Special-T Sienna SIEN-3030 Manual

Special-T Tafel Sienna SIEN-3030

Læs nedenfor 📖 manual på dansk for Special-T Sienna SIEN-3030 (5 sider) i kategorien Tafel. Denne guide var nyttig for 10 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/5
Parts Included:
1. Top Plate
2. Column
3. Floor Plate
4. Hardware:
Hex Head Flat Head Washer (3) Hex Wrench (1) Hex Key (1)
Bolts (3) Bolts (4)
Instructions
You will need 2 people to assemble this base.
Base Assembly
1. Place mounting plate on one end of a column. Insert
lock washers inside the hex head bolts. Start 3 hex head
bolts with lock washers inside by hand first, then tighten
with a hex wrench.
2. Turn the column over and place mounting plate on the
floor. Carefully place center of the floor plate over the
column, and align the holes. Use the remaining 4 flat
head bolts to secure the column. Tighten the bolts with
the hex key.
Table Assembly
1. Lay table top upside down on cardboard or carpeted
surface.
2. Position assembled base(s) in the center of the table
top or align holes in mounting plate(s) with pre-drilled
holes in the top. Use wood screws to attach the top.
Use every hole in the mounting plate(s).
3. Holding onto the edges of the top, carefully turn the
table over in the upright position.
4. Use stainless steel cleaner and soft cloth to remove
finger prints or stains from the base. Enjoy your table!
09.2014
Round and Square Bases (Sienna Table) Assembly Instructions
Base Assembly
Table Assembly
If you are missing parts or
have any questions, please
call Customer Service at
888-705-0777.
ATTENTION: Due to sensitive nature of the stainless
steel, use extreme care when assembling a base to
avoid accidental dents and scratches.
678-879-0777: phone www.specialT.net 678-456-6046: fax


Produkt Specifikationer

Mærke: Special-T
Kategori: Tafel
Model: Sienna SIEN-3030

Har du brug for hjælp?

Hvis du har brug for hjælp til Special-T Sienna SIEN-3030 stil et spørgsmål nedenfor, og andre brugere vil svare dig