Shimano FH-5800 Manual


Læs nedenfor 📖 manual på dansk for Shimano FH-5800 (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 18 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
One Holland, Irvine, California 92618, U.S.A. Phone: +1-949-951-5003
High Tech Campus 92, 5656 AG Eindhoven, The Netherlands Phone: +31-402-612222 3-77 Oimatsu-cho, Sakai-ku, Sakai-shi, Osaka 590-8577, Japan
Please note: speci cations are subject to change for improvement without notice. (English)
© Dec. 2017 by Shimano Inc. ITP
UM-3E00A-003-00 User's manual
Rear Freehub
User's manuals in other languages are available at :
http://si.shimano.com
IMPORTANT NOTICE
Contact the place of purchase or a bicycle dealer for information on
installation and adjustment of the products which are not found in the
user's manual. A dealer's manual for professional and experienced bicycle
mechanics is available on our website (http://si.shimano.com).
Do not disassemble or alter this product.
For safety, be sure to read this user's manual thoroughly
before use, and follow them for correct use.
Important Safety Information
Guidelines that require replacement, contact the place of purchase or a
bicycle dealer.
WARNING
Check that the wheels are fastened securely before riding the bicycle. If
the wheels are loose in any way, they may come off the bicycle and
serious injury may result.
After reading the user's manual carefully, keep it in a safe place for later
reference.
CAUTION
Never fasten a wheel to a frame by
rotating the quick release lever as shown
in the diagram on the right.
Simply rotating the lever in a circular
motion will not fasten the wheel to the
frame.
Detachment of the wheel as a result of
improper hub installation can result in
serious bodily injury.
Note
Do not apply any lubricant to the inside of the hub, otherwise the grease
will come out.
If the quick release lever can be easily pushed to the CLOSE position, this
means the clamping strength is insuffi cient. Return the quick release lever
to the position perpendicular to the bicycle frame and again turn the
adjusting nut clockwise to increase the clamping strength. Push the quick
release lever back to the CLOSE position.
Adjusting nut
If the clamping strength is adjusted too strong and the quick release lever
cannot be pushed to the CLOSE position, turn the adjusting nut in a
counter-clockwise direction to reduce the clamping strength. When doing
this, do not fully release the adjuster nut. Turn it 1/8 of a revolution, and
then try to push the lever to CLOSE, to set the maximum clamping
strength with which you can push the quick release lever to the
CLOSE position.
Turn 1/8 revolution
at a time
Products are not guaranteed against natural wear and deterioration from
normal use and aging.
For maximum performance we highly recommend Shimano lubricants and
maintenance products.
Regular inspections before riding the bicycle
Before riding the bicycle, check the following items. If any problems are
found with the following items, contact the place of purchase or a bicycle
dealer.
Are the wheels fi xed?
Do the wheels rotate smoothly?
Are there any abnormal noises?
Names of parts
Quick release lever
Rear freehub
Rear freehub
What is a Quick Release?
It is a mechanism that uses a single quick release lever operation on the hub
to enable the wheel to be easily installed and removed.
Quick Release function
When the quick release lever is brought to the closed position, the lever nut
moves inward. The force of this clamps the wheel to the frame and holds the
wheel securely in place.
CLOSE position
Open position
Adjusting nut
Lever nut
Quick release lever
The clamping strength is adjusted by turning the adjusting nut. When the
nut is turned in a clockwise direction, the clamping strength increases, and
when the nut is turned in a counter-clockwise direction, the clamping
strength decreases.
Adjusting nut
Weaker
Stronger
Suitable dimensions of the rear end
Be sure to use only rear end widths with suitable dimensions.
Can not use fork thicknesses less than 5 mm.
(Dura-Ace, 600 Ultegra: not less than 6 mm.)
Operation
How to fasten this quick release hub
1. Move the quick release lever to the OPEN position and set the wheel so it
rmly touches the interior of the rear end (See sketch below).
OPEN position
OK No Good
2. Open and close the quick release lever with your right hand while
gradually tightening the adjusting nut with your left hand in the clockwise
direction. Continue tightening the nut until you feel resistance with your
hand at the point when the lever is parallel to the hub (as indicated by the
dotted position in the diagram on the right).
Adjusting nut
Quick release lever
3. Grip the rear end with your fi ngers and use the palm of your hand to close
the quick release lever with as much strength as possible. When closed, the
quick release lever must be in the "CLOSE" position shown below in the
diagram on the right. The side of the lever with the inscription "CLOSE"
must be facing away from the bicycle, and the lever should be parallel to
the rear end as shown below in the diagram on the left.
Tightening torque:
5 -7.5 N·m {43 -65 in. lbs.}
Rear end
Quick
release
lever
CLOSE position
Positioning of the quick release lever
For safety, the quick release lever should be along the bicycle frame when in
the CLOSE position.
Removing the wheel
Move the quick release lever from the CLOSE position to the OPEN position.
And then remove the wheel.
OPEN position


Produkt Specifikationer

Mærke: Shimano
Kategori: Ikke kategoriseret
Model: FH-5800

Har du brug for hjælp?

Hvis du har brug for hjælp til Shimano FH-5800 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Shimano Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Elektron

Elektron Overbridge Manual

26 November 2024
Elektron

Elektron Sidstation Manual

26 November 2024
SoundTube

SoundTube IPD-RS82-EZ Manual

26 November 2024
Kramer

Kramer 4x1VB Manual

26 November 2024
Kramer

Kramer RC-63A Manual

26 November 2024
SoundTube

SoundTube IPD-HP82-EZ Manual

26 November 2024
Kramer

Kramer RK-KVM-1U-PP3 Manual

26 November 2024
Gioteck

Gioteck VX-2 (PS3) Manual

26 November 2024