OttLite CS309G5W Manual

OttLite Lys CS309G5W

Læs nedenfor 📖 manual på dansk for OttLite CS309G5W (2 sider) i kategorien Lys. Denne guide var nyttig for 5 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
CONGRATULATIONS! You’ve purchased the nest in natural lighting
technology with your new OttLite® product.
PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form and return it
today by mail, or register online by going to: OttLite.com/warranty
WARNING: To prevent electric shock, make sure the lamp is not plugged
in until all steps are complete.
NOTE: THIS UNIT IS FULLY ASSEMBLED
1. Remove lamp from packing, placing lamp body base (A) at on a steady
surface.
2. I/O Switch (C) can toggle into two positions (left and right). The light will
not turn on when the switch is in the right-position. Toggle the switch to
left-position so the light will be able to turn on.
3. PLEASE NOTE: This lamp will function while the USB charging cable
is plugged into a power source OR on its own internal battery. When
using on battery power and the light starts to dim, this indicates that the
internal battery needs to be recharged. Charging will occur regardless
of the position of I/O Switch (C).
4. To recharge the battery, plug micro-USB connector (D) into port (E)
in the rear-bottom of the lamp. Then plug USB-A connector (F) into a
standard 5V, 0.5A USB power source such as a computer USB Port or
a USB power adapter (not included). LED indicator (J) will change from
RED to GREEN when lamp is fully charged.
5. With I/O Switch (C) in the left-position, turn the lamp ON/OFF by using
power switch (B) located on top of base (A).
6. Press and hold power switch (B) to adjust brightness until desired
brightness level is achieved, then release.
7. Touch power switch (B) to change the color temperature of the light.
This lamp has 3 color modes.
8. To reposition the light, hold the lamp base (A) steady and grasp either
ex-neck (G) or shade (H) depending on needed adjustment. DO NOT
FORCE the shade or lamp body outside allowable adjustable range as
excessive adjustment may cause damage.
SAFETY WARNING:
1. Turn lamp off and WAIT UNTIL LAMP HEAD IS COOL before handling.
2. The LED panel (K) might get hot after several hours of continuous use
DO NOT place your hands directly on LED light panel.
3. The lamp head included with this unit cannot be replaced by the
consumer.
4. INDOOR USE ONLY.
NOTE: The important safety instructions appearing in this instruction sheet
are not meant to cover all possible conditions and situations that may occur.
It must be understood that common sense, caution, and care must be used
with any electrical product.
CAUTION!
CAUTION: Any change or modication to product not expressly recognized
by OttLite voids OttLite’s responsibility for proper function of product.
FCC PART 15
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
the interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
CAN ICES-005 (B)/NMB-005 (B)
Specications
USB: 5V, 0.5A / Input power: 5V, 0.5A
Built-in Lithium Battery: 3.7V / 1500mAh (power for LED light)
Accessories:
• USB charging cable
ENGLISH Vibe Rechargeable LED Ring Desk Lamp
Vibe Rechargeable LED Ring Desk Lamp
CS309G5W L078
INS240810 REV081524
Li-ion Battery - Model: 18650
Capacity: 1500mAh (5.55 Wh). Output Voltage: 3.7V
NOTICE:
Never disassemble by yourself. Use the authorized charger only. Exposure of
battery to open ames could cause explosion.
Do not expose the battery pack out of the temperature range 32°F to 113°F
(0°C~45°C)
Do not incinerate.
Battery is not replaceable.
Properly dispose in accordance with local regulations for hazardous waste.
MADE IN CHINA
AB
C
E
H
D
G
F
K
J


Produkt Specifikationer

Mærke: OttLite
Kategori: Lys
Model: CS309G5W

Har du brug for hjælp?

Hvis du har brug for hjælp til OttLite CS309G5W stil et spørgsmål nedenfor, og andre brugere vil svare dig




Lys OttLite Manualer

Lys Manualer

Nyeste Lys Manualer

Savio

Savio FL-03 Manual

6 Februar 2025
Savio

Savio FL-01 Manual

6 Februar 2025
Neewer

Neewer WP11 Manual

6 Februar 2025
Neewer

Neewer NW48 II Manual

4 Februar 2025
Neewer

Neewer PL81 PRO Manual

4 Februar 2025
Neewer

Neewer RM18 Manual

4 Februar 2025
Neewer

Neewer FS300C Manual

4 Februar 2025
Neewer

Neewer FS150C Manual

4 Februar 2025
Neewer

Neewer HS60C Manual

4 Februar 2025