Mikrotik LHG LTE kit Manual
Mikrotik
TV signal booster
LHG LTE kit
Læs nedenfor 📖 manual på dansk for Mikrotik LHG LTE kit (4 sider) i kategorien TV signal booster. Denne guide var nyttig for 4 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/4
LHG LTE kit
Assembly
Attach the two legs to the LHG case by sliding them onto the respective sides (when looking at the logo, leg
marked R is for the right side, leg marked L is for the left side). Snap the assembled LHG unit to the grid in the
appropriate central location. Fix the two legs in place with two self thread screws (included, use Phillips screw
driver PH2). The package also contains a grounding cable connector and a 5 degree angle adapter, for easier up or
downward tilt adjustment.
Quick start
1. While holding the unit by it’s central column, apply force to the tab, which holds the latch closed,
until the latch pops open.
2. Connect an ethernet cable to the ethernet port, connect the other end of the ethernet cable
to the included PoE injector.
3. Plug the PoE injector into your network switch or ISP internet outlet.
4. Plug the included power supply into the PoE injector to start up the device.
Powering
The device can be powered from 12-57 V 802.3af/at sources and also Passive PoE injectors (one power supply
and PoE injector are included).
Mounting
Slide the included metallic mounting rings into the two slots on the back of the antenna dish. Attach the unit to a
pole, with the Ethernet cable pointing downward. Use a PH2 screwdriver to tighten the rings. Fix the Ethernet cable
to the pole less than one meter from the unit, to avoid the cable being pulled out of the port. Optional: if required,
before mounting the unit, you can insert the included 5 degree adjustment adapter into the top or bottom slot where
the mounting ring is inserted. This will create an additional upward or downward angle, when the unit is tightened to
a vertical pole. Warning! This equipment should be installed and operated with minimum distance of 120 cm
between the radiator and your body,
Expansion slots and ports
One 10/100 ethernet port, supporting automatic cross/straight cable correction (Auto MDI/X). Either straight
or crossover cable can be used for connecting to other network devices. The ethernet port accepts 9-30 V
DC powering from a passive PoE injector.
miniPCIe slot and SIM slot (can’t be used separately) to be used with a 3G/4G/LTE modem (the LTE kit
includes the modem already inside the device).
Buttons and jumpers
RouterBOOT reset button has the following functions. Press the button and apply the power, then:
Release the button when green LED starts flashing, to reset RouterOS configuration to defaults.
Release the button when the LED turns solid green to clear all configuration and defaults.
Release the button after LED is no longer lit (~20 seconds) to cause device to look for Netinstall servers
(required for reinstalling RouterOS over network).
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed
before power is applied to the device. Useful for RouterBOOT debugging and recovery.
The device includes a grounding connection behind the ethernet port door, which you should connect to the
grounding installation of the tower or building where the device will be used. This is to substantially reduce risk of
ESD and lightning damage.
See mikrotik.com for more information. Document #41960 Modified on: 07/03/18
Produkt Specifikationer
| Mærke: | Mikrotik |
| Kategori: | TV signal booster |
| Model: | LHG LTE kit |
Har du brug for hjælp?
Hvis du har brug for hjælp til Mikrotik LHG LTE kit stil et spørgsmål nedenfor, og andre brugere vil svare dig
TV signal booster Mikrotik Manualer
31 Juli 2024
TV signal booster Manualer
- TV signal booster One For All
- TV signal booster Hama
- TV signal booster König
- TV signal booster Meliconi
- TV signal booster Triax
- TV signal booster Goobay
- TV signal booster Astro
- TV signal booster Kathrein
- TV signal booster Evolveo
- TV signal booster Wilson
- TV signal booster Hirschmann
- TV signal booster Wentronic
- TV signal booster Televés
- TV signal booster Winegard
- TV signal booster Antennas Direct
- TV signal booster Epcom
- TV signal booster SureCall
- TV signal booster SmoothTalker
- TV signal booster Wilson Electronics
- TV signal booster ZBoost
- TV signal booster Axing
Nyeste TV signal booster Manualer
7 Oktober 2024
7 Oktober 2024
2 September 2024
1 September 2024
1 September 2024
1 September 2024
31 August 2024
31 August 2024
31 August 2024
31 August 2024