Sunbeam XpressHeat Heating Pad 2013 Manual

Sunbeam Elektrisk tæppe XpressHeat Heating Pad 2013

Læs nedenfor 📖 manual på dansk for Sunbeam XpressHeat Heating Pad 2013 (2 sider) i kategorien Elektrisk tæppe. Denne guide var nyttig for 19 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
XpressHeat Heating Pad
IMPORTANT SAFETY INSTRUCTIONS
DO NOT DESTROY
DANGER: TO REDUCE RISKS OF BURNS, ELECTRIC SHOCK, FIRE, AND PERSONAL
INJURY, THIS PRODUCT MUST BE USED IN ACCORDANCE WITH THE FOLLOWING
INSTRUCTIONS:
1. READ ALL INSTRUCTIONS.
2. DO NOT USE WHILE SLEEPING.
3. DO NOT USE ON AN INFANT OR ON AN ANIMAL.
4. THIS PAD IS NOT TO BE USED ON OR BY AN INVALID, A SLEEPING
OR UNCONSCIOUS PERSON, A PERSON WITH DIABETES,
OR A PERSON WITH POOR BLOOD CIRCULATION.
5. DO NOT USE ON AREAS OF INSENSITIVE SKIN.
6. BURNS CAN OCCUR REGARDLESS OF CONTROL SETTING.
CHECK SKIN UNDER PAD FREQUENTLY.
7. DO NOT USE IN AN OXYGEN ATMOSPHERE.
8. DO NOT USE PINS OR OTHER METALLIC MEANS
TO FASTEN THIS PAD IN PLACE.
9. DO NOT BUNCH, SIT ON OR AGAINST OR CRUSH PAD-AVOID SHARP FOLDS.
10. NEVER PULL THIS PAD BY THE SUPPLY CORD.
11. DO NOT USE THE CORD AS A HANDLE.
12. THIS UNIT SHOULD NOT BE USED BY CHILDREN
WITHOUT ADULT SUPERVISION.
13. PLACE PAD ON TOP OF AND NOT UNDER THE
PART OF THE BODY NEEDING HEAT.
14. USE THIS PAD ONLY ON A 110-120 VOLT AC
CIRCUIT. UNPLUG WHEN NOT IN USE.
15. DO NOT TAMPER WITH THIS PAD IN ANY WAY.
16. THERE ARE NO USER-SERVICEABLE PARTS. IF FOR ANY
REASON THIS PAD DOES NOT FUNCTION SATISFACTORILY, SEE
WARRANTY FOR CONSUMER SERVICE INFORMATION.
17. DO NOT USE THIS PAD WITH LINIMENT, SALVE OR OINTMENT
PREPARATIONS, ESPECIALLY ONES THAT CONTAIN HEAT-
PRODUCING INGREDIENTS. SKIN BURNS COULD RESULT.
18. DO NOT BEND OR PINCH CORD AND DO NOT USE IF CORD IS DAMAGED.
19. NEVER LEAVE THE APPLIANCE UNATTENDED,
ESPECIALLY IF CHILDREN ARE PRESENT.
20. LOOP CORD LOOSELY WHEN STORING. TIGHT WRAPPING
MAY DAMAGE CORD AND INTERNAL PARTS.
21. WHEN NOT IN USE, STORE THE HEATING PAD IN THE
ORIGINAL PACKAGING, IN A DARK, COOL, DRY PLACE.
22. SAVE THESE INSTRUCTIONS.
HOW TO USE YOUR HEATING PAD
Make sure Control Connector is securely attached to the Pad
Connector (Figure 1). Push both parts together for a tight fit.
NOTE: control must be connected to heating
pad before plugging unit into outlet.
1. After control is connected to pad, plug
into 120V AC electrical outlet.
Your Sunbeam heating pad features XpressHeat. With this
unique fast-heat technology, you will feel heat in 30 seconds
– for faster pain relief!
2. To turn the pad on, press the Power Button. Then select
from 6 heat settings by scrolling to the desired setting
with HEAT or HEAT buttons. The light ring around the
controls, called the Heat Meter, will light up one
side at the time, indicating progress as the pad
heats up. All four sides of the Heat Meter will light
up within 30 seconds of powering up, indicating
that the heating pad is warm and ready for use.
3. To turn the pad OFF, press the Power
Button one more time. The heating pad and
lights of the Heat Meter will turn off.
4. DO NOT SIT ON OR AGAINST OR CRUSH
PAD – AVOID FOLDING DURING USE.
5. DO NOT USE WHILE SLEEPING.
6. SEE ADDITIONAL WARNINGS.
www.sunbeam.com

Sunbeam Products, Inc. doing business as Jarden Consumer Solutions or if in Canada, Sunbeam Corporation (Canada) Limited doing
business as Jarden Consumer Solutions (collectively “JCS”) warrants that for a period of five years from the date of purchase, this product
will be free from defects in material and workmanship. JCS, at its option, will repair or replace this product or any component of the product
found to be defective during the warranty period. Replacement will be made with a new or remanufactured product or component. If the
product is no longer available, replacement may be made with a similar product of equal or greater value. This is your exclusive warranty.
Do NOT attempt to repair or adjust any electrical or mechanical functions on this product. Doing so will void this warranty. This warranty
is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. Keep the original sales receipt. Proof
of purchase is required to obtain warranty performance. JCS dealers, service centers, or retail stores selling JCS products do not have the
right to alter, modify or any way change the terms and conditions of this warranty. This warranty does not cover normal wear of parts or
damage resulting from any of the following: negligent use or misuse of the product, use on improper voltage or current, use contrary to the
operating instructions, disassembly, repair or alteration by anyone other than JCS or an authorized JCS service center. Further, the warranty
does not cover: Acts of God, such as fire, flood, hurricanes and tornadoes.
What are the limits on JCS’s Liability?
JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or statutory warranty or
condition. Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular
purpose is limited in duration to the duration of the above warranty.
JCS disclaims all other warranties, conditions or representations, express, implied, statutory or otherwise. JCS shall not be liable for any
damages of any kind resulting from the purchase, use or misuse of, or inability to use the product including incidental, special, consequential
or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against purchaser
by any other party. Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages
or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you. This warranty gives you
specific legal rights, and you may also have other rights that vary from province to province, state to state or jurisdiction to jurisdiction.
How to Obtain Warranty Service
In the U.S.A. - If you have any question regarding this warranty or would like to obtain warranty service, please call 1-800-435-1250 and
a convenient service center address will be provided to you.
In Canada, - If you have any question regarding this warranty or would like to obtain warranty service, please call 1-800-667-8623 and a
convenient service center address will be provided to you.
In the U.S.A., this warranty is offered by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions located in Boca Raton,
Florida 33431. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions,
located at 20 B Hereford Street, Brampton, Ontario L6Y 0M1. If you have any other problem or claim in connection with this product, please
write our Consumer Service Department.
PLEASE DO NOT RETURN THIS PRODUCT TO ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE.
THIS APPLIANCE HAS A POLARIZED PLUG (ONE BLADE IS WIDER
THAN THE OTHER). TO REDUCE THE RISK OF ELECTRIC SHOCK, THIS
PLUG IS INTENDED TO FIT IN A POLARIZED OUTLET ONLY ONE WAY.
IF THE PLUG DOES NOT FIT FULLY IN THE OUTLET, REVERSE THE
PLUG. IF IT STILL DOES NOT FIT, CONTACT A QUALIFIED ELECTRICIAN
TO INSTALL THE PROPER OUTLET.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR
DEFEAT THIS SAFETY FEATURE IN ANY WAY.
WASHING INSTRUCTIONS
DO NOT DRY CLEAN! DO NOT BLEACH! DO NOT USE WRINGER FOR DETACHABLE PAD!
1. Disconnect pad from outlet.
2. Detach Pad Connector from the Control Connector.
3. Wash by hand or as follows in an automatic washer using slow agitation
and normal spin speed:
Fill washer with warm water. Add minimum amount
of all-purpose detergent, agitate to dissolve, measure heating pad before
washing. Add heating pad and soak five minutes. Agitate two minutes. Spin.
Fill for cool rinse, agitate one minute then spin. Dry in automatic dryer on high
heat, five minutes only, or line dry. Remove damp heating pad from dryer, block
to original size, and drape to finish drying. Do not iron your heating pad.
4. Do not plug in pad and pad connector until they are completely dry.
AUTO-OFF FEATURE
Your heating pad controller includes a selectable Auto-Off feature. By pressing the
Auto Off” button, you can set the timer to “Stay On” continuously or to shut down
after 2 hours of continuous use. NOTE: After a power outage, the Auto-Off feature
automatically resets the timer.
©2011 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Distributed by Sunbeam Products, Inc.
doing business as Jarden Consumer Solutions, Boca Raton, Florida 33431.
Printed in China. DW-052011 PN: 148112
USING MOIST HEAT THERAPY
In some cases, you may find that moist heat therapy provides
more comfort and relief. When using moist heat therapy, you
should protect furniture and clothing from becoming damp.
1. Dampen either side of the heating pad with water by patting
the surface with a wet sponge or cloth or use a spray
bottle to apply a fine mist. Do not thoroughly soak pad.
2. Do not spray or dampen the pad connector. (Figure 3)
DANGER: Do not immerse the pad or wiring in water or place under
running water. Failure to comply may result in product failure and/or personal injury.
NOTE: The electrical pad connector must be thoroughly dry before establishing
electrical connection.
Figure 3
Figure 1
A. Control Connector
B. Pad Connector
A
B
A
C
D
E
F
Figure 2
A. Display
B. Power Button
C. Auto Off Button
D. Auto Off Indicator
E. Heat Meter
F. Heat Setting
Buttons
B



Produkt Specifikationer

Mærke: Sunbeam
Kategori: Elektrisk tæppe
Model: XpressHeat Heating Pad 2013

Har du brug for hjælp?

Hvis du har brug for hjælp til Sunbeam XpressHeat Heating Pad 2013 stil et spørgsmål nedenfor, og andre brugere vil svare dig