Polmar DB-50M Manual

Polmar Marine DB-50M

Læs nedenfor 📖 manual på dansk for Polmar DB-50M (2 sider) i kategorien Marine. Denne guide var nyttig for 7 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Polmar DB-50M quick reference guide
© 2014 by PC5E/Robert Elsinga, www.pc5e.nl (but distribution permitted when unchanged)
Front panel
1
Dial A
R: Change channel/freq/scan dir
P: Set as main band/confirm setup
2
Dial B
R: Change channel/freq/scan dir
P: Set as main band/confirm setup
3
Vol A
R: Adjust volume
H: Delete memory channel (Hold to confirm)
4
Vol B
R: Adjust volume
H: Delete memory channel (Hold to confirm)
5
Sql
H: turn Squelch off momentarily, rotate dial to change Squelch level
6
Set
P: enter Set menu
H: Write/Copy Memory channel (hold Set to
confirm) or Delete Memory channel (hold
Vol to confirm)
7
ɸ
H: Power on/off
8
LOW
P: Power level Low/Mid2/Mid1/High
H: Additional Signalling 5T/2T/DTMF
9
V/M
P: VFO mode <-> Memory mode
H: Channel spacing Wide/Middle/Narrow
10
HM
P: Enable Home channel
H: Dual Watch (VFO+Memory ch) on/off
11
SCN
P: Scanning on/off
H: turn Skip on/off for Memory channel
12
MHZ
P: change dial step 1MHz/10 ch
H: Talk Around (RX/TX on repeater output)
on/off
13
REV
P: Frequency Reverse on/off
H: Compander on/off
14
TONE
P: cycle Tone/CTCSS/DCS
H: CTCSS/DCS scan (when CTCSS/DCS is on)
15
SUB
P: configure sub band settings
H: cycle through Scrambler settings
P: = press knob/key once, H: = hold knob/key down for 1 second, R: rotate knob
Microphone
1
UP
RX: channel/frequency up
2
DN
RX: channel/frequency down
3
PTT
Transmit
4
0..9
RX: input memory ch/frequency
*
RX: Squelch on/off
#
RX: input and store memory freq
PA..PD
RX: programmed keys
5
A/B
RX: main band A<->B
6
MAIN
Main band indicator
7
RT
RX/TX indicators
8
MIC
Microphone
9
Speaker (when enabled in Menu 55)
RX: = press while in standby, TX: press while transmitting


Produkt Specifikationer

Mærke: Polmar
Kategori: Marine
Model: DB-50M

Har du brug for hjælp?

Hvis du har brug for hjælp til Polmar DB-50M stil et spørgsmål nedenfor, og andre brugere vil svare dig