Speco Technologies SRH20 Manual

Speco Technologies Højttaler SRH20

Læs nedenfor 📖 manual på dansk for Speco Technologies SRH20 (2 sider) i kategorien Højttaler. Denne guide var nyttig for 10 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

SRD100 100W Speaker Horn Driver + Horn Casing SRH20

IMPORTANT NOTES

Before connecting and using this product, please read this instruction manual carefully and keep it on hand for future reference. The manual is to be

considered an integral part of this product and must accompany it if ownership changes, to serve as a reference for correct installation and use as well

as for the safety precautions.

Any incorrect installation or use of this product will void the warranty.

WARNING

Contact your Speco Technologies technical support should any of the following occur:

the Driver Unit does not function (or works in an anomalous way).

the cable has been damaged.

objects or liquids have gotten into the Driver Unit.

the Driver Unit has been damaged due to impact or fire.

SAFETY PRECAUTIONS

1. All precautions, in particular the safety ones, must be read with special attention, as they provide important information.

2. Make sure all connections have been made correctly and the Driver Unit input voltage (in a constant voltage system) or its impedance is suitable for

the amplifier output.

3. Never attempt to carry out any operations, modifications or repairs that are not expressly described in this manual.

4. Driver Unit lines (i.e., speaker wire) can sometimes have sufficiently high voltage (i.e. 100 V) to involve a risk of electrical shock: never install or

connect this Driver Unit when the line is powered.

5. Protect connected speaker wire from damage; make sure it is positioned in a way that it cannot be stepped on or crushed by objects.

6. Should the Driver Unit emit any strange odors or smoke, turn the amplifier off and disconnect the driver from the speaker wire.

7. Make sure that no objects or liquids can get into this product as this may cause a short circuit.

8. To prevent inductive effects from causing hum, noise and poor performance, speaker wire should not be laid together with other electric cables

(mains), microphone cables or line level signal cables connected to amplifier inputs.

9. Strongly recommend this product is only installed by professional qualified installers or specialized firms who can ensure a correct installation and

certify it is installed according to local regulations.

10. WARNING: Do not install the speaker close to the listening area. Exposure to high sound levels can cause permanent hearing loss. The acoustic

pressure level that leads to hearing loss is different from person to person and depends on the duration of exposure. To prevent potentially dangerous

exposure to high levels of acoustic pressure, anyone who is exposed to these levels should use adequate protection devices. When a transducer

capable of producing high sound levels is being used, it is necessary to wear ear plugs or protective earphones.

11. Do not connect this product to any equipment or accessories other than that for which it is intended (i.e., commercial amplifiers).

CAUTION

Install this Driver Unit far from any heat source.

Do not overload this product for extended periods of time.

If the Driver Unit is used in particularly cold places, drive it with a low signal for 5-10 minutes to allow it to warm up before using it maximum power.

Do not use solvents, alcohol, benzene or other volatile substances for cleaning the external parts of this product.

APPLICATION

This unit is intended for use with Speco Technologies SRH20 Horn Casing. When used in conjunction with a casing, driver units can be easily aimed to