Onkyo SKS-HT648 Manual

Onkyo Hjemmebiograf sæt SKS-HT648

Læs nedenfor 📖 manual på dansk for Onkyo SKS-HT648 (1 sider) i kategorien Hjemmebiograf sæt. Denne guide var nyttig for 33 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/1

5.1ch Home Cinema Package

Y1105-1

2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPAN

Tel: 072-831-8023 Fax: 072-831-8163

http://www.onkyo.com/

18 Park Way, Upper Saddle River, N.J. 07458, U.S.A.

Tel: 800-229-1687, 201-785-2600 Fax: 201-785-2650

http://www.us.onkyo.com/

Liegnitzerstrasse 6, 82194 Groebenzell, GERMANY

Tel: +49-8142-4401-0 Fax: +49-8142-4401-555

http://www.eu.onkyo.com/

The Coach House 81A High Street, Marlow, Buckinghamshire, SL7 1AB, UK

Tel: +44-(0)1628-473-350 Fax: +44-(0)1628-401-700

Unit 1 & 12, 9/F, Ever Gain Plaza Tower 1, 88, Container Port Road, Kwai Chung,

N.T., Hong Kong. Tel: 852-2429-3118 Fax: 852-2428-9039

http://www.ch.onkyo.com/

1301, 555 Tower, No.555 West NanJin Road, Jin an, Shanghai,

China 200041, Tel: 86-21-52131366 Fax: 86-21-52130396

SN 29400781

Using the Rubber Stoppers for a More Stable Platform

Attaching and detaching the speaker grilles

Front speaker (SKF-648) Center speaker (SKC-648) Surround speaker (SKR-648)

Front speakers Speaker cables 3.5 m Center speaker

Speaker cable 3.0 m Surround speakers Speaker cables 8.0 m

12 rubber stoppers* (For Front/Surround speakers)

4 rubber stoppers*

*Configuration of the rubber stoppers may be different from the figure, such as being 2 sheets instead of 1 sheet, but the total number will be same.

We recommend using the supplied rubber stoppers to achieve

the best possible sound from your speakers.

The rubber stoppers prevent the speakers from moving,

providing a more stable platform.

The front, center and surround speakers have detachable grilles.

See the right illustrations to attach or detach them.

(White) (Red)

(Green)

(Blue) (Gray)

Speaker terminals

SKF-648

SKR-648 Speaker terminals

SKC-648

Rubber stoppers

Bottom of the

SKF-648

SKR-648

Bottom of the

SKC-648

Rubber stoppers

Removal Replacement

■Front

■Rear

Note

• The Auto Standby function turns the subwoofer on when the input signal exceeds a

certain level. If the Auto Standby function does not work reliably, try slightly increasing

or decreasing the subwoofer output level on your receiver.

• If the Standby/On indicator lights (both red and blue LEDs) several seconds or minutes

after the sound output stopped, this means that the amp protection circuit has been acti-

vated. In this case, set the OUTPUT LEVEL control to the center position, and discon-

nect the power cord from the AC outlet. Wait at least 10 seconds, and then reconnect the

power cord. If that doesn’t solve the issue, contact your Onkyo dealer.

Setting the Subwoofer Level

To set the level of the subwoofer, use the OUTPUT LEVEL control.

Set it so that bass sounds are evenly balanced with the treble sounds

from the other speakers. Because our ears are less sensitive to very

low bass sounds, there’s a temptation to set the level of the

subwoofer too high. As a rule of thumb, set the subwoofer level to

what you think is the optimal level, and then back it off slightly.

Using the Floor Pads for Subwoofer

If the subwoofer is placed on a hard floor

(wood, vinyl, tile, etc.) and playback is very

loud, the subwoofer’s feet may damage the

flooring. To prevent this, place the supplied

pads underneath the subwoofer’s feet. The pads

also provide a stable base for the subwoofer.

Subwoofer (SKW-501E)

Subwoofer

RCA cable 3.0 m 4 floor pads

STANDBY/ON indicator

Red: Subwoofer in standby mode

Blue: Subwoofer on

With the Auto Standby function, the SKW-501E

automatically turns on when an input signal is

detected in Standby mode. When there’s no input

signal for a while, the SKW-501E automatically

enters Standby mode.

POWER switch

Press this switch to the ON position to turn on the

power. Press it to the OFF position to turn off the

power.

OUTPUT LEVEL control

This control is used to adjust the volume of the

subwoofer.

LINE INPUT

This RCA input should be connected to the

subwoofer pre out on your AV receiver with

supplied RCA cable.

To AC outlet

Pad

Enjoying Home Cinema

The Home Cinema means that you can enjoy surround sound with a real sense of movement in your own home — just like being in

a movie theater or concert hall.

Connecting the Speakers

Corner

position

1/3 of wall

position

Center speaker (SKC-648)

Position it close to your TV (prefer-

ably on top) facing forward at about

ear level, or at the same height as the

front left and right speakers.

Front left and right speakers (SKF-648)

They should be positioned facing the listener at about ear level,

and equally spaced from the TV. Angle them inward slightly so as

to create a triangle, with the listener at the apex.

Surround left and right speakers (SKR-648)

Position them at the sides of the listener, or

slightly behind, about 60 to 100 cm above ear

level. Ideally they should be equally spaced

from the listener.

Subwoofer (SKW-501E)

The subwoofer handles the bass sounds of the LFE (Low-Frequency Effects)

channel and bass from the satellite speakers when a crossover is specified.

The volume and quality of the bass output from your subwoofer will depend

on its position, the shape of your listening room, and your listening position.

In general, a good bass sound can be obtained by installing the subwoofer in

a front corner, or at one-third the way along the front wall, as shown.

Red WhiteGreen

Front right

speaker

Center speaker

Gray

Front left

speaker

Surround right

speaker

Speaker Connection

Precautions

Read the following before connecting your

speakers:

• Turn off your receiver before making any

connections.

• Pay close attention to speaker

wiring polarity. Connect

positive (+) terminals to only

positive (+) terminals, and

negative (–) terminals to only negative (–)

terminals. If the speakers are wired

incorrectly, the sound will be out of phase

and will sound unnatural.

• Be careful not to short the positive and

negative wires. Doing so may damage

your amp.

Powered

subwoofer

*Using the supplied RCA cable,

connect the subwoofer’s LINE

INPUT to your AV receiver’s

SUBWOOFER PRE OUT jack.

Blue

Surround left

speaker

Specifications

■Powered Subwoofer (SKW-501E)

■Front Speakers (SKF-648)

■Center Speaker (SKC-648)

■Surround Speakers (SKR-648)

Specifications and appearance are subject to change without

prior notice.

Note

For non-magnetic shielded speakers:

Try moving the speakers away from your TV or monitor. If discoloration should occur, turn off your TV or monitor, wait 15 to 30

minutes, and then turn it back on again. This normally activates the degaussing function, which neutralizes the magnetic field,

thereby removing any discoloration effects.

Type Bass-Reflex

Input sensitivity/impedance 410 mV / 20 kΩ

Rated output Power (IEC) 80 watts minimum continuous power,

4 ohms, driven at 100 Hz with a

maximum total harmonic distortion of

1 %

Frequency response 27 Hz to 150 Hz

Cabinet capacity 24.5 L

Dimensions (W × H D)×230 mm × 425 mm × 412 mm

(incl. grille and projection)

Weight 9.1 kg

Drivers unit 20 cm Cone Woofer × 1

Power supply (HTP-648) AC 230V, 50Hz

(SKS-HT648) AC 220-240V, 50/60 Hz

Power consumption 105 W

Other Auto Standby function

Non-magnetic shielding

Type 2 Way Closed Box

Impedance 6 Ω

Maximum input power 130 W

Sensitivity 79 dB/W/m

Frequency response 70 Hz to 50 kHz

Crossover frequency 7 kHz

Cabinet capacity 0.9 L

Dimensions (W × H D)×102 mm × 170 mm × 105 mm

(incl. grille and projection)

Weight 1.0 kg

Drivers unit 8 cm Cone Woofer × 1

2.5 cm Balanced Dome Tweeter × 1

Terminal Spring type color coded

Grille Detachable

Insert nut Available

Other Magnetic shielding

Type 2 Way Closed Box

Impedance 6 Ω

Maximum input power 130 W

Sensitivity 82 dB/W/m

Frequency response 70 Hz to 50 kHz

Crossover frequency 7 kHz

Cabinet capacity 1.3 L

Dimensions (W × × H D) 277 mm × 110 mm × 110 mm

(incl. grille and projection)

Weight 1.7 kg

Drivers unit 8 cm Cone Woofer × 2

2.5 cm Balanced Dome Tweeter × 1

Terminal Spring type color coded

Grille Detachable

Insert nut Available

Other Magnetic shielding

Type Full Range Closed Box

Impedance 6 Ω

Maximum input power 130 W

Sensitivity 80 dB/W/m

Frequency response 80 Hz to 20 kHz

Cabinet capacity 0.9 L

Dimensions (W × × H D) 102 mm × 170 mm × 105 mm

(incl. grille and projection)

Weight 0.9 kg

Drivers unit 8 cm Cone × 1

Terminal Spring type color coded

Grille Detachable

Insert nut Available

Other Magnetic shielding

HTP-648/SKS-HT648

Produkt Specifikationer

Mærke:	Onkyo
Kategori:	Hjemmebiograf sæt
Model:	SKS-HT648
Produktfarve:	Sort
Udgangseffekt (RMS):	210 W
Anbefalet brug:	Hjemmebiograf
Lyd-output kanaler:	5.1 kanaler
Strømkilde:	Vekselstrøm
Pakkens dimensioner (BxDxH):	566 x 464 x 480 mm
Subwoofer RMS-effekt:	80 W
Frekvensområde for centerhøjttaler:	70 - 50000 Hz
Subwoofer type:	Passiv subwoofer
Subwoofer frekvensomrpde:	27 - 150 Hz
Satellithøjttalere RMS-effekt:	- W
Centerhøjttaler vægt:	1700 g
Subwoofer vægt:	9100 g
Centerhøjttaler type:	2-vejs
Centerhøjttaler RMS-effekt:	130 W
Forstærkningsenhed inkluderet:	Ingen
Fronthøjttaler type:	2-vejs
Fronthøjttaler, frekvensinterval:	70 - 50000 Hz
Subwoofer-impedans:	4 ohm (Ω)
Fronthøjttaler vægt:	1000 g
Fronthøjttalere RMS-effekt:	130 W