Mini-Box picoPSU-90 Manual

Mini-Box Computer strømforsyning picoPSU-90

Læs gratis den danske manual til Mini-Box picoPSU-90 (4 sider) i kategorien Computer strømforsyning. Denne vejledning er vurderet som hjælpsom af 8 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 4.5 anmeldelser. Har du et spørgsmål om Mini-Box picoPSU-90, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

picoPSU-90

12V, 90Watt ATX Power Supply

Quick Installation Guide

Version 1.0d

P/N picoPSU-90

Introduction

Based on the electrical design of the picoPSU-120, the picoPSU-90 is a small yet

powerful and fully compliant ATX power supply designed to power a wide variety

of motherboard from a single 12V regulated power source.

The PICOPSU-90 is the only snap power supply solution for general purpose

motherboards. Compatible with an entire range of mini-ITX, UATX or full size

ATX motherboards the picoPSU-90 provides cool, silent power for system. The

PICOPSU-90 has many advantages over a regular power supply:

-Smallest ATX PSU to date

-100% silent operation

-Low heat dissipation with efficiency over 95%

-Plugs directly into the motherboard’s power connector, no cable mess

Quick installation Instructions

The PICOPSU-90 has been specifically designed for the Mini-ITX form factor,

thus eliminating the need for ATX power cables. It is also 1U compliant – height

will not exceed 1U form factor.

1) After the picoPSU module was ‘snapped in’, hook the hard drive power or

floppy power to your floppy/hard drives. If more hard drives or floppy connectors

are needed, use a HDD/floppy “Y” splitter cable.

Mini-Box.com ATX DC-DC Converter Series

picoPSU-90 Quick Installation Guide Page 2

PicoPSu-90 shown with the D201GLY Intel Motherboard.

2) Connect a 12 VDC power adapter (or any 12V source) to the DC-to-DC

connector, center pin / white wire is positive (+).

3) Turn on the PC using the motherboard ON/OFF motherboard switch

Typical configuration

The picoPSU-90 has been tested with all mini-ITX board (VIA C3, VIA C7, low

power AMD and Atom) under virtually any disk / floppy / CDROM / PCI

configuration. Additionally, the PICOPSU-90 can power low boards equipped

with an 12VATX 4 pin connector. NOTE: The hard drive cable harness can be

disconnected in case the user does not need any peripheral. Additionally, the

cable harness can be made to any length or output connector type provided that

the max load does not exceed 3A for GND return. Please look under

specifications for the mating connector type.

Removing the picoPSU-90

In order to remove the picoPSU you must release the power connector latch and

then remove the unit. Gently lift the picoPSU out from the ATX connector, by

grabbing from the picoPSU PCB, not from components or the wire harness.

Produkt Specifikationer

Mærke:	Mini-Box
Kategori:	Computer strømforsyning
Model:	picoPSU-90

Har du brug for hjælp?

Hvis du har brug for hjælp til Mini-Box picoPSU-90 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Computer strømforsyning Mini-Box Manualer

Mini-Box picoPSU-120-WI-25 Manual

31 August 2024

Mini-Box picoPSU-80-WI-32 Manual

31 August 2024

Mini-Box picoPSU-80 Manual

31 August 2024

Mini-Box picoPSU-90 Manual

31 August 2024

Mini-Box picoPSU-160-XT Manual

31 August 2024

Mini-Box picoPSU-150-XT Manual

31 August 2024

Mini-Box picoPSU-120 Manual

31 August 2024

Computer strømforsyning Manualer

Nyeste Computer strømforsyning Manualer

FSP FlexGURU Manual

5 Januar 2025

ADATA PROBE Bronze Manual

1 Januar 2025

Be Quiet! Pure Power 12 Manual

1 Januar 2025

StarTech.com ATXPW350DELL Manual

1 Januar 2025

StarTech.com ATX2POWER450 Manual

1 Januar 2025

StarTech.com ATXPOWER250 Manual

1 Januar 2025

StarTech.com ATX2POWER350 Manual

1 Januar 2025

StarTech.com ATX2POW400HS Manual

1 Januar 2025

StarTech.com ATX2PW530PRO Manual

1 Januar 2025

StarTech.com PS2POWER230 Manual

1 Januar 2025