Sigma 50mm f3.5-5.6 DC 18 Manual

Sigma Linse 50mm f3.5-5.6 DC 18

Læs nedenfor 📖 manual på dansk for Sigma 50mm f3.5-5.6 DC 18 (1 sider) i kategorien Linse. Denne guide var nyttig for 6 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
Thank you very much for purchasing a Sigma Lens. In order to get the maximum
performance and enjoyment out of your Sigma lens, please read this instruction booklet
thoroughly before you start to use the lens.
DESCRIPTION OF THE PARTS (fig.1)
Filter Attachment Thread
Focus Ring
Distance Scale
Focus Index Line
Zoom Ring
Focus Mode Switch (SIGMA / CANON AF / NIKON ) SA / FOUR THIRDS
Mount
Lens Hood
DC LENS
These are special lenses that are designated for digital cameras because the lens image
circle is designated to correspond to the size of the image sensors of most digital SLR
cameras. The specialized design gives these lenses the ideal properties for digital cameras.
An image sensor element larger than those corresponding to APS C cannot be used in -
digital cameras or 35mm SLR cameras. If such an element is used vignetting will occur
on the picture surface.
If you use SD / SD914 / SD10 digital cameras, corresponding angle of view will be
30 85- mm.
ATTACHING TO CAMERA BODY
When this lens is attached to the camera body it will automatically function in the same way
as your normal lens. Please refer to the instruction booklet for your camera body.
On the lens mount surface, there are a number of couplers and electrical contacts.
Please keep them clean to ensure proper connection. To avoid damaging the lens, be
especially sure to place the lens with its front end down while changing the lens.
Many accessories such as rear mounted teleconverters, extension tubes, etc., are
specially made for designated lenses. Before you purchase such accessories, please
check your Sigma lens to determine that it is compatible and that the accessories will
function properly with it.
SETTING THE EXPOSURE MODE
The sigma lens functions automatically after mounting to your camera. Please, refer to the
camera instruction book.
FOCUSING AND ZOOMING
SIGMA AF and CANON AF
For autofocus operation, set the focus mode switch on the lens to ” position (fig.2). If the AF
you wish to focus manually, set the focus mode switch on the lens to the Mposition. You
can adjust the focus by turning the focus rin g.
NIKON AF and FOUR THIRDS
For autofocus operation, set the camera to AF mode and set the focus mode switch on the
lens to the AF position (fig.2). If you wish to focus manually, set the focus mode switch on
the lens to the position. You can adjus Mt the focus by turning the focus ring. (In the case
of Four-Thirds cameras it is necessary to switch the camera to MF mode as well)
SONY AF and PENTAX AF
For autofocus operation, set the camera’s focus mode to AF. If you wish to focus manually,
set the camera’s focus mode to “M” and adjust the focus by turning the focus ring.
Please refer to camera’s instruction manual for ’s details on changing the camera
focusing mode.
The viewfinder of some Nikon AF cameras have indicators to display the focus status.
The symbol indicates that correct focus has been set, indicates that focus is
set in front of the subject, and indicates that focus is set behind the subject. When
this AF lens is used with Nikon AF cameras in MF mode, please adjust the lens’ focus
until the symbol is visible.
To avoid damaging AF , please do not turn the focus ring manually while in mechanism
the autofocus mode.
When operating this lens in manual focus mode, it is recommended that correct focus be
confirmed visually in the viewfinder rather than relying on the distance scale. This is
due to possible focus shift resulting from extreme changes in which cause temperature
various components in the lens to expand and contact. Special allowance is made for
this at the infinity settin g.
In the case of Four Thirds lenses, t S mode with MF override ishe function of AF- not
available.
Zooming
Rotate the Rubber grip on the zoom ring to the desired position.
LENS HOOD
A bayonet type detachable hood is provided with the lens. This lens hood helps to prevent
flare and ghosted images caused by bright illumination from outside the picture area.
Attach the hood and turn clockwise until it stops rotation. (fig.3)
When taking photographs using the built-in flash, it is advisable to remove the lens hood
so as to avoid cutting o any of the ash output, which could cause a shadow in the
picture.
In order to place the lens and hood into the storage case, you must first remove the
hood, then replace it on the lens in the reverse position. (fig.4)
FILTER
When mounting or removing the filter, the lens should be in the manual focus mode, and
should be held by the front of the lens barrel in order to avoid damaging the lens and
camera (fig.5).
Only one filter should be used at the time. Two or more lters and/or special thicker
filters, like a polarizing filter, may cause vignetting.
When us ngi polarizing filter with AF camera, use the “a circular” type.
BASIC CARE AND STORAGE
Avoid any shocks or exposure to extreme high or low temperatures or to humidity.
For extended storage, choose a cool and dry place, preferably with good ventilation. To
avoid damage to the lens coating, keep away from mothballs or naphthalene gas.
Do not use thinner, benzine or other organic cleaning agents to remove dirt or finger
prints from the lens elements. Clean by using a soft, moistened lens cloth or lens
tissue.
This lens is not waterproof. When you use the lens in the rain or near water, keep it
from getting wet. It is often impractical to repair the internal mechanism, lens elements
and electric components damaged by water.
Sudden temperature changes may cause condensation or fog to appear on the surface
of the lens. When entering a warm room from the cold outdoors, it is advisable to keep
the lens in the case until the temperature of the lens approaches room temperature.
TECHNICAL SPECIFICATIONS
Lens construction 8 - 8
Angle of View 69.3 27.9 °
Minimum Aperture 22
Minimum Focusing Distance 25cm (0.82 ft)
Magnification 1:3.5
Filter Size mm 58
Dimensions D L mm ( ) ia.×ength 67.5×62 2.66×2.44 in
Weight ( ) 250g 8.8 oz
Dimensions and weight include the SIGMA . mount
The CE Mark is a Directive conformity mark of the European
Community (EC).
SIGMA (Deutschland) GmbH
Carl- -Zeiss Str. 10/2, D-63322 Rödermark, F.R.GERMANY
Verkauf 01805 01805: -90 90 85-0 Service: -90 90 85- - - 85 Fax: 01805 90 90 85 35
ENGLISH


Produkt Specifikationer

Mærke: Sigma
Kategori: Linse
Model: 50mm f3.5-5.6 DC 18

Har du brug for hjælp?

Hvis du har brug for hjælp til Sigma 50mm f3.5-5.6 DC 18 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Linse Sigma Manualer

Linse Manualer

Nyeste Linse Manualer