Onkyo SKS-HT528 Manual

Onkyo Højttaler SKS-HT528

Læs nedenfor 📖 manual på dansk for Onkyo SKS-HT528 (1 sider) i kategorien Højttaler. Denne guide var nyttig for 41 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/1

5.1ch Home Theater Speaker Package SKS-HT528

Y1203-3

SN 29400527B

2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPAN

Tel: 072-831-8023 Fax: 072-831-8163

http://www.onkyo.com/

18 Park Way, Upper Saddle River, N.J. 07458, U.S.A.

Tel: 800-229-1687, 201-785-2600 Fax: 201-785-2650

http://www.us.onkyo.com/

Liegnitzerstrasse 6, 82194 Groebenzell, GERMANY

Tel: +49-8142-4401-0 Fax: +49-8142-4208-213

http://www.eu.onkyo.com/

The Coach House 81A High Street, Marlow, Buckinghamshire, SL7 1AB, UK

Tel: +44-(0)1628-473-350 Fax: +44-(0)1628-401-700

Unit 1033, 10/F, Star House, No 3, Salisbury Road, Tsim Sha Tsui Kowloon, Hong Kong.

Tel: 852-2429-3118 Fax: 852-2428-9039

http://www.onkyochina.com/

1301, 555 Tower, No.555 West NanJin Road, Jin an, Shanghai,

China 200041, Tel: 86-21-52131366 Fax: 86-21-52130396

http://www.cn.onkyo.com/

*29400527B*

*2 Non-magnetic shielding.

■Front

■Rear

Note

• The Auto Standby function turns the subwoofer on when the input signal exceeds a certain

level. If the Auto Standby function does not work reliably, try slightly increasing or

decreasing the subwoofer output level on your receiver.

• If the Standby/On indicator lights (both red and blue LEDs) several seconds or minutes

after the sound output stopped, this means that the amp protection circuit has been acti-

vated. In this case, set the OUTPUT LEVEL control to the center position, and disconnect

the power cord from the AC outlet. Wait at least 10 seconds, and then reconnect the power

cord. If that doesn’t solve the issue, contact your Onkyo dealer.

Setting the Subwoofer Level

To set the level of the subwoofer, use the OUTPUT LEVEL control.

Set it so that bass sounds are evenly balanced with the treble sounds

from the other speakers. Because our ears are less sensitive to very

low bass sounds, there’s a temptation to set the level of the sub-

woofer too high. As a rule of thumb, set the subwoofer level to what

you think is the optimal level, and then back it off slightly.

Using the Floor Pads for Subwoofer

If the subwoofer is placed on a hard floor

(wood, vinyl, tile, etc.) and playback is very

loud, the subwoofer’s feet may damage the

flooring. To prevent this, place the supplied

pads underneath the subwoofer’s feet. The pads

also provide a stable base for the subwoofer.

Powered subwoofer (SKW-501E)

Subwoofer*2

RCA cable 3.0 m 4 floor pads

STANDBY/ON indicator

Red: Subwoofer in standby mode

Blue: Subwoofer on

With the Auto Standby function, the SKW-501E

automatically turns on when an input signal is

detected in Standby mode. When there’s no

input signal for a while, the SKW-501E automat-

ically enters Standby mode.

POWER switch

Press this switch to the ON position to turn on

the power. Press it to the OFF position to turn off

the power.

OUTPUT LEVEL control

This control is used to adjust the volume of the

subwoofer.

LINE INPUT

This RCA input should be connected to the

subwoofer pre out on your AV receiver with

supplied RCA cable.

To AC outlet

Pad

Enjoying Home Theater

The Home Theater means that you can enjoy surround sound with a real sense of movement in your own home — just like being in

a movie theater or concert hall.

Connecting the Speakers

fcab ab Front left and right speakers (SKF-528)

They should be positioned facing the listener at about ear level, and equally

spaced from the TV. Angle them inward slightly so as to create a triangle, with

the listener at the apex.

cCenter speaker (SKC-528)

Position it close to your TV (preferably on top) facing forward at about ear

level, or at the same height as the front left and right speakers.

de Surround left and right speakers (SKR-528)

Position them at the sides of the listener, , about 60 to 100 cm or slightly behind

above ear level. Ideally they should be equally spaced from the listener.

fSubwoofer (SKW-501E)

The subwoofer handles the bass sounds of the LFE (Low-Frequency Effects)

channel. The volume and quality of the bass output from your subwoofer will

depend on its position, the shape of your listening room, and your listening

position. In general, a good bass sound can be obtained by installing the sub-

woofer in a front corner, or at one-third the way along the front wall, as shown.

Corner

position 1/3 of wall

position

Red White

Blue

Front right

speaker

Center speaker

Gray

Front left

speaker

Surround right

speaker

Surround left

speaker

Speaker Connection

Precautions

Read the following before connecting your

speakers:

• Turn off your receiver before making any

connections.

• Pay close attention to speaker

wiring polarity. Connect posi-

tive (+) terminals to only pos-

itive (+) terminals, and

negative (–) terminals to only negative (–)

terminals. If the speakers are wired incor-

rectly, the sound will be out of phase and

will sound unnatural.

• Be careful not to short the positive and

negative wires. Doing so may damage

your amp.

Caution

• With other audio-video components, connect

the subwoofer’s LINE INPUT to the subwoofer

pre out jack of your equipment. Never plug any

kind of musical instrument to the subwoofer.

Powered

subwoofer

*Using the supplied RCA cable,

connect the subwoofer’s LINE

INPUT to your AV receiver’s PRE

OUT SUBWOOFER jack.

Green

Specifications

■Powered Subwoofer (SKW-501E)

■Front Speakers (SKF-528)

■Center Speaker (SKC-528)

■Surround Speakers (SKR-528)

Specifications and appearance are subject to change without

prior notice.

Type Bass-reflex

Rated output Power (IEC) 80 watts minimum continuous power,

4 ohms, driven at 100 Hz with a

maximum total harmonic distortion of

1 %

Input sensitivity/impedance 410 mV / 20 kΩ

Frequency response 27 Hz to 150 Hz

Cabinet capacity 24.5 L (0.865 cubic feet)

Dimensions (W × H D)×230 mm × 425 mm × 412 mm

(9-1/16" × 16-3/4" × 16-1/4")

(incl. grille and projection)

Weight 9.1 kg (20.1 lbs)

Drivers unit 20 cm (8") Cone Woofer

Power supply AC 220 – 240V

50/60 Hz

Power consumption 105 W

Other Auto Standby function

Type Full Range Bass-reflex

Impedance 6 Ω

Maximum input power 120 W

Output sound pressure level 81 dB/W/m

Frequency response 80 Hz to 20 kHz

Cabinet capacity 1.1 L (0.039 cubic feet)

Dimensions (W × H D)×101 mm × 175 mm × 116 mm

(4" × 6-7/8" × 4-9/16")

(incl. grille and projection)

Weight 0.7 kg (1.5 lbs)

Drivers unit 8 cm (3-1/4") Cone

Terminal Spring type color coded

Keyhole slot 1

Grille Fixed

Other Magnetic shielding

Type Full Range Bass-reflex

Impedance 6 Ω

Maximum input power 120 W

Output sound pressure level 82 dB/W/m

Frequency response 80 Hz to 20 kHz

Cabinet capacity 1.8 L (0.064 cubic feet)

Dimensions (W × × × × H D) 273 mm 101 mm 106 mm

(10-3/4" × 4" × 4-3/16")

(incl. grille and projection)

Weight 1.0 kg (2.2 lbs)

Drivers unit 8 cm (3-1/4") Cone

Terminal Spring type color coded

Keyhole slot 2

Grille Fixed

Other Magnetic shielding

Type Full Range Bass-reflex

Impedance 6 Ω

Maximum input power 120 W

Output sound pressure level 81 dB/W/m

Frequency response 80 Hz to 20 kHz

Cabinet capacity 1.1 L (0.039 cubic feet)

Dimensions (W × × × × H D) 101 mm 175 mm 116 mm

(4" × 6-7/8" × 4-9/16")

(incl. grille and projection)

Weight 0.7 kg (1.5 lbs)

Drivers unit 8 cm (3-1/4") Cone

Terminal Spring type color coded

Keyhole slot 1

Grille Fixed

Wall Mounting

Using the Rubber Stoppers for a More Stable Platform

Front speaker (SKF-528) Surround speaker (SKR-528) Center speaker (SKC-528)

Front speakers*1 Speaker cables 3.5 m Surround speakers*2 Speaker cables 8.0 m Center speaker*1

Speaker cable 3.0 m

*1 For magnetic shielding.

*2 Non-magnetic shielding.

*3 Configuration of the rubber stoppers may be different from the figure, such

as being 2 sheets instead of 1 sheet, but the total number will be same. 16 thin rubber stoppers*3 12 thick rubber stoppers*3

Caution

• The front grilles are not designed to be removed so

do not attempt to remove them forcibly, as this will

damage them.

To mount the front/surround speakers vertically, use

the keyhole slot shown to hang each speaker on a

screw that’s securely screwed into the wall.

To mount the center speaker horizontally, use the two

keyhole slots shown to hang each speaker on two

screws that are securely screwed into the wall.

Caution

• A mounting screw’s ability to sup-

port a speaker depends on how

well it’s anchored to the wall. If

you have hollow walls, screw each

mounting screw into a stud. If

there are no studs, or the walls are

solid, use suitable wall anchors.

Use screws with a head diameter of 9 mm or less and

a shank diameter of 4 mm or less. With hollow walls,

use a cable/pipe detector to check for any power

cables or water pipes before making any holes.

• Leave a gap of between 5 mm and 10 mm between

the wall and the base of the screw head, as shown.

(We recommend that you consult a home installation

professional.)

We recommend using the supplied rubber stoppers to

achieve the best possible sound from your speakers.

The rubber stoppers prevent the speakers from mov-

ing, providing a more stable platform. Use thick stop-

pers for the center speaker, and thin stoppers for the

other speakers.

(White) (Red) (Blue) (Gray)

(Green)

Speaker terminals

Keyhole slot

SKF-528

SKR-528

Speaker terminals

Keyhole slots

SKC-528

Keyhole slot for

wall mounting

Thick rubber

stoppers

Keyhole slots for wall mounting

217 mm

Thick rubber

stoppers

Wall

5 to 10 mm

Thin rubber stoppers

Bottom of the

SKR-528

Bottom of the

SKF-528

Bottom of the

SKC-528

55 mm

12 mm

Thick rubber stoppers

Produkt Specifikationer

Mærke:	Onkyo
Kategori:	Højttaler
Model:	SKS-HT528
Produktfarve:	Sort
Udgangseffekt (RMS):	120 W
Lyd-output kanaler:	5.1 kanaler
Subwoofer RMS-effekt:	150 W
Frekvensområde for centerhøjttaler:	80 - 20000 Hz
Subwoofer driver diameter (britisk):	7.9 "
Subwoofer frekvensomrpde:	27 - 150 Hz
Satellithøjttalere RMS-effekt:	120 W
Antal satellithøjttalere:	4
Frekvensområde for satellithøjttaler:	80 - 20000 Hz
Satellithøjttalerimpedans:	6 ohm (Ω)
Centerhøjttaler dimensioner (BxDxH):	230 x 102 x 113 mm
Centerhøjttaler vægt:	900 g
Subwoofer vægt:	9100 g
Centerhøjttaler RMS-effekt:	120 W
Centerhøjttalerimpedans:	6 ohm (Ω)