Square Jellyfish Micro Ball Head Manual

Square Jellyfish Kamerastativ Micro Ball Head

Læs nedenfor 📖 manual på dansk for Square Jellyfish Micro Ball Head (2 sider) i kategorien Kamerastativ. Denne guide var nyttig for 18 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
www.squarejellysh.com
Designed in USA. Made in China. Patent pending.
Thank you for purchasing the Square Jellysh Micro Ball Head. This product is
designed for use with pocket cameras to add camera angle exibility to a tripod.
You will need two things:
A camera weighing up to 9 oz. with a tripod screw mount.
• A tripod with a 1/4 x 20 standard camera thread screw. Alternatively, the
Square Jellysh Pocket Tripod may be also be used.
Set up in two
simple steps:
• Gently
thumb-tighten
the screw of the
Micro Ball Head
onto the screw
mount of your
pocket camera.
• Gently
thumb-tighten
the base of the
Micro Ball
Head onto
thread screw
of your tripod.
Position your camera
Once set-up is complete, you
can then position your camera
in a broad range or angles. The
built-in tension of the Ball Head
holds your camera rmly in place.
If desired, a small screwdriver
can be used to adjust the tension
looser or tighter by slightly turning
the recessed set-screw at the
bottom of the Micro Ball Head.
Use common sense
• Do not place your camera where it can easily fall a distance that would cause
damage to your camera.
• This product contains small parts that may be a chocking hazard. Keep out
of reach of children.
Micro Ball Head shown with
conventional tripod
Micro Ball Head shown with
Square Jellysh Pocket Tripod
SQUARE JELLYFISH MICRO BALL HEAD USER’S MANUAL


Produkt Specifikationer

Mærke: Square Jellyfish
Kategori: Kamerastativ
Model: Micro Ball Head

Har du brug for hjælp?

Hvis du har brug for hjælp til Square Jellyfish Micro Ball Head stil et spørgsmål nedenfor, og andre brugere vil svare dig




Kamerastativ Square Jellyfish Manualer

Kamerastativ Manualer

Nyeste Kamerastativ Manualer