Minelab GPX 4500 Manual

Minelab Detektor GPX 4500

Læs nedenfor 📖 manual på dansk for Minelab GPX 4500 (55 sider) i kategorien Detektor. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/55
Instruction Manual
Quick Start
Set the front panel switches to the following positions:
Threshold
Auto Tune
Ground
Balance
Tracking
Fixed
Threshold
On Off/
Hold for FP
Push and release the On/Off switch on the rear
control panel (pg. 25).
Turn the Threshold (pg. 34) control clockwise until a hum
is audible through the headphones.
Raise the coil off the ground and Press the Auto Tune
(pg. 33) button to reduce electrical interference. The
tuning process takes approximately 60 seconds. Do not
move the coil or pass metal objects near the coil during
the tuning process.
Whilst lowering and raising the coil between 25mm and
100mm (1" and 4") from the ground, change the Ground
Balance switch to Tracking (pg. 40). Any variations in the
Threshold will smooth out within 3–5 seconds.
Adjust the Threshold (pg. 34) to a very faint but still
audible level. It should be smooth with only minor
fluctuations.
You are now ready to start searching!
Search
Mode Soil /
Timings Ground
Balance Coil /
Rx
CancelTrackingSpecialDeep
Custom Enhance Fixed Double D
MNG


Produkt Specifikationer

Mærke: Minelab
Kategori: Detektor
Model: GPX 4500

Har du brug for hjælp?

Hvis du har brug for hjælp til Minelab GPX 4500 stil et spørgsmål nedenfor, og andre brugere vil svare dig