Special-T Disco DISC-3030 Manual


Læs nedenfor 📖 manual på dansk for Special-T Disco DISC-3030 (1 sider) i kategorien niet gecategoriseerd. Denne guide var nyttig for 3 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/1
Parts Included:
1. Column 3. Hardware:
Bolts (3)
Washers (3)
Screws (8)
2. Floor plate
Disco Table Assembly Instructions(C4-PLP Base)
If you are missing parts or
have any questions, please
call Customer Service at
888-705-0777.
Tolls Needed:
13mm rachet wrench or impact drill
3/8” hex bit
13mm socket
#3 Phillips bit
Safety glasses
Instructions
Base Assembly
1. To assemble the base, set mounting plate on the floor
with the bottom of the column pointing upward. Place
the floor plate over the column aligning holes in the floor
plate in inside the column. Insert (3) hex head bolts with
washers inside them and start them by hand.
2. Use impact drill to tight nut as much as possible.
Table Assembly
1. Lay table top upside down on cardboard or carpeted
surface.
2. Position column on the top and align holes in mounting
plate with pre-drilled holes in the top. Use wood screws
to attach the top. Use every hole in the mounting plate.
3. Holding onto the edges of the top, carefully turn the
table over in the upright position. Enjoy your table!
09.2014
START BOLTS BY HAND TO PREVENT
CROSS THREADING
678-879-0777: phone www.specialT.net 678-456-6046: fax


Produkt Specifikationer

Mærke: Special-T
Kategori: niet gecategoriseerd
Model: Disco DISC-3030

Har du brug for hjælp?

Hvis du har brug for hjælp til Special-T Disco DISC-3030 stil et spørgsmål nedenfor, og andre brugere vil svare dig




niet gecategoriseerd Special-T Manualer

niet gecategoriseerd Manualer

Nyeste niet gecategoriseerd Manualer