Nemco 80650 Manual


Læs nedenfor 📖 manual på dansk for Nemco 80650 (1 sider) i kategorien Hotdog maker. Denne guide var nyttig for 7 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
TONG HOLDER ASSEMBLY
Model: 80650 & 80650-1
INSTALLATION INSTRUCTIONS
INTRODUCTION
1. Please read the instructions completely before beginning installation.
2. Clean Roller Grill thoroughly before installation.
INSTALLATION
1. Be sure that the location where the Tong Holder Assembly will be installed is completely clean and free of
debris. This will ensure that the adhesive will adhere to the end frame.
2. Remove Tong Holder Back from the assembly by sliding the body up and over the mounting posts.
3. Remove the paper backing from the adhesive strip on the back side of the Tong Holder Back.
4. Attach the Tong Holder Back to the desired location on either end frame. Note that the Tong Holder
Assembly may need to be mounted in a lower position than shown below if a Guard or Divider Kit are being
used.
5. Install Tong Holder Body to Tong Holder Back by sliding it over the mounting posts located on the Tong
Holder Back. Be sure that the Body is completely seated on the mounting posts.
NEMCO FOOD EQUIPMENT 301 Meuse Argonne, Hicksville, OH 43526
Phone: (419) 542-7751 Fax: (419) 542-6690 Toll free: 1-800-782-6761
www.nemcofoodequip.com 1-17-2013


Produkt Specifikationer

Mærke: Nemco
Kategori: Hotdog maker
Model: 80650

Har du brug for hjælp?

Hvis du har brug for hjælp til Nemco 80650 stil et spørgsmål nedenfor, og andre brugere vil svare dig