Vanson V-3213 Manual


Læs nedenfor 📖 manual på dansk for Vanson V-3213 (4 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 12 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/4
GREAT BRITAIN
For consumer contact, please visit www.clasohlson.co.uk and click on customer service.
Ver. 200805
Charger
Article number: 18-2001 36-3313
18-2005 36-3314
Model: Vanson V-3213
Please read the entire instruction manual before using the
product and save it for future reference. We apologise for any text
or photographic errors and any changes of technical data. If you
have any questions concerning technical problems please contact
our Customer Service Department.
Battery Charger with USB
Easy and convenient. Charges 2-4 HR03/HR6 Ni-MH batteries.
The charger is equipped with a 5 V DC 500 mA USB outlet.
Microprocessor controlled charging.
Charging time: Two to four hours.
Comes with eco-friendly NiMH batteries.
4 x HR6 2500 mAh 36-3313
 36-3314 4 x HR03 1000 mAh
2 LED charge indicators:
Quick chargingREDlit
Wrong battery type or bad contactREDashing
Charging completeREDunlit
USB outlet ready for useGREENlit
Safety functions:
Negative delta-V cut off
Timer
Short-circuit protection
Polarity protection
Warning
1. Read the entire instruction manual before using the charger.
2. The charger is only designed for charging Ni-MH batteries, size
HR03 or HR6. Attempts to charge other types of batteries can
lead to personal injury or damage the charger. The batteries
can leak or explode if incorrectly inserted, thrown in a re, mixed
with other types of batteries or short circuited.
3. Do not expose the charger to rain or moisture. The product
is only intended for indoor use.
4. Unplug the adaptor from the power point when the charger
is not in use.
5. Do not use an extension lead or other accessory besides
the ones included with the charger. Doing so can lead to an
electrical re or personal injury.
6. Do not use the equipment if damaged. Allow a qualied
repairman to perform any necessary repairs.
7. Use only the included adaptor. Do not disassemble or modify
the product in any way.
8. Remove the adaptor from the mains before and cleaning of
the charger of adaptor.
9. The charger is not a toy. Do not allow small children near the
charger without supervision.
Charging
N.B. The rechargeable batteries are not pre-charged. They must be
charged rst before using them for the rst time.
1. Insert 2 or 4 Ni-MH batteries; size HR6/HR03 in the battery
slots. The batteries must be charged in pairs. When charging
2 batteries, they must both be charged either in the right or left
section. (Fig. 1 and Fig. 2)
Battery status
The charger automatically senses the battery status when charging
commences.
If any of the batteries is unchargeable, short circuited,
or are mispositioned in the battery compartment, the LED
will ash rapidly.
Remove the defective battery and dispose of it. Refer to Disposal.
Charging time
N.B. The charging time can vary depending on the capacity and
condition of the battery.
Batterysize Capacity Chargingtime
HR6
1800-2000 mAh 3 – 3,5 hours
2100-2300 mAh 3,5 – 4 hours
2500-2800 mAh 4,5 – 5 hours
HR03 700-800 mAh 2 – 2,5 hours
900-1100 mAh 3 – 3,5 hours
USB outlet
Charging of the batteries in the battery compartment is stopped
when the USB outlet is used.
The green LED lights when the USB outlet is ready for use.
The connected USB devices power consumption cannot exceed
500 mA.
Disposal
Follow local ordinances when disposing of this product. If you are
unsure please contact your municipality.
Specications
Power Supply: 100-240 VAC, 50/60 Hz
Secondary outlet: HR6: 2 x 2.8 VDC, 600 mA, 3.36 VA
HR03: 2 x 2.8 VDC, 350 mA, 1.96 VA
USB outlet: 5 VDC 500 mA
Fig. 1 Fig. 2
2. Insert the batteries according to the (+ and -) markings in the
battery compartment.
3. Charge only one battery size at a time. Don’t mix HR6 and
HR03 batteries.
4. Connect the charger to a power point (100-240 VAC). The built-
in power supply will adjust automatically. The red LED light is lit
when charging is in progress.
5. The LED turns off when the batteries are fully charged and
ready to use.
6. Remove the charged batteries from the charger and remove the
charger from the outlet. Never let charged or even remain in the
charger when it is unplugged or for extended periods of time.
ENGLISH


Produkt Specifikationer

Mærke: Vanson
Kategori: Ikke kategoriseret
Model: V-3213

Har du brug for hjælp?

Hvis du har brug for hjælp til Vanson V-3213 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Vanson Manualer

Vanson

Vanson V-3213 Manual

23 August 2024
Vanson

Vanson SMP-60WME Manual

23 August 2024
Vanson

Vanson V-6833 Manual

23 August 2024
Vanson

Vanson BC-1HU Manual

23 August 2024
Vanson

Vanson SMP-20WM Manual

23 August 2024
Vanson

Vanson SPM 120 Manual

23 August 2024
Vanson

Vanson SMP-90WAT Manual

23 August 2024
Vanson

Vanson V-828 Manual

23 August 2024
Vanson

Vanson 36-4061 Manual

23 August 2024
Vanson

Vanson SDR-120W Manual

23 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer