Shimano WH-R9270-C60-HR-TL-R Manual

Shimano Ikke kategoriseret WH-R9270-C60-HR-TL-R

Læs nedenfor 📖 manual på dansk for Shimano WH-R9270-C60-HR-TL-R (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 4 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
Wheel Set (for Disc
Brake)
IMPORTANT NOTICE
Contact the place of purchase or a distributor for information on
installation, adjustment, and replacement of the products which are not
found in the user's manual. A dealer's manual for professional and
experienced bicycle mechanics is available on our website (https://si.
shimano.com).
For safety, be sure to read this “user's manual”
thoroughly before use, follow it for correct use, and
store it so that it can be referenced at any time.
The following instructions must be observed at all times in order to
prevent personal injury and physical damage to equipment and
surroundings. The instructions are classified according to the degree of
danger or damage which may occur if the product is used incorrectly.
DANGER Failure to follow the instructions will result
in death or serious injury.
WARNING Failure to follow the instructions could
result in death or serious injury.
CAUTION
Failure to follow the instructions could
cause personal injury or physical damage
to equipment and surroundings.
Important safety information
WARNING
Do not disassemble or modify the product. This may cause the product
to not operate correctly, and you may suddenly fall and be seriously
injured.
Check that the wheels are fastened securely before riding the
bicycle. Using the axle release lever incorrectly may cause the
wheel to fall off, etc. and lead to serious injury due to a fall.
Use the appropriate air pressure indicated on the tire and rim. If the
maximum pressures indicated on the tires and rims differ, be sure not to
exceed the maximum pressure with the lower value. A higher pressure
than indicated can cause a sudden puncture and/or sudden release of
the tire, which can result in serious injury.
WH-R9270-TL / WH-R8170-TL / WH-RS710-TL: Maximum pressure = 7.5
bar / 109 psi / 750 kPa
WH-R9170-TL / WH-RS770-TL: Maximum pressure = 8 bar / 116 psi / 800
kPa
WH-RS370-TL: Maximum pressure = 6.5 bar / 94 psi / 650 kPa
WH-RX870-TL / WH-RX570-TL: Maximum pressure = 5 bar / 72 psi / 500
kPa
Before riding the bicycle, check the wheels to make sure that there are
no bent or loose spokes, dents, scratches or cracks on the rim surface.
Do not use the wheel if any of these problems are found. The wheel
may break, and you may fall. Check also that there is no carbon
separation or cracking.
Do not use the Road Wheel Set on unpaved surfaces. The Road Wheel
Set is designed for paved surfaces. If the wheels are used on unpaved
surfaces, they may become bent or damaged, and accidents may result.
Do not use the gravel/adventure wheel set in harsh conditions such as
on rough roads. Do not use for downhill bicycle riding or freeriding, etc.
otherwise the wheel may become bent or otherwise damaged if it is
subjected to a strong impact, and accidents may occur as a result.
Do not use with rim brakes. These wheels are designed exclusively for
use with disc brakes. Using these wheels with rim brakes could damage
the rims and result in an accident that can lead to a serious injury or
even death.
Confirm that the axle release lever does not
interfere with the disc brake rotor even when it is
fully engaged. The axle release lever may interfere
with the disc brake rotor if it is on the disc brake
rotor side, which is dangerous. If the axle release
lever interferes with the disc brake rotor,
immediately stop use and contact the place of
purchase or a distributor.
Axle release lever
Disc brake rotor
For details on the E-THRU axle, refer to the E-THRU axle user's manual.
The tires should be installed and removed by hand. If this is difficult, a
resin tire lever for tubeless wheels may be used. In such cases, be sure to
check that the rim surface has not been dented, scratched, or cracked as
there is a risk of causing damage to the air seal between the tire and
the rim, which would result in air leakage. Also, check that there is no
carbon separation or cracking, etc. Finally, make sure that there is no air
leakage.
F12 (front 12 mm axle), R12 (rear 12 mm axle) wheel (thru axle)
This wheel can only be used in combination with the special front fork/
frame and the through axle. If it is used in combination with any other
front fork/frame or through axle, it may cause the wheel to become
detached from the bicycle during riding and result in serious bodily
injury.
CAUTION
Note that a higher rim is more easily affected by the wind and makes
riding unstable.
Bed-in period
Disc brakes have a bed-in period, and the braking force will gradually
increase as the bed-in period progresses. Accidents or falls may occur
due to losing control of the bicycle, possibly resulting in serious injury.
The same thing will happen when the brake pads or disc brake rotor
are replaced.
Notice
For the use of the supplied nipple wrench tool, contact your place of
purchase or a distributor for their assistance.
Special nipple wrenches are available as optional accessories.
Do not lubricate the internal parts of the hub. Otherwise, grease will
flow out.
It is recommended that you ask a place of purchase to adjust the spoke
tensions if there is any deviation in the spokes and after the first 1,000
km of riding.
Do not use detergent or other chemicals when wiping the wheel,
otherwise, the sticker on the rim may come off.
Be sure to also read the manual for the disc brakes.
Products are not guaranteed against natural wear and deterioration
from normal use and aging.
For maximum performance we highly recommend SHIMANO lubricants
and maintenance products.
Regular inspections before riding the bicycle
Before riding the bicycle, check the following items. If any problems are
found, consult your place of purchase or a distributor.
Are the spokes broken or loose?
Is the rim surface dented, damaged, or cracked?
Are the wheels secure?
Are there any signs of brake oil leakage?
Do the pads have a thickness of 0.5 mm or more?
Is the disc brake rotor cracked or deformed?
Is it hard to rotate the wheels?
Is abnormal noise emitted from the wheels?
Names of parts
Brake hose
Caliper
Disc brake rotor
Valve hole
Spoke
E-THRU/through axle
Axle release lever
Freehub
Front hub Rim surface
Brake hose
Caliper
Disc brake rotor
Brake pad
UM-0AN0A-005 User's Manual
Please note: specifications are subject to change for improvement without notice. (English)
© Oct. 2021 by SHIMANO INC. ITP
One Holland, Irvine, California 92618, U.S.A. Phone: +1-949-951-5003
High Tech Campus 92, 5656 AG Eindhoven, The Netherlands Phone: +31-402-612222
3-77 Oimatsu-cho, Sakai-ku, Sakai City, Osaka 590-8577, Japan


Produkt Specifikationer

Mærke: Shimano
Kategori: Ikke kategoriseret
Model: WH-R9270-C60-HR-TL-R

Har du brug for hjælp?

Hvis du har brug for hjælp til Shimano WH-R9270-C60-HR-TL-R stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Shimano Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Smeg

Smeg KIT6PX Manual

23 December 2024
Smeg

Smeg KIT6CX Manual

23 December 2024
Smeg

Smeg GTA-6 Manual

23 December 2024