Philips QP2523 Manual


Læs nedenfor 📖 manual på dansk for Philips QP2523 (2 sider) i kategorien barbermaskine. Denne guide var nyttig for 15 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
English
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benefit from the support that
Philips offers, register your product at
www.philips.com/welcome.
General description (Fig. 1)
1 Protection cap
2 Blade
3 Blade release slide
4 On/off button
5 Small plug
6 Battery charge indicator
7 Supply unit
Important safety information
Read this important information carefully before
you use the appliance and its accessories and save
it for future reference. The accessories supplied
may vary for different products.
Danger
- Keep the supply unit dry (Fig. 2).
Warning
- To charge the battery, only use the detachable
supply unit (A00390) provided with the
appliance.
- The supply unit contains a transformer. Do not
cut off the supply unit to replace it with another
plug, as this causes a hazardous situation.
- This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. Cleaning and
user maintenance shall not be made by
children without supervision.
- Always unplug the appliance before you clean it
under the tap.
- Always check the appliance before you use it.
Do not use the appliance if it is damaged, as
this may cause injury. Always replace a
damaged part with one of the original type.
- Do not open the appliance to replace the
rechargeable battery.
Caution
- Never immerse the charging stand in water and
do not rinse it under the tap (Fig. 2).
- Do not use the supply unit in or near wall
sockets that contain an electric air freshener to
prevent irreparable damage to the supply unit.
- Only use this appliance for its intended purpose
as shown in the user manual.
- For hygienic reasons, the appliance should only
be used by one person.
- Never use water hotter than 60°C to rinse the
appliance.
- Never use compressed air, scouring pads,
abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the
appliance.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic fields.
General
- This appliance is waterproof (Fig. 3). It is
suitable for use in the bath or shower and for
cleaning under the tap. For safety reasons, the
appliance can therefore only be used without
cord.
- The supply unit is suitable for mains voltages
ranging from 100 to 240 volts.
- The supply unit transforms 100-240 volts to a
safe low voltage of less than 24 volts.
Charging
Note: This appliance can only be used without cord
(Fig. 4).
Charge the appliance before you use it for the first
time and when the appliance starts working more
slowly.
Charging normally takes approx. 8 hours.
A fully charged appliance has an operating time of
up to 45 minutes.
1
3
2
45
6
7
1
Battery charge indicator
The battery status is indicated by the performance
of the appliance. When the appliance starts
working more slowly, the battery is almost empty
and needs to be charged for optimal performance.
Charging with the supply unit
1 Insert the small plug into the appliance and put
the supply unit in the wall socket (Fig. 5).
-The battery charge indicator on the supply
unit lights up continuously, when the
appliance is connected to the wall socket.
2 After charging, remove the supply unit from the
wall socket and pull the small plug out of the
appliance.
Using the appliance
You can use the appliance to trim, edge or shave
facial hair (beard, moustache and sideburns).
Shave for a smooth result, trim to obtain a certain
length and edge to create perfect edges and sharp
lines. This appliance is not intended for shaving,
edging or trimming hairs on lower body parts or
scalp hair. Take your time when you first start to
use the appliance. You have to acquire practice
with the appliance.
Note: This appliance can only be used without cord
(Fig. 4).
Switching the appliance on and off
1 To switch on the appliance, press the on/off
button once (Fig. 6).
2 To switch off the appliance, press the on/off
button once.
Shaving
Warning: Before you use the appliance, always
check the blade for damage or wear. If the
blade is damaged or worn, do not use the
appliance, as injury may occur. Replace a
damaged blade before you use the appliance
(see chapter ‘Replacement’).
Shaving tips and tricks
- Make sure that the blade is in full contact with
the skin by placing it flat on the skin.
- For the best result, move the appliance against
the grain.
- Make long strokes while pressing lightly.
- You can use the appliance dry or wet with gel or
foam. You can even use the appliance in the
shower.
- Shaving a clean beard and face gives the best
results.
Shaving
Before you use the appliance, always check
the blade for damage or wear. If the blade is
damaged or worn, do not use the appliance, as
injury may occur. Replace a damaged blade
before you use the appliance.
1 Switch on the appliance.
2 Place the blade on the skin and move the
appliance up or against the grain in long strokes
while you press it lightly (Fig. 7).
Note: Make sure you hold the surface of the
blade flat against your skin (Fig. 8).
3 Switch off and clean the appliance after every
use (see 'Cleaning and maintenance').
Edging
- You can also use both edges of the blade to
create sharp lines and perfect edges.
- Hold the appliance in such a way that the blade
is perpendicular to the skin and one of its edges
touches the skin. This allows more precise
detailing of sideburns and the area around the
mouth and nose.
1 Switch on the appliance.
2 Place the edge of the blade perpendicular onto
the skin (Fig. 9).
Note: To use the blade for creating sharp edges
and lines, use either edge of the blade (Fig. 10).
3 Make straight strokes while applying gentle
pressure (Fig. 11).
4 Switch off and clean the appliance after every
use (see 'Cleaning and maintenance').
Cleaning and maintenance
Clean the appliance after every use.
Never use compressed air, scouring pads, abrasive
cleaning agents or aggressive liquids such as
petrol or acetone to clean the appliance.
Do not tap the appliance against a surface to
remove water from it, as this may cause damage
(Fig. 12). Replace the blade if it is damaged.
Never dry the blade with a towel or tissue, as this
may cause damage.
Cleaning the appliance
1 Blow off any hairs that have accumulated on
the blade.
2 Switch on the appliance and rinse the blade
with lukewarm water (Fig. 14).
Caution: Do not dry the blade with a towel or a
tissue as this may cause damage.
3 Carefully shake off excess water and let all parts
air dry completely.
Note: The blade is fragile. Handle it carefully.
Replace the blade if it is damaged.
Storage
Always attach the protection cap on the blade to
protect the blade from damage during travelling or
storage.
We advise you to let the appliance and its
attachments are completely dry before you store
them for the next use.
1 Place the protection cap onto the edge of the
blade (Fig. 15).
2 Close the protection cap (Fig. 16).
Replacement
Usage indicator
For optimal cutting and gliding performance, we
advise you to replace the blade every 4 months,
when it no longer provides the shaving or trimming
results you expect.
The blade is equipped with an usage indicator. A
green bar will gradually appear on the blade as you
use it (Fig. 17). When it is highly visible, it is
recommended to replace your blade for the best
OneBlade experience. Always replace the blade
with original Philips blade.
Depending on your usage behavior, the exact
lifetime of the blade could be longer or shorter.
Similar to a manual blade, the blade becomes
blunt over time, which results in increased hair
pulling and reduced cutting performance.
Replacing the blade
1 Switch off the appliance.
2 Push the blade release slide upwards carefully,
and hold the blade on its sides to remove the
blade and prevent it from flying away (Fig. 18).
3 Hold the new blade on its sides and press it
onto the handle (‘click’) (Fig. 19).
Note: Be careful, the edges of the blade are sharp.
When you hear a click the new blade is placed
correctly and ready for use.
Ordering accessories
To buy accessories or spare parts, visit
www.shop.philips.com/service or go to your
Philips dealer. You can also contact the Philips
Consumer Care Center in your country (see the
international warranty leaflet for contact details).
The following parts are available:
- QP210 Blade 1-pack
- QP220 Blade 2-pack
Recycling
- Do not throw away the product with the normal
household waste at the end of its life, but hand
it in at an official collection point for recycling.
By doing this, you help to preserve the
environment.
- This product contains a built-in rechargeable
battery which shall not be disposed of with
normal household waste. Please take your
product to an official collection point or a
Philips service center to have a professional
remove the rechargeable battery.
- Follow your country’s rules for the separate
collection of electrical and electronic products
and rechargeable batteries. Correct disposal
helps prevent negative consequences for the
environment and human health.
Removing the rechargeable battery
Only remove the rechargeable battery when
you discard the product. Before you remove
the battery, make sure that the product is
disconnected from the wall socket and that
the battery is completely empty.
Take any necessary safety precautions when
you handle tools to open the product and
when you dispose of the rechargeable battery.
Removing the rechargeable battery
Only remove the rechargeable battery when
you discard the product. Before you remove
the battery, make sure that the product is
disconnected from the wall socket and that
the battery is completely empty.
Take any necessary safety precautions when
you handle tools to open the product and
when you dispose of the rechargeable battery.
1 Check if there are screws in the back or front of
the appliance. If so, remove them.
2 Remove the back and/or front panel of the
appliance with a screwdriver. If necessary, also
remove additional screws and/or parts until you
see the printed circuit board with the
rechargeable battery.
3 Remove the rechargeable battery.
Troubleshooting
This chapter summarizes the most common
problems you could encounter with the appliance.
If you are unable to solve the problem with the
information below, visit www.philips.com/support
for a list of frequently asked questions or contact
the Consumer Care Center in your country.
Problem Possible
cause
Solution
The
appliance
does not
charge
when it is
connected
to the
mains.
The
appliance has
to be
switched off
when you
charge it.
Switch off the
appliance.
I cannot
switch on
the
appliance
when it is
connected
to the
mains.
You cannot
use the
appliance
when it is
charging. You
can only use
the appliance
without cord.
Disconnect the
appliance from the
mains before use.
QP2523
4222.002.9067.1 20/3/2018
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
1
2
18
19


Produkt Specifikationer

Mærke: Philips
Kategori: barbermaskine
Model: QP2523

Har du brug for hjælp?

Hvis du har brug for hjælp til Philips QP2523 stil et spørgsmål nedenfor, og andre brugere vil svare dig




barbermaskine Philips Manualer

barbermaskine Manualer

Nyeste barbermaskine Manualer