Speakman SR-5000-E2 Manual

Speakman Brusehoved SR-5000-E2

Læs nedenfor 📖 manual på dansk for Speakman SR-5000-E2 (2 sider) i kategorien Brusehoved. Denne guide var nyttig for 5 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
800-537-2107 www.speakman.com
NEED HELP?
For additional assistance or service please contact: 92-SR-5000-01
SR-5000 SERIES
INSTALLATION INSTRUCTIONS
Exhilaration Shower Head
TOOLS & SUPPLIES NEEDED
Thread Seal Tape
(INCLUDED)
Adjustable
Wrench
IMPORTANT
MAINTENANCE
SAFETY TIPS:
Be sure to read and understand all instructions
before beginning installation.
Inspect all connections after installation.
Cover the drain to avoid loss of parts.
Be sure to wear proper eye protection.
Do NOT over tighten any connections or damage
may occur.
Shut OFF water supplies before beginning
installation.
Observe all local plumbing and building codes.
Periodic cleaning using a mild soap and warm
water will help keep your Shower head's
appearance in its original condition.
For best results, dry immediately with a soft, clean
cloth. DO NOT USE harsh and/or abrasive
cleaners.
To help restore the finish, occasionally apply a
non-abrasive wax to your showerhead body (follow
manufacturers’ instructions).
On CHROME PLATED SHOWER HEADS, a two
(2) part white vinegar, one (1) part water solution
can be used to break down excessive mineral
deposits on the sprays. Let the showerhead soak in
the solution for about ½ hour then rinse thoroughly.
Brush off any remaining mineral deposits if
necessary.
DO NOT USE the vinegar/water treatment on any
finish other than Chrome.
APPLY THREAD SEAL TAPE
1Apply the included Thread Seal Tape to the
outlet side of shower arm in a clockwise
direction.
INSTALL SHOWER HEAD
2Thread Shower Head onto shower arm by
turning it in a clockwise direction. Tighten with
Adjustable Wrench. Turn water supply on and
check for leaks.
ADJUST SPRAY PATTERN
3Adjust spray pattern by rotating the spray
face using the tab shown below.
Model: -E175SR-5000
Max. Flow Rate: 1.75 gpm (6.6 L/min)
Min. Flow Rate: 1.3 gpm (4.9 L/min) @ 45psi
FOR USE WITH AUTOMATIC COMPENSATING VALVES RATED AT
4.9 L/MIN (1.3 GPM) OR LESS.
Model: SR-5000-E2
Max. Flow Rate: 2.0 gpm (7.6 L/min)
Min. Flow Rate: 1.4 gpm (5.3 L/min) @ 45psi
FOR USE WITH AUTOMATIC COMPENSATING VALVES RATED AT
5.3 L/MIN (1.4 GPM) OR LESS.
ROUGH IN DIAGRAM


Produkt Specifikationer

Mærke: Speakman
Kategori: Brusehoved
Model: SR-5000-E2

Har du brug for hjælp?

Hvis du har brug for hjælp til Speakman SR-5000-E2 stil et spørgsmål nedenfor, og andre brugere vil svare dig