Roland GA-FC Manual

Roland Ikke kategoriseret GA-FC

Læs nedenfor 📖 manual på dansk for Roland GA-FC (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 158 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/2
GA-FC Owner’s Manual * 5100029053- 02*
Connecting the foot controller
How to operate the foot controller
Using the expression pedals
By connecting expression pedals (Roland EV-5, BOSS FV-500L, BOSS FV-500H; sold separately), you can change the DRIVE value and volume by pedal.
DRIVE jack
Use this to control DRIVE. When BOOST is o, the sound can be changed from clean to crunch, and when BOOST is on, changed from clean to super
extreme.
With an expression pedal connected to the DRIVE jack, the drive value can be controlled from 0 to the current
DRIVE value on the panel. When the pedal is pressed fully down, the drive value shown by the panel knob will be
applied.
VOLUME jack
This is for controlling the volume. Volume swell and mute are possible.
* The volume that you can control with the expression pedal connected to this jack is dierent from the [VOLUME] on the panel. The pedal
operation is not linked to the [VOLUME] knob level.
Drive values that can
be controlled with the
expression pedals.
(Example)
Blinks in the
FUNCTION mode.
You can change channels by using the foot controller. By pressing the [FUNCTION] switch, you can also turn on/o BOOST, MID BOOST, EFX LOOP A, EFX
LOOP B, and REVERB.
* The ON/OFF operation of BOOST, MID BOOST, EFX LOOP A, EFX LOOP B, and REVERB using the foot controller is not saved in the channel.
Connect a stereo cable to the FOOT CONTROL/LINK IN jack of the GA-212/GA-112.
* Always use a stereo cable.
* Use cables that do not contain resistors.
Setting MINIMUM VOLUME of an expression pedal
With the [MINIMUM VOLUME] knob of an expression pedal, you can set the value for
when the pedal is lifted up all the way (lowest value).
DRIVE value settings after changing channel
When an expression pedal is connected to the DRIVE jack, you can set the DRIVE value after changing channel to the
current pedal value, not the value saved in the channel. To make the setting, see “GA-212/GA-112 Owner’s Manual.“
[MINIMUM
VOLUME]
knob
* Use only the specied expression pedal (Roland EV-5, BOSS FV-500L, BOSS FV-500H; sold separately). By connecting any other expression pedals,
you risk causing malfunction and/or damage to the unit.
* This instrument is equipped with TRS type jacks. Wiring diagrams for these
jacks are shown below.
TIP
RING
SLEEVE (GND)
USING THE UNIT SAFELY
Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES”. These sections provide important information concerning the
proper operation of the unit. Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Owner’s manual
should be read in its entirety. The manual should be saved and kept on hand as a convenient reference.
Used for instructions intended to alert the
user to the risk of injury or material
damage should the unit be used
improperly.
* Material damage refers to damage or
other adverse effects caused with
respect to the home and all its
furnishings, as well to domestic animals
or pets.
Used for instructions intended to alert the
user to the risk of death or severe injury
should the unit be used improperly.
The symbol alerts the user to things that must be
carried out. The specific thing that must be done is
indicated by the design contained within the circle. In the
case of the symbol at left, it means that the power-cord
plug must be unplugged from the outlet.
The symbol alerts the user to important instructions or
warnings.The specific meaning of the symbol is
determined by the design contained within the triangle. In
the case of the symbol at left, it is used for general
cautions, warnings, or alerts to danger.
The symbol alerts the user to items that must never be
carried out (are forbidden). The specific thing that must
not be done is indicated by the design contained within
the circle. In the case of the symbol at left, it means that
the unit must never be disassembled.
About WARNING and CAUTION Notices About the Symbols
ALWAYS OBSERVE THE FOLLOWING
WARNING
Do not disassemble or modify by yourself
Do not open or perform any internal
modications on the unit.
Do not repair or replace parts by yourself
Do not attempt to repair the unit, or
replace parts within it (except when this
manual provides specic instructions
directing you to do so). Refer all servicing
to your retailer, the nearest Roland
Service Center, or an authorized Roland
distributor, as listed on the “Information”
page.
Do not use or store in the following types of
locations
• Subject to temperature extremes (e.g.,
direct sunlight in an enclosed vehicle,
near a heating duct, on top of heat-
generating equipment); or are
• Damp (e.g., baths, washrooms, on wet
oors); or are
• Exposed to steam or smoke; or are
• Subject to salt exposure; or are
• Humid; or are
• Exposed to rain; or are
• Dusty or sandy; or are
• Subject to high levels of vibration and
shakiness.
Do not place in an unstable location
Make sure you always have the unit
placed so it is level and sure to remain
stable. Never place it on stands that could
wobble, or on inclined surfaces.
WARNING
Don’t allow foreign objects or liquids to enter unit;
never place containers with liquid on unit
Never allow foreign objects (e.g.,
ammable objects, coins, wires) or liquids
(e.g., water or juice) to enter this product.
Doing so may cause short circuits, faulty
operation, or other malfunctions.
Turn o the unit if an abnormality or malfunction
occurs
Immediately turn the amplier o, and
request servicing by your retailer, the
nearest Roland Service Center, or an
authorized Roland distributor, as listed on
the “Information” page when:
• Objects have fallen into, or liquid has
been spilled onto the unit; or
• If smoke or unusual odor occurs; or
• The unit has been exposed to rain (or
otherwise has become wet); or
• The unit does not appear to operate
normally or exhibits a marked change in
performance.
Adults must provide supervision in places where
children are present
When using the unit in locations where
children are present, be careful so no
mishandling of the unit can take place. An
adult should always be on hand to provide
supervision and guidance.
Do not drop or subject to strong impact
Protect the unit from strong impact.
(Do not drop it!)
CAUTION
Manage cables for safety
Try to prevent cords and cables from
becoming entangled. Also, all cords and
cables should be placed so they are out of
the reach of children.
Avoid climbing on top of the unit, or placing heavy
objects on it
Never climb on top of, nor place heavy
objects on the unit.
Disconnect everything before moving the unit
Disconnect all cords coming from external
devices before moving the unit.
IMPORTANT NOTES
Placement
• This device may interfere with radio and television
reception. Do not use this device in the vicinity of
such receivers.
• When moved from one location to another where
the temperature and/or humidity is very dierent,
water droplets (condensation) may form inside
the unit. Damage or malfunction may result if you
attempt to use the unit in this condition. Therefore,
before using the unit, you must allow it to stand
for several hours, until the condensation has
completely evaporated.
• Depending on the material and temperature of the
surface on which you place the unit, its rubber feet
may discolor or mar the surface.
You can place a piece of felt or cloth under the
rubber feet to prevent this from happening. If you
do so, please make sure that the unit will not slip or
move accidentally.
• Swiftly wipe away any liquid that spills on the unit
using a dry, soft cloth.
Maintenance
• For everyday cleaning wipe the unit with a soft,
dry cloth or one that has been slightly dampened
with water. To remove stubborn dirt, use a cloth
impregnated with a mild, non-abrasive detergent.
Afterwards, be sure to wipe the unit thoroughly
with a soft, dry cloth.
• Never use benzine, thinners, alcohol or solvents of
any kind, to avoid the possibility of discoloration
and/or deformation.
Additional Precautions
• Use a reasonable amount of care when using
the unit’s switches; and when using its jacks
and connectors. Rough handling can lead to
malfunctions.
• When disconnecting all cables, grasp the connector
itself—never pull on the cable. This way you will
avoid causing shorts, or damage to the cable’s
internal elements.
• When you need to transport the unit, package it
in the box (including padding) that it came in, if
possible. Otherwise, you will need to use equivalent
packaging materials.
• Use only the specied expression pedal (Roland EV-
5, BOSS FV-500L, BOSS FV-500H; sold separately).
By connecting any other expression pedals, you risk
causing malfunction and/or damage to the unit.
Copyright
• Roland, BOSS, COSM are either registered
trademarks or trademarks of Roland Corporation in
the United States and/or other countries.
• MMP (Moore Microprocessor Portfolio) refers to a
patent portfolio concerned with microprocessor
architecture, which was developed by Technology
Properties Limited (TPL). Roland has licensed this
technology from the TPL Group.
Main Specications
Roland GA FOOT CONTROLLER (GA-FC): Foot Controller
Controls
[FUNCTION] switch
[MANUAL] switch
[CH 1]–[CH 4] switches
Indicators
FUNCTION
MANUAL
CH 1–CH 4
Connectors
EXP PEDAL DRIVE jack (1/4-inch TRS phone type)
EXP PEDAL VOLUME jack (1/4-inch TRS phone type)
GA FOOT CONTROL jack (1/4-inch TRS phone type)
Dimensions 392 (W) x 81 (D) x 49 (H) mm
15-7/16 (W) x 3-3/16 (D) x 1-15/16 (H) inches
Weight 1.0 kg / 2 lbs 4 oz
Accessories Owner’s Manual, Foot Controller Cable
Options Expression Pedal (Roland EV-5, BOSS FV-500L, BOSS FV-500H)
* In the interest of product improvement, the specications and/or appearance of this unit are subject to change without prior notice.
This product complies with the requirements of EMC Directive 2004/108/EC.
For EU Countries
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
NOTICE
AVIS
For the USA
FEDERAL COMMUNICATIONS COMMISSION
RADIO FREQUENCY INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment requires shielded interface cables in order to meet FCC class B limit.
Any unauthorized changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
For Canada
WARNING
This product contains chemicals known to cause cancer, birth defects and other reproductive harm, including lead.
For C.A. US (Proposition 65)
For EU Countries
For China
Copyright © 2012 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
Rear side GA-212/GA-112

Produkt Specifikationer

Mærke: Roland
Kategori: Ikke kategoriseret
Model: GA-FC

Har du brug for hjælp?

Hvis du har brug for hjælp til Roland GA-FC stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Roland Manualer

Roland

Roland M-1000 Manual

12 Oktober 2024
Roland

Roland Fantom FA-76 Manual

11 Oktober 2024
Roland

Roland KD-200 Manual

7 Oktober 2024
Roland

Roland RD-88 EX Manual

25 September 2024
Roland

Roland RD-2000 EX Manual

25 September 2024
Roland

Roland KT-10 Manual

22 September 2024
Roland

Roland VH-14D Manual

19 September 2024
Roland

Roland CB-R09S Manual

16 September 2024
Roland

Roland UA-100 Manual

12 September 2024
Roland

Roland GP609 Manual

9 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Senal

Senal ASM-5 Manual

21 November 2024
Senal

Senal PS-48B Manual

21 November 2024
Senal

Senal SCS-98 Manual

21 November 2024
Senal

Senal ASM-6 Manual

21 November 2024
Senal

Senal ASM-MNTKIT Manual

21 November 2024
Senal

Senal SMS-45 Manual

21 November 2024
Senal

Senal MXGN-ICO Manual

21 November 2024
Dubatti

Dubatti Board One Manual

21 November 2024
D-Link

D-Link DWA-142 Manual

21 November 2024
Senal

Senal CSP-142 Manual

21 November 2024