Rangemaster CLASP110BB Manual

Rangemaster Ikke kategoriseret CLASP110BB

Læs nedenfor 📖 manual på dansk for Rangemaster CLASP110BB (4 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 9 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/4

U104320-05

Fitting

Please read all of this instruction before

installing the splashback.

The manufacture disclaims all liabilities

for any damage or injury caused as a

result of not following this instruction

leaet.

This splashback is designed to t on

the wall behind your range cooker.

The wall should be at and clear of any

obstructions.

 Take care, the splashback is

heavy and we recommend at

least two people should t it.

 Beware of sharp edges. Use

gloves when handling the

splashback.

 Before drilling the wall check

that there are no electrical

cables or pipe work in the wall

in the xing areas.

The splashback should be tted AFTER

the cooker has been installed and

BEFORE an extractor hood is tted.

To Fit the Splashback

You will need the following equipment

to complete the splashback installation

satisfactorily

• Apencilormarker

• Arule

• Adrill

• A7mmmasonrydrill

• Acrosspointscrewdriver

• Rawlplugsandscrewsor;ifxing

to a hollow construction plaster,

special plaster board xing screws

or plugs.

In order to t the splashback at the

correct height the cooker must rst be

installed, set to the correct height and

levelled.

If the cooker has a short cooker

splashbacktted   canberemove it. It

retted later if required.

Mark the wall behind the cooker at the

ue grille height.

Move forward.thecooker Measure

down 38 mm from the your marks and

draw a line.

ArtNo.420-0001 Splashback: marking the wall

original line at cooker height

line of bottom edge of splashback

38 mm

This dimension will position the splash

plate as shown in (1).

If you want to mount the splashback

lower as in (2), please be aware that

you have movewill  to thecooker

forwards.

ArtNo.420-0003 Bottom fixing

1 2

Hold the splashback in position with

bottomedgelevelwiththelowerline.

ArtNo.420-0004 Holding the splashback to wall

Bottom line

Splashback

Mark the position of the xing holes on

the wall.

Atleast6screwsmustbeused holdto

the splashback – 3 at the top and 3 at

the bottom.

Removethesplashbackanddrillthe

wallusinga7mmmasonrybit.Using

suitable rawl plugs and screws, secure

the splashback into position.

Note: When tting a cookerhood along

with a splashback, please refer to the

cookerhood instructions for important

tting dimensions.

Produkt Specifikationer

Mærke:	Rangemaster
Kategori:	Ikke kategoriseret
Model:	CLASP110BB
Type:	Husholdningsartikel, splashback
Bredde:	1090 mm
Dybde:	8 mm
Højde:	670 mm
Antal pr. pakke:	1 stk
Produktfarve:	Sort
Enhedstype:	Komfur