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/4
1. Paste the installation sticker
supplied with this camera to
where to install the camera,
and position the four holes for
screws.
Drill the two screws at top to
the wall. ( and as shown
in the picture )
454Z
m565_365a_V1.0
2Prerequisite
Prerequisite (continued)
Before configuring network setup with iPhone / iPad, make
sure you have checked the followings:
(Recommended) Apply your own ADSL or cable
Internet service to simplify the network configurations.
Your camera is connected to your wireless router with
a RJ45 network cable, and it’s powered on.
You have installed our mobile program,
EagleEyes-Lite EagleEyes-Plus or , on your iPhone or
iPad.
iPhone / iPad
Network
Cable
(RJ45)
Wireless
Router
Modem
Camera
LAN Port WAN Port
Event Trigger
System Install the Camera
1
2. 161
Step4: Select “Apply” to confirm all your changes, and you see the message “Done” or “Fail” in “Status”.WAIT till
Done
Fail
Step6: Open your web browser on iPhone, and enter the IP address of your wireless router (“ ” in 192.168.2.161
our example) to access.
Step3: Select the IP address to enter the setting page, and switch the tab from “DHCP” to “Static”.
Then, note down the IP address and port number you see here. You’ll need them in Step 7.
Step5: In the new device page, give a meaningful name for this connection in “Title”, and select “Save”.
3Configure with iPhone / iPad
Step1: Connect your iPhone / iPad to the wireless router
which has the camera connected.
iPhone / iPad
Network
Cable
(RJ45)
Wireless
Router
Modem
Camera
LAN Port WAN Port
Step2: Open “EagleEyes-Lite” (or “EagleEyes-Plus”),
and click “+” to enter the new device page.
Then, select “Local Network Search” to search
your network camera.
The IP address shown is the address assigned to
your camera by your router.
1
B
A
A
B
You have checked the IP address used by your wireless
router as instructed below, and written them down.
You will need them later.
Connect your iPhone / iPad to the wireless router
with the camera connected, and go to “Settings”
“Wi-Fi”. Select “>” near the selected wireless network
to enter the details.
(Optional) Your wireless router supports UPnP, and
this function is enabled.
2
1
Note: Please leave some space between the
screws and wall. Do not get them to the end.
2. Hang the camera at the
screws you just fixed, and
make sure the camera
stays in place. Decide the
cable direction (up
/ down) before you fasten
the screws tight to the wall.
A
B
2
A
B
3. Drill the rest of screws ( and as shown in the
picture ) into the wall. After that, make sure all
screws are fastened.
3
C
D
C
D
3
4
4. Adjust the angle of the camera (up / down / left /
right) with the supplied wrenches for better viewing.
a.b.

Produkt Specifikationer

Mærke: LogiLink
Kategori: Overvågningskamera
Model: AVM365

Har du brug for hjælp?

Hvis du har brug for hjælp til LogiLink AVM365 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Overvågningskamera LogiLink Manualer

LogiLink

LogiLink AVM265 Manual

19 August 2024
LogiLink

LogiLink AVN807 Manual

19 August 2024
LogiLink

LogiLink AVM365 Manual

16 August 2024

Overvågningskamera Manualer

Nyeste Overvågningskamera Manualer

Sony

Sony SNC-DH160 Manual

16 November 2024
Bresser

Bresser DL-30MP Manual

15 November 2024
D-Link

D-Link DCS-6500LHV2 Manual

14 November 2024
D-Link

D-Link DCS-2803KT Manual

13 November 2024
D-Link

D-Link DCS-2804KT Manual

13 November 2024
D-Link

D-Link DCS-931L Manual

13 November 2024
D-Link

D-Link DCS-6100LHV2 Manual

13 November 2024
Philips

Philips Series 3000 HSP3800 Manual

13 November 2024
Emos

Emos H4060 Manual

13 November 2024
Philips

Philips Series 3000 HSP3500 Manual

13 November 2024