Roland RT-30K Manual

Roland Ikke kategoriseret RT-30K

Læs nedenfor 📖 manual på dansk for Roland RT-30K (1 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 8 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/1
Owner’s Manual
You’ll use this product by mounting it on an acoustic drum. The vibrations that occur when a performer strikes
the drum are detected by a sensor, and the force of the strike is sent to the drum sound module as a trigger
signal.
Main Features
• Mounts on your drum easily and securely
• Can be mounted on drums that have a variety of hoop shapes (except wooden hoops)
• Design is optimized for Roland’s drum sound modules
Parts Descriptions
RT-30K (for bass drum) RT-30HR/RT-30H (for snare and tom)
Output Jack
Head Sensor
Mounting Screw
Output Jack
Head Sensor
Mounting Screw
• The RT-30K (Kick Trigger) and RT-30H (Single Trigger) support head triggering.
• The RT-30HR (Dual Trigger) supports separate head/rim dual triggering.
* When you’re not using the trigger, remove it from your drum set.
* Do not apply strong force to the head sensor, and do not subject it to force for an extended time when
you’re not using it. Doing so may deform the head sensor or cause malfunctions.
Mounting the Trigger on Acoustic Drums
Firmly position the trigger against the surface of the drum head, and tighten the screw to secure the trigger
in the position shown in the illustration below.
* To allow the trigger to accurately detect the vibration of the head, mount it between two adjacent tension
bolts.
RT-30K To detect the left and right strokes
evenly when using double pedals
To avoid unintended operation
when the oor tom is struck
Recommended position
To avoid unintended operation when
the snare or high tom is struck
Head
Hoop
Shell
Mounting Screw
RT-30HR/RT-30H HoopHead
Shell
Mounting
Screw
* When you mount the trigger on acoustic drums, please be careful not to get your ngers pinched. In places
where small children are present, make sure that an adult provides supervision and guidance.
Connecting a Drum Sound Module
Use a stereo cable (included) to connect the trigger and the drum sound module.
RT-30K Drum Sound ModuleRT-30HR/RT-30H
* You must use the included stereo cable to connect this trigger to your drum sound module.
* To prevent malfunction and equipment failure, always turn down the volume, and turn o all the units
before making any connections.
Introduction
Setting Up
If your strikes do not produce accurate triggering, check the following three points to improve the triggering.
Adjust the position or angle of your drums
Vibrations and sound can be transmitted from another drum or via the stand, causing notes to be triggered
inadvertently.
Mute or mue the drum head
This will reduce unwanted vibration of the head, improving the accuracy of detection. If a drum is not securely
fastened to the stand, this can also be the cause of unwanted vibration.
Setting trigger parameters in a drum sound module
You can minimize problems by adjusting the settings.
Problem Action
No sound is
triggered
Check the power and volume of your drum sound module.
Make sure that this trigger is securely fastened to the drum hoop, and that the head
sensor is contacting the drum head.
Check the sound module’s trigger indicator to conrm that the drum sound module
is receiving the trigger signals.
Multiple sounds
played when drum
is struck only once
(Retrigger)
The tension bolts on both sides of the trigger should be
fastened quite tightly.
Reduce unneeded vibration, either by exchanging the head for a type that has a
short sustain, or by using a ring mute, tape, or gel material to mute the head.
On your drum sound module, increase the value of the “Retrigger Cancel” setting.
When you strike, a
dierent drum that
you did not strike
also responds
Adjust your setup so that the trigger is not in contact with the stand or with another
drum. If this does not solve the problem, mount the trigger at a position that is
farther away from the other drum.
Reduce unneeded vibration, either by exchanging the head for a type that has a
short sustain, or by using a ring mute, tape, or gel material to mute the head.
On your drum sound module, increase the value of the “Threshold” setting.
If this problem occurs between multiple drums on which triggers are mounted, make
adjustments by gradually increasing the value of the “Crosstalk Cancel” setting on
your drum sound module for the drums that are having the problem.
For snare drum triggering, it’s a good idea to keep the tension of the snares fairly
tight.
Sounds are
triggered without
playing the drums
In some cases, the trigger may be responding to vibrations from the oor or to
sound from a monitor speaker or bass amp. Adjust the location and angle of your
equipment to reduce such vibration or sound.
No response to soft
strikes
On your drum sound module, decrease the value of the “Threshold” setting.
* When making adjustments, take care to avoid double triggering or sound from
other drums.
No response to rim
shots
Rim shots are supported only by the RT-30HR (Dual Trigger).
Use the included stereo cable to connect the trigger to your drum sound module.
The trigger won’t respond to rim shots if you use a monaural cable.
Connect the cable to a trigger input on your drum sound module that supports
Roland PD/PDX series rim shots. For details, refer to the owner’s manual of your drum
sound module.
Dynamic response
seems strange
Adjust the “Sensitivity” and “Velocity Curve” value. For details, refer to the owner’s
manual of your drum sound module.
Troubleshooting
(Kick Trigger)English
Setting Trigger Parameters in a Drum Sound Module
Correct trigger type and parameter settings provide accurate triggering. Here’s how to specify the trigger type
(pad type) on your drum sound module.
Yes
No
Select the trigger that you’re using: “RT-
30K,” “RT-30HR,” or “RT-30H.”
Yes
No
If you’re using the “RT-30K,” “RT-10K”choose ;
if you’re using the “RT-30HR,” choose “RT-10S”;
if you’re using the “RT-30H,” “RT-10T.” choose
Refer to the following URL for the
recommended trigger parameter values.
Enter the following URL in your computer.
http://www.roland.com/manuals/
Select the product name “RT-30K,” “RT-30HR,”
or “RT-30H,” and refer to the settings for each
trigger parameter.
The drum sound module shows
“RT-30K,” “RT-30HR,” or “RT-
30H”
The drum sound module shows
“RT-10K,” “RT-10S,” or “RT-10T”
You’re using a drum sound
module other than the above
Main Specications
RT-30K (Kick Trigger) RT-30H (Single Trigger) RT-30HR (Dual Trigger)
Trigger 1 (Head) 2 (Head & Rim)
Connector Output Jack (1/4 inch Phone Type)
Dimensions 38 (W) x 94–111 (D) x 62 (H) mm
1.50 (W) x 3.70–4.37 (D) x 2.44 (H) inches
39 (W) x 91–112 (D) x 45 (H) mm
1.54 (W) x 3.58–4.41 (D) x 1.77 (H) inches
Weight 95 g
3.35 oz
67 g
2.36 oz
69 g
2.43 oz
Accessories Owner’s Manual, Leaet “USING THE UNIT SAFELY,” Stereo Cable (3.5 m, 11.48 ft)
In the interest of product improvement, the specications and/or appearance of this unit are subject to
change without prior notice.
(Dual Trigger)
(Single Trigger)
Before using this unit, carefully read the leaet “USING THE UNIT SAFELY.” After reading, keep the leaet where
it will be available for immediate reference. Copyright © 2015 ROLAND CORPORATION

Produkt Specifikationer

Mærke: Roland
Kategori: Ikke kategoriseret
Model: RT-30K

Har du brug for hjælp?

Hvis du har brug for hjælp til Roland RT-30K stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Roland Manualer

Roland

Roland M-1000 Manual

12 Oktober 2024
Roland

Roland Fantom FA-76 Manual

11 Oktober 2024
Roland

Roland KD-200 Manual

7 Oktober 2024
Roland

Roland RD-88 EX Manual

25 September 2024
Roland

Roland RD-2000 EX Manual

25 September 2024
Roland

Roland KT-10 Manual

22 September 2024
Roland

Roland VH-14D Manual

19 September 2024
Roland

Roland CB-R09S Manual

16 September 2024
Roland

Roland UA-100 Manual

12 September 2024
Roland

Roland GP609 Manual

9 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Kramer

Kramer VP-8X8 Manual

25 November 2024
Kramer

Kramer PT-2C Manual

25 November 2024
Lazer

Lazer Bob+ Manual

25 November 2024
Dometic

Dometic DPS 80 Manual

25 November 2024
Kramer

Kramer 102MX Manual

25 November 2024
Kramer

Kramer FC-18 Manual

25 November 2024
Kramer

Kramer DSP-62-UC Manual

25 November 2024
Kramer

Kramer KC-BRAINware-25 Manual

25 November 2024
Kramer

Kramer KC-BRAINware-50 Manual

25 November 2024
Tiger

Tiger SKF-H101 Manual

25 November 2024