Rega Fono Mini A2D Manual

Rega Modtager Fono Mini A2D

Læs nedenfor 📖 manual på dansk for Rega Fono Mini A2D (1 sider) i kategorien Modtager. Denne guide var nyttig for 47 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/1
Exceptional Hi-Fi designed and manufactured in England www.rega.co.uk
F
F
F
FFono mini
ono mini
ono mini
ono mini ono mini A2D
A2D
A2D
A2D A2D
Moving Magnet disc stage with USB
Moving Magnet disc stage with USB
Moving Magnet disc stage with USB
Moving Magnet disc stage with USBMoving Magnet disc stage with USB
Connections via USB to PC
To transfer vinyl to your PC You will need to install
a digital audio editor. Such software is widely
available as a free download (such as Audacity)
from the internet. This is a simple interface which
allows monitoring of volume and balance whilst
transferring your audio to your PC hard drive.
Audio editing software includes a level meter
which indicates the output level achieved when
playing a piece of vinyl. You should adjust the
output as necessary via the ‘Level’ control located
on the front panel. Always take special note of
record levels to ensure optimum recording quality.
Output Level Dial
Specifications
Input sensitivity: 5mV for 500mV output
Input loading: 47k +100pF
Maximum input level: 70mV @ 1kHz
Output Impedance: 100 Ohms
Signal to noise ratio: 78dBA ref 5mV
Power requirements: 24VAC 85mA
Input for full scale digital output: 7.5mV
WARNING
Only use the supplied mains adaptors with this product.
EURO-PS2
Input 230V-50Hz 25mA
Output 24V-100mA
AUS/NZ-PS2
Input 230V-30mA
Output 24V-100mA
USA/CANADA-PS2
Input 115V-60mA
Output 24V-100mA
UK-PS2
Input 230V-50Hz 25mA
Output 24V-100mA
Introduction
The is designed to amplify the Fono mini A2D
signal from a moving magnet cartridge to a
suitable level for all line level inputs of an audio
amplifier. The USB interface also offers the ability
to simply transfer vinyl to PC . The Fono mini A2D
amplifier offers exceptional performance and
convenience and will be a valuable addition to any
Hi-Fi set up.
Input Connections (1)
Connect the signal lead (tonearm leads) to the
input sockets labelled on the rear panel. If the
tonearm requires a separate earth please
connect the earth lead to the earth terminal
located on the front panel of the Fono mini A2D.
Output Connections (2)
Connect the output sockets of the Fono mini A2D
to a suitable ‘line level’ input on your amplifier
using appropriate RCA leads. (Do not connect to
an amplifiers integrated ‘Phono’ or ‘Disk’ input).
Power Connections (4)
Connect the designated power supply to the
power socket situated on the rear panel. Power
on is indicated by illumination of the red LED (3).
Set-up is now complete, simply switch on, sit back
and enjoy!
(4) (2) (3)
(1)

Produkt Specifikationer

Mærke: Rega
Kategori: Modtager
Model: Fono Mini A2D

Har du brug for hjælp?

Hvis du har brug for hjælp til Rega Fono Mini A2D stil et spørgsmål nedenfor, og andre brugere vil svare dig


Modtager Rega Manualer

Rega

Rega Osiris Manual

1 September 2024
Rega

Rega Elex MK4 Manual

30 August 2024
Rega

Rega io Manual

30 August 2024
Rega

Rega Elicit MK5 Manual

30 August 2024
Rega

Rega Elicit-R Manual

26 Juli 2024
Rega

Rega Elex-R Manual

29 Juni 2023
Rega

Rega Fono Mini A2D Manual

26 December 2022

Modtager Manualer

Nyeste Modtager Manualer

Henry Engineering

Henry Engineering AES DIGITAL DA 2X4 Manual

21 November 2024
QSC

QSC PowerLight 9.0 Manual

20 November 2024
Ashly

Ashly FX-125.4 Manual

20 November 2024
JBL

JBL Grand Touring GTO-501EZ Manual

20 November 2024
Harman Kardon

Harman Kardon CA5250 Manual

19 November 2024
Esoteric

Esoteric F-05 Manual

19 November 2024
Konig & Meyer

Konig & Meyer 28075 Manual

18 November 2024
IFi Audio

IFi Audio ZEN CAN 3 Manual

18 November 2024
JBL

JBL Marine MA6002 Manual

18 November 2024
Infinity

Infinity Kappa One Manual

18 November 2024