Shimano ST-R9270-L Manual

Shimano Ikke kategoriseret ST-R9270-L

Læs nedenfor 📖 manual på dansk for Shimano ST-R9270-L (3 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 10 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/3
UM-0MX0A-003-00 User's Manual
Dual Control Lever (DI2)
For Hydraulic Disc Brake
User's manuals in other languages are available at :
https://si.shimano.com
IMPORTANT NOTICE
• Contact the place of purchase or a distributor for information on
installation, adjustment, and replacement of the products which are
not found in the user's manual. The dealer's manual for professional
bicycle mechanics is available from our website(https://si.shimano.
com).
• Please observe the appropriate rules and regulations of the country,
state or region in which you conduct your business as a dealer.
For safety, be sure to read this “user's manual”
thoroughly before use, follow it for correct
use, and store it so that it can be referenced at
any time.
Important safety information
WARNING
• Because each bicycle may handle slightly differently depending on the
model, be sure to learn the proper braking technique (including brake
lever pressure and bicycle control characteristics) and operation of
your bicycle. Improper use of your bicycle's brake system may result in
a loss of control or a fall, which could lead to serious injury.
• Do not disassemble or modify the product. This may cause the product
to not operate correctly, and you may suddenly fall and be seriously
injured.
• Use only the battery specified. Using an incorrect battery may cause
the battery to burst or leak fluid, resulting in fire, injury, or
defacement in the surrounding area.
• Do not use the battery outside its operating temperature ranges. If
the battery is used or stored in temperatures which are outside these
ranges, fire, injury or problems with operation may occur.
• Do not throw or subject this product to strong shocks. If this is not
observed, bursting, overheating or problems with operation may
occur.
• Do not let grease adhere to the metal terminals. A conduction failure
may result.
• Do not use the battery if leakages, discoloration, deformation or any
other abnormalities occur. If this is not observed, bursting,
overheating or problems with operation may occur.
• If any leaked fluid gets on your skin or clothes, wash it off
immediately with clean water. The leaked fluid may damage your
skin.
• Store in a safe place out of the reach of small children to avoid letting
them swallow by mistake.
• Coin batteries are hazardous and must be kept away from
children. Never put batteries in mouth or in any part of
the body. Severe or fatal injuries can occur within 2 hours
if swallowed or placed inside the body. If this occurs or is
suspected, seek medical attention immediately.
• When operating the shifting switch, be careful not to allow your
fingers to be caught in the derailleur. The powerful motor which
drives the electronic gear shifting derailleur will operate without
stopping until the shifting position is reached.
• This hydraulic brake system has different braking characteristics from
those of the rim brake type, demonstrating relatively high braking
force at the beginning of braking (higher than the rim brake type);
familiarize yourself sufficiently with the braking characteristics before
using it. If you ride the bicycle without becoming sufficiently familiar
with the braking characteristics, braking may cause you to fall off the
bicycle, potentially causing serious injury or a fatal accident.
• Riders must become accustomed to the higher performance of this
brake before riding the bicycle. Using larger diameter disc brake
rotors provides a higher braking force than smaller diameter disc
brake rotors. If you ride the bicycle without becoming sufficiently
familiar with the braking characteristics, braking may cause you to fall
off the bicycle, potentially causing serious injury or a fatal accident.
• Please use extra caution to keep your fingers away
from the rotating disc brake rotor. The disc brake
rotor is sharp enough to inflict severe injury to
your fingers if caught within the openings of
moving rotor.
• Do not touch the calipers or disc brake rotor while riding or
immediately after dismounting from the bicycle. The calipers and disc
brake rotor will become hot when the brakes are operated, so you
may get burned if you touch them.
• Be careful not to allow any oil or grease to get onto the disc brake
rotor and brake pads. Riding the bicycle with oil or grease on the disc
brake rotor and brake pads may prevent the brakes from operating
and result in serious injury due to a fall or collision.
• Check the thickness of the brake pads and do not
use them if they have a thickness of 0.5 mm or less.
Doing so may prevent the brakes from operating
and result in serious injury.
2 m m 0 . 5 m m
• Do not use the disc brake rotor if it is cracked or deformed. The disc
brake rotor may break, and result in serious injury due to a fall.
• Do not use the disc brake rotor if its thickness is 1.5 mm or less. Also
do not use it if the aluminum surface becomes visible. The disc brake
rotor may break, and result in serious injury due to a fall.
• Do not continuously apply the brakes. Doing so may cause a sudden
increase in the brake lever stroke, preventing the brakes from
operating and resulting in serious injury.
• Do not use the brakes with fluid leaking. Doing so may prevent the
brakes from operating and result in serious injury.
• Do not apply the front brake too strongly. If you do so, the front
wheel may lock and the bicycle may fall forward, and serious injury
may result.
• Because the required braking distance will be longer during wet
weather, reduce your speed and apply the brakes early and gently.
You may fall or collide and be seriously injured.
• A wet road surface may cause tires to skid; to avoid this, reduce your
speed and apply the brakes early and gently. If the tires skid, you may
fall and be seriously injured.
• Do not use or leave the unit in hot and humid places such as where
the unit is exposed to direct sunlight, in a closed vehicle on a hot day,
or near a heater. If this is not observed, leakages of flammable liquid
or gas, overheating or bursting may cause fire, burns or other injury
to occur.
• Do not subject this product to extremely low air pressure. That may
result in an explosion of incorporated battery or the leakage of
flammable liquid or gas from it. Transporting this product by air is not
a problem.
• Observe all federal, state and local environmental regulations when
disposing of this product, because it has a built-in battery in addition
to its button battery. Disposal of this product into fire or a hot oven,
or mechanically crushing or cutting of it, can result in an explosion of
the built-in battery.
Built-in battery
CAUTION
Cautions on SHIMANO genuine mineral oil
• In the event of eye contact, flush with fresh water and seek medical
assistance immediately.
Contact with eyes may result in irritation.
• In the event of skin contact, wash well with soap and water.
Contact with eyes may result in irritation.
• Cover nose and mouth with a respirator type mask and use in a well
ventilated area. Inhalation of mineral oil mist or vapors may cause
nausea.
• If mineral oil mist or vapor is inhaled, go immediately to an area with
fresh air. Cover up with a blanket. Stay warm and stable and seek
professional medical advice.
Burn-in period
• Disc brakes have a burn-in period, and the braking force will gradually
increase as the burn-in period progresses. Make sure that you are
aware of any such increases in braking force when using the brakes
during the burn-in period. The same thing will happen when the
brake pads or disc brake rotor are replaced.
Notice
• To prevent noise and ensure the best performance, perform the
burn-in procedure after replacing the brake pads or disc brake rotor.
• Be sure to rotate the crank when carrying out switch operations which
are related to gear shifting.
• You can use E-TUBE PROJECT to update the software for the hood
button. Please contact your place of purchase for details.
• The components are designed to be fully waterproofed to withstand
wet weather riding conditions; however, do not deliberately place
them into water.
• Do not clean the bicycle with a high-pressure washer. If water gets
into any of the components, operating problems or rusting may result.
• Handle the components carefully, and avoid subjecting them to strong
shock.
• Be careful not to get water into the E-TUBE ports and the satellite
shifter connection port.
• Do not use thinners or strong solvents to clean the products. Such
substances may damage the surfaces.
• In the case of carbon levers, wash them with a soft cloth using a
neutral detergent. Otherwise, the material may be damaged and lose
strength.
• Avoid leaving the carbon levers in places where high temperatures are
present. Also keep them well away from fire.
• When the bicycle wheel has been removed, it is recommended that
pad spacers are installed. Do not depress the brake lever while the
wheel is removed. If the brake lever is depressed without the pad
spacers installed, the pistons will protrude further than normal. If that
happens, consult a place of purchase.
• Use soapy water or a dry cloth when cleaning and carrying out
maintenance of the brake system. Do not use commercially available
brake cleaners or silencing agents. Such substances can cause damage
to parts such as seals.
• Contact the place of purchase for updates to the component software.
The most up-to-date information is available on the SHIMANO
website.
• Also read the manuals for other connected components together with
the manual for the brakes.
• Be sure to attach dummy plugs to any unused E-TUBE ports and the
satellite shifter connection port. If water gets into any of the
components, operating problems or rusting may result.
• The electric wire has small waterproof connectors, so do not
repeatedly connect and disconnect it too often. It may impair the
function.
• Regarding 2.4 GHz digital wireless
This product adopts digital communication technologies in the 2.4
GHz frequency, which is used for wireless LAN, etc.
It may receive interference in the following locations or environments
that prevents wireless communication from being performed correctly.
* Near a device such as a television, computer, radio, motor, or
microwave oven, or inside an automobile or railway car
* Near a railway crossing or railway track, television transmitting
station, or radar base, etc.
* When using the product in combination with another cordless
device or some lights
• About the button battery
* Insert the battery with the correct +/- orientation.
* Remove the battery if you do not use it for a long period.
* When the battery is depleted, remove it immediately.
• Store this product or the bicycle with this product installed in a cool
indoor location away from direct sunlight and rain (estimate: 10 to
20°C).
If the storage temperature is low or high, the performance of the
button battery is reduced, and its usable time will be shorter.
When using after a long period of non-use, be sure to replace the
button battery with a new one.
• Products are not guaranteed against natural wear and deterioration
from normal use and aging.
• For maximum performance we highly recommend SHIMANO
lubricants and maintenance products.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that
may cause undesired operation.
Regular inspections before riding the
bicycle
Before riding the bicycle, check the following items. If any problems are
found, consult your place of purchase or a distributor.
• Are there any signs of brake oil leakage?
• Do the front and rear brakes work correctly?
• Do the pads have a thickness of 0.5 mm or more?
• Is the disc brake rotor cracked or deformed?
• Does gear shifting occur when the shifting switches are operated?
• Are the levers securely installed to the handlebar?
• Do any abnormal noises occur during operation?
• Is there sufficient charge remaining in the battery?

Produkt Specifikationer

Mærke: Shimano
Kategori: Ikke kategoriseret
Model: ST-R9270-L

Har du brug for hjælp?

Hvis du har brug for hjælp til Shimano ST-R9270-L stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Shimano Manualer

Shimano

Shimano BR-M8120 Manual

7 Oktober 2024
Shimano

Shimano SL-RV400-6R Manual

7 Oktober 2024
Shimano

Shimano SL-RV300-6R Manual

6 Oktober 2024
Shimano

Shimano ST-2400-R Manual

6 Oktober 2024
Shimano

Shimano CN-HG901-11 Manual

6 Oktober 2024
Shimano

Shimano DH-T785 Manual

4 Oktober 2024
Shimano

Shimano CLARIS 2400 ST-R240-R Manual

1 Oktober 2024
Shimano

Shimano SL-RV300-7R Manual

1 Oktober 2024
Shimano

Shimano SL-RV400-LN Manual

1 Oktober 2024
Shimano

Shimano SL-RV400-7R Manual

1 Oktober 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Gigabyte

Gigabyte ODIN GT 550W Manual

23 November 2024
Vitec

Vitec MGW Diamond-HX OG Manual

23 November 2024
Stamos

Stamos SWG-PTABLE-100PCT Manual

23 November 2024
Stamos

Stamos S-PLASMA 60U Manual

23 November 2024
Velbus

Velbus VMBPIRO-W-20 Manual

23 November 2024
Honor

Honor 90 Pro Manual

23 November 2024
Honor

Honor 80 SE Manual

23 November 2024
Medela

Medela Safe & Dry Manual

22 November 2024
Stamos

Stamos S-PLASMA 70-IGBT Manual

22 November 2024
Jane

Jane First Potty Manual

22 November 2024