Synco P2L Manual

Synco Ikke kategoriseret P2L

Læs nedenfor 📖 manual på dansk for Synco P2L (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 11 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF
Side 1/2
Thank you for choosing SYNCO product.
Please read this manual carefully before use and follow all instructions mentioned herein.
Microphone P2L User Manual
Caring For Your SYNCO Product
Package List
Product Instruction
Operations
Please keep the product in a dry, clean, dust-free environment.
Keep corrosive chemicals, liquids and heat source away from the product to prevent mechanics damage.
Use only a soft and dry cloth for cleaning the product.
Malfunction may be caused by dropping, impact of external force.
Do not attempt to disassemble the product. Doing so voids warranty.
Please have the product checked or repaired by authorized technicians if any malfunctions happened.
Failure to follow all the instructions may result in mechanics damage.
Warranty does not apply to human errors.
TX Transmitter x2
RX Receiver (Lightning
Connector) x1 Wireless Charging Case x1
Charging Cable x1
Type-C to 3.5mm Adapter x1
TX Transmitter
TX Transmitter
RX Receiver
RX Receiver
Wireless Charging Case
Wireless Charging Case
Indicator — Transmitter (Double press the Power button to turn o󽗈 light e󽗈ect)
Indicator — Receiver
Indicator — Wireless Charging Case
① Power
② Working Indicators
③ Built-in Mic
④ Contacts
⑤ Pocket Clip
① Vocal E󽗈ects/ Mono/Stereo
② Type-C Port
③ Working Indicators
④ Connector
⑤ Contacts
① Pairing/ Power Prompt
② Type-C Port
③ Working Indicators
④ Contacts
1. Usage
2. Pairing
3. Charging
4. Check the power
5. Use vocal e󽗈ects
① Tap on the right side of charging case to pop out the drawer
② Take the TX and RX out
③ TX should boot automatically as it leaved the case, and switch itself o󽗈 automatically
when returning to the case.
(Forcible switch: Long press the Power button on TX for 3 seconds)
④ RX should boot automatically as it is plugged into smartphone
① Place the TX and RX in the case with their contacts are connected with the case’s
② Long press the Pairing button on the case for 3 seconds with the drawer open
③ The indicators on the TX and RX should light up and illuminate sequentially when
pairing is successful
Note: The transmitter will automatically switch o󽗈 if it is unpaired or disconnected for 5
minutes.
Charge the TX: Place the TX in the case with contacts connected with the case’s.
Charge the case: Connect the case with power supply via the charging cable.
TX: Short press the Power button, the indicators will light up according to remain power
for 5 seconds
Charging Case: Short press the Power Prompt button, the indicators will light up
according to remain power for 5 seconds
Short press the Vocal E󽗈ects button on the receiver to switch sound e󽗈ects: Original >> Studio FX >> KTV FX >> Voice
Ampli󽗉cation >> EDM (Electronic Dance Music) >> Baby FX >> Male to Female >> Female to Male >> Monster FX.
Default e󽗈ect: Original.
Note: The vocal e󽗈ect will apply to both transmitters. In Stereo mode, only original is supported. Other vocal e󽗈ects are
unavailable.
System unpaired
Pairing
System unpaired
Charging, and then turns o󽗈 when fully charge
Stereo mode (Only original is supported)
System paired, normal working
System paired
Mono mode-Original sound
Low battery
Mono mode-Vocal e󽗈ects on
Flash concurrently
Illuminate sequentially
Flash concurrently
Single light keeps on (light e󽗈ect o󽗈)
Single light keeps on & Illuminate sequentially
Single light keeps on (in the case)
Single light keeps on & Illuminate sequentially
two-way
Illuminate sequentially(light e󽗈ect on)
Illuminate sequentially
Single light 󽗊ashes
Single light 󽗊ashes twice & Illuminate sequentially
Working
Indicators(White
Light)
Working
Indicators(White Light)
Working
Indicators
(White
Light)
Working
Indicators(Red Light)
Long press for 3 seconds
6. Mono/ Stereo
Mono-Original
Mono-Other vocal e󽗈ects
Mono-Original
Long press the Mono/Stereo button on the RX once
Long press the Mono/Stereo button on the RX once
Long press the Mono/Stereo button on the RX once
Stereo

Produkt Specifikationer

Mærke: Synco
Kategori: Ikke kategoriseret
Model: P2L

Har du brug for hjælp?

Hvis du har brug for hjælp til Synco P2L stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Synco Manualer

Synco

Synco X-Talk X5 Manual

3 September 2024
Synco

Synco CMic-V2 Manual

20 August 2024
Synco

Synco P2L Manual

19 August 2024
Synco

Synco P2T Manual

19 August 2024
Synco

Synco WAir-G1T Manual

18 August 2024
Synco

Synco P1T Manual

18 August 2024
Synco

Synco WAir-G1L Manual

18 August 2024
Synco

Synco WMic-T3 Manual

17 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

MPM

MPM -48-CW-48 Manual

9 November 2024
Alpine

Alpine KAE-123C Manual

8 November 2024
IFM

IFM AC434S Manual

8 November 2024
Alpine

Alpine SBS-0515 Manual

8 November 2024
Alpine

Alpine KCE-103V Manual

8 November 2024
Alpine

Alpine KCE-104V Manual

8 November 2024
Advantech

Advantech ECU-1051TL Manual

8 November 2024
Alpine

Alpine DDC-R13A Manual

8 November 2024
Alpine

Alpine HCE-C200F Manual

8 November 2024
Alpine

Alpine CRM-1652RF Manual

8 November 2024