Think Tank Glass Limo Manual

Think Tank Ikke kategoriseret Glass Limo

Læs nedenfor 📖 manual på dansk for Think Tank Glass Limo (2 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 17 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

Glass Limo Instructions

For more information about this and other Think Tank products, visit www.thinktankphoto.com

Step 1: Locate the “tripod” or “monopod” straps

with the two buckles inside of the backpack.

Remove the Glass Limo waist belt. Open the rear lumbar

panel and slide your Thin Skin Belt, Pro Speed Belt or

Steroid Speed Belt in place. Secure the hook and loop

panel on the bottom of the bag. (belts sold separately)

Expand the capacity of your backpack by using the

Modular rails to attach up to three modular or Skin

pouches. (pouches sold separately)

Step 2: Thread the “tripod” or “monopod” straps

under the webbing near the top of the bag and

directly above the stretch pocket (two locations).

Step 3: The side release buckle should be located on

the side of the “tripod” straps. Adjust the strap posi-

tion on the bag so it is in this position.

Step 4: The ladder lock buckle should also be

located on the side of the tripod. Use this buckle to

tighten the strap.

Open the rear panel on any modular or skin pouch

and slide it behind the modular rail. To lock in place,

use the plastic tab to slide through the webbing

loop attached to the rail.

MONOPOD/TRIPOD ATTACHMENT

Monopods and tripods can be attached to the side of the backpack by putting two legs into the stretchable bottom pocket and then attaching it with two “tripod straps”.

ATTACHING A MODULAR BELT ATTACHING MODULAR COMPONENTS

TOP

BOTTOM

Use the foam donut to secure your 300 f/4

or similar lenses in the bottom of the bag,

or remove it when using larger lenses up to

a 600 f/4.

The included foam yolk can be used to

secure large glass to the back of the bag.

BIG GLASS SUPPORT