Speco Technologies SP6OCT Manual

Speco Technologies Højttaler SP6OCT

Læs nedenfor 📖 manual på dansk for Speco Technologies SP6OCT (1 sider) i kategorien Højttaler. Denne guide var nyttig for 4 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/1

SP6OCT 70V 6.5” Weather-Resistant In-ceiling Speaker with Backcan and Transformer

Thank you for your purchase of Speco Technologies SP6OCT. This speaker is constructed to meet the IP66 rating, so it can be used in outdoor or humid environments. All

Speco Technologies’ outdoor speakers come with a 5-YEAR warranty against manufacturing defects, so you can be confident in your choice of product.

INSTALLATION INSTRUCTIONS:

1) For optimal installation, this speaker should be used with the Speco

Technologies accessories indicated to the right.

2) Cut an 8.2” diameter hole in your ceiling or ceiling tile.

3) This assembly requires at least 6.5” clearance from the entry point to

the top of ceiling.

4) Install all products in the order shown.

5) This speaker has a transformer dial. Select the power setting you’d

like for this speaker. It will be easier to select your power before

installing the speaker.

6) To install the speaker, you must remove the magnetic grille.

7) Once the grille is off, turn all the L-brackets so that they are locked

facing in, and put the speaker into your cutout and mounting

bracket. Once through, turn all the L-brackets again so that they

are facing out, and using a Phillips screwdriver, turn each of the four

until they clamp the bracket and ceiling tile securely.

8) There are a brown and a blue wire coming out of the speaker. The

brown wire is the (+) positive wire. Wire this lead to the positive wire

running from your amplifier.

9) The blue wire is the (-) negative wire. Wire this to the negative lead

from your amplifier.

10) IMPORTANT: Ensure the total power of all wattage taps selected on

all speakers running from this amplifier does not exceed 80% of the

rated power of the amplifier. (e.g., if the amp rated power is 100W,

do not put more than 80W of speakers on it). Speco Technologies

is NOT responsible for damage to equipment due to improper

installation.

11) IMPORTANT: Ensure you are wiring the proper voltage. Only use 70V taps with a 70V amplifier. Speco Technologies is NOT responsible for damage to equipment

due to improper installation.