Midland LXT630VP3 Manual

Midland Radio LXT630VP3

Læs nedenfor 📖 manual på dansk for Midland LXT630VP3 (2 sider) i kategorien Radio. Denne guide var nyttig for 31 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

Welcome to the world of Midland electronics

Congratulations on your purchase of a high quality MIDLAND

product. Your 2-way radio represents state-of-the-art high-tech

engineering and is designed for FRS (Family Radio Service)

operation. It is a quality piece of electronic equipment, skillfully

constructed with the finest components. The circuitry is all solid-state

and mounted on a rugged printed circuit board. Your two-way radio is

designed for reliable and trouble-free performance for years to come.

Features

- 36 FRS Channels

- 121 Privacy Codes (38 CTCSS / 83 DCS)

- VOX

- Selectable Call Alert

- NOAA Weather Scan

- NOAA Weather Radio

- NOAA Weather Alert

- Scan Function

- Monitor Function

- Roger Beep Tone

- Silent Operation

- Key Pad Lock

- Power High / Low Settings

- Speaker / Microphone Jacks

- Battery Meter / Battery Low Indicator

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) this device does not cause

harmful interference, and (2) this radio must accept any interference

that may cause undesired operation.

To maintain compliance with FCC’s RF exposure guidelines, for

body-worn operation, this radio has been tested and meets the FCC RF

exposure guidelines when used with Midland Radio Corp. accessories

supplied or designated for this product. Use of other accessories may

not ensure compliance with FCC RF exposure guidelines.

IMPORTANT: Changes or modifications to this unit not expressly

approved by MIDLAND RADIO CORP. could void your right to operate

this unit. Your radio is set up to transmit a regulated signal on an

assigned frequency. It is against the law to alter or adjust the settings

inside the COMMUNICATOR to exceed those limitations. Any adjustment

to your radio must be made by qualified technicians.

LCD DISPLAY

1. KEY LOCK ICON – Indicates KEY

LOCK mode is on.

2. VOX ICON – Indicates when VOX mode

is active.

3. NOAA WEATHER (WX) BAND ICON–

Indicates when the radio is in Weather

Band mode.

4. CHANNEL NUMBER – Changes from

1~36 on FRS band (1~10 on WX band).

5. PRIVACY CODE – Indicates Privacy

Code selected by user (oF~38/oF~83). It

can only be set in Ch 1~22.

6. BATTERY METER – Indicates the battery

level.

7. RECEIVE (RX) ICON – Indicates radio is

receiving a transmission.

8. TRANSMIT (TX) ICON – Indicates radio

is transmitting a signal.

9. TRANSMIT POWER LEVEL ICON –

Indicates TX Power setting (H/L).

10. PRIVACY CODE ICON – Indicates

Privacy Code setting (CTCSS/DCS).

CONTROLS

11. POWER/VOLUME KNOB – Turn clock-

wise to turn the power on and increase

the volume level. Turn counter-clockwise

to decrease the volume level and turn

the power off.

12. PTT Button – Press and hold to

transmit voice communication.

13. CALL/LOCK Button – Press to send a

CALL ALERT signal. Press and hold to

turn KEY LOCK on/off.

14. MIC – Built-in microphone.

15. SPEAKER – Built-in speaker.

16. ANTENNA

17. EXTERNAL SPEAKER/MIC/CHG

JACK

18. MENU Button – Press momentarily to

access Menu mode.

19. MONITOR/SCAN Button – Press to

enter SCAN mode. Press and hold to

enter MONITOR mode.

20. UP/WX SCAN s

ss and DOWN t

Buttons – Make adjustments in MENU

mode. Press and hold the UP button for

5 seconds to activate the NOAA

Weather Scan function.

BATTERY INSTALLATION

Your radio operates with either a NiMH battery pack or optional 3 AAA

alkaline batteries. The belt clip should be removed (see below) to

ease installation or removal of the batteries.

To install the batteries:

1. With the back of the radio facing you, remove the belt clip (see

diagram below) for easy access, then remove the Battery Cover by

pressing down on the top center and sliding it down from the radio.

2. Insert 3 AAA batteries observing the polarity as shown. Installing

the batteries incorrectly will prevent the unit from operating or may

damage the unit.

3. Return the Battery Cover by sliding it up on the radio. Replace the

belt clip, making sure it locks into place.

BATTERY

COMPARTMENT

BATTERY

COMPARTMENT

COVER

Press here and

push down to open

BELT CLIP

LOCK TAB

BELT CLIP

LATCH

INSTALLING THE BELT CLIP

To install the BELT CLIP, slide the clip down into the slot on the back

of the radio until the BELT CLIP LATCH clicks. To remove the BELT

CLIP LOCK TAB, press the down, then gently pull the belt clip up

toward the top of the radio.

MIDLAND RADIO CORPORATION

MIDLAND RADIO CORPORATIONMIDLAND RADIO CORPORATION

5900 Parretta Drive

Kansas City, MO 64120

Call 816.241.8500

We’d love to hear from you! Let us know what you

think of your new Midland product at

or by visiting us at

midlandusa.com

Note: Features & Specifications are subject to change without

notice. MIDLAND is not responsible for unintentional errors or

omissions on its packaging.

Your radio is equipped for using a rechargeable NiMH battery pack

which can be recharged by inserting the AC adapter into the

desktop charger (as described below). Initial charge time is 24

hours. Charge time is about 12 hours thereafter. For maximum

battery life, we recommend charging the battery pack when the low

battery icon comes on. Remove the radios from the charger when the

charge time expires.

To charge using a Desktop Charger:

1. Place the rechargeable battery packs in the radios.

2. Connect the AC adapter into an AC wall outlet.

3. Insert the AC adapter plug (or DC Cigarette Lighter adapter if

charging in vehicle) into the desktop charger jack.

4. Place the units into the desktop charger slot and note that the LED

indicator with color will light up, indicating charging function.RED

In order to ensure that the battery pack is fully charged, it is

recommended that the battery pack be charged for at least 12

hours with the radio turned OFF.

1. Only use the Midland NiMH battery pack and AC adapter.

2. Do not attempt to charge alkaline batteries or any batteries

or battery packs other than the one indicated in the

manual. This may cause leakage and damage to the radio.

3. For long term storage of the radio, turn the radio OFF and

remove the batteries from the radio.

BATTERY LEVEL INDICATOR

Your radio has a BATTERY LEVEL METER

that shows the

battery power level. The greater the number of bars visible, the

stronger the battery level. When the battery level is low, the Battery

Shell icon will flash in the display indicating your batteries

should be replaced or recharged if using a rechargeable battery pack.

CHARGING THE BATTERY PACK

POWER ON/OFF AND VOLUME

Rotate the knob clockwise to turn the radio onPOWER/VOLUME

and increase the volume level. Rotate the control counter-clockwise

to reduce the volume level and to turn the radio off. During Power On,

the radio will beep 2 times with different tones, the LCD will display

all icons for 1 second and the LCD display will indicate the last

channel selected.

TRANSMITTING AND RECEIVING A CALL

To communicate, all radios in your group must be set to the same

channel and/or Privacy Code.

1. For maximum clarity, hold the radio 2 to 3 inches from your

mouth.

2. Press and hold the button and speak in a normal voicePTT

into the icon will appear continuouslymicrophone. The TX

on the LCD display while transmitting.

3. To receive a call, release the icon willPTT button. The RX

appear on the display when your radio is receiving a transmision.

ABOUT RANGE

Your LXT Series radios are designed to give you maximum range

under optimum conditions.

Optimum Conditions are:

lOver water

lOpen rural areas without obstructions

lFlat areas where you can see the other person

To ensure you get maximum range:

lBe sure to use fresh or fully charged batteries - low batteries will

cause low power conditions.

lBe sure to set your radio to use Hi power.

OPERATING YOUR RADIO LXT600/630/650 SERIES QUICK REFERENCE CHART

MONITOR

Pressing and holding the button for 3 seconds will let youMONITOR

hear noise so you can adjust the volume level of the radio when not

receiving a signal. This could also be used to check any activity on

your current channel before transmitting.

Press and hold the button for 3 seconds again to get outMONITOR

of mode.MONITOR

SCAN

Your radio can scan all 36 channels for activity. To enter, quickly

press the button. Repeat the same procedure to exit. YourSCAN

radio will rapidly scan each of the 36 channels and stop on any active

channel for 4 seconds before resuming scan.

When you press the button to transmit on an active channel, thePTT

scanning function will stop and remain on the active channel. To

resume scanning, quickly press the SCAN button.

CALL ALERT

Your radio can transmit a call alert for a fixed length of time. To send

a call alert, press the icon will appear whileCALL button. The TX

transmitting a call alert and a tone can be heard on the speaker for

confirmation.

KEYPAD LOCK

To avoid accidentally changing the radio setting, press the LOCK

button for 4 seconds. The KEY LOCK icon will appear on the display.

PTT CALLand will still be active. Repeat the same procedure to

unlock the keypad.

CHANNEL SELECTION (FRS BAND)

Press the button once, and then the MENU s

ss t

tt\buttons to select

one of the 36 FRS channels. To confirm the selection, press the PTT

button or press the button again to move to the next featureMENU

setting

MENU Channel VOX

1~36

Privacy

Roger Beep

On/Off

Power

H/L

Call Alert

1~5

WX Channel

1~10

Silent Operat ion

On/Off

oF/1/2/3

CTCSS

DCS

oF~38

oF~83

WX Alert

On/Off

WX Scan

1~10

Press and hold UP/WX

button for 5 seconds

SETTING PRIVACY CODES

Your radio has 121 available to use in channelsPrivacy Codes

1~22. The selected Privacy Code may be different for each channel.

To select a Privacy Code for the current channel press the MENU

button twice, and then the s

ss t

tt\buttons to select one of the 38

CTCSS Privacy Codes. Press the MENU button again and then the

ss\t

t t buttons to select one of the 83 Privacy Codes. TheDCS

Privacy Code icon on the display will indicate whether you set your

Privacy Code in mode. To confirm the selection,CTCSS DCSor

press the button or press the button again to move to thePTT MENU

next feature setting.

Note : If you select a CTCSS Privacy Code, any pre-selected

DCS Privacy Code will be cancelled and vice-versa.

Selecting a Privacy Code of will disable the Privacy feature." "oF

To communicate between two radios, all radios in your group

must be set to the same channel and/or Privacy Code selections.

The Privacy Code can only be set in channels 1~22.

TRANSMIT (TX) POWER LEVEL SELECTION

Your radio has 2 power level settings. To select the power level on

channels 1~7 and 15~36, press the button until a “ ” icon willMENU Pr

appear blinking on the display. Then press the s

ss t

tt\buttons to select

TRANSMIT POWER LEVEL icon (H: /L: Hi Lo). To confirm, press the

PTT MENUbutton or press the button again to move to the next

feature setting. When the PTT button is pressed during Lo

Battery Level condition, the TX Power will automatically switch

from Hi(H) to Lo(L) level.

Note : You cannot adjust the power setting on channels

8~14. They are set to Lo power per FCC regulations.

VOX

Your radio has 3 VOX level settings: (oF/1/2/3).

To set VOX, press the button until the display shows “MENU VOX”

blinking while on the right of the display, anCHANNEL NUMBER

“ ”,“oF” icon appears. Select “1 2” or “3” by pressing the s

ss t

tt\buttons

and push the key, or press the button again to move toPTT MENU

the next feature setting.

Rev F

IMPORTANT NOTICE

Exposure To Radio Frequency Energy

Your Midland radio is designed to comply with the following national and

international standards and guidelines regarding exposure of human

beings to radio frequency electromagnetic energy:

- United States Federal Communications Commission, Code of Federal

Regulations: 47 CFR part 2 sub-part J

- American National Standards Institute (ANSI)/Institute of Electrical &

Electronic Engineers (IEEE) C95. 1-1992

- Institute of Electrical and Electronic Engineers (IEEE) C95. 1-1999

Edition

- National Council on Radiation Protection and Measurements (NCRP) of

the United States, Report 86, 1986

- International Commission on Non-lonizing Radiation Protection

(ICNIRP) 1998

To control your exposure and ensure compliance with the general

population or uncontrolled environment exposure limits, transmit no more

than 50% of the time. The radio generates measurable RF energy

exposure only when transmitting.

Body-Worn Operation

If you wear the radio on your body when transmitting always use Midland-

supplied or approved belt clip, holster, case, or body harness for this

product. Use of any accessories not supplied or approved by Midland may

exceed FCC/Health Canada RF exposure guidelines. If you do not use

any accessories supplied or approved by Midland, ensure the radio and

its antenna are at least 1 inch (2.5cm) from your body when

ransmitting.

Produkt Specifikationer

Mærke:	Midland
Kategori:	Radio
Model:	LXT630VP3
Bredde:	55.6 mm
Dybde:	154.7 mm
Højde:	32.2 mm
Brugervejledning:	Ja
Produktfarve:	Black, Yellow
Batteriteknologi:	Alkaline
Antal:	2
Batterier inkluderet:	Ingen
Batteritype:	AAA
Antal understøttede batterier:	3
Formål:	Multi-Use Radio Service (MURS)
Oplader:	Ja
Driftsfrekvens:	- MHz
Foreslået køn:	Unisex
Maks. rækkevidde:	48000 m
Genopladelig:	Ja
Bælteclip:	Ja
Anbefalet alder:	Voksen
Garantiperiode:	3 År
Antal kanaler (i alt):	36 kanaler