Vertex Standard VX-231 Manual

Vertex Standard Radiokommunikation VX-231

Læs nedenfor 📖 manual på dansk for Vertex Standard VX-231 (3 sider) i kategorien Radiokommunikation. Denne guide var nyttig for 8 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/3

OperatiOn

Preliminary StePS

 Installacharged batterypackontothetransceiver,asde-

scribedpreviously.

 ScrewthesuppliedantennaontotheAntennajack.Never

attempt to operate this transceiver without an antenna con-

nected.

 IfyouhaveaSpeaker/Microphone,werecommendthatitnot

beconnecteduntil you arefamiliar with thebasic operation

oftheVX-230.

OPeratiOn Quick Start

 Turnthetoppanel’sVOL/PWRknob

clockwisetoturnontheradioon.

 Turnthetoppanel’sCHselectorknob

to choose the desired operating chan-

nel.

 RotatetheVOL/PWRknobtosetthe

volume level. If no signal is present,

pressandholdintheProgrammable

keyassignedto“SQL OFF”formore

thanonesecond;backgroundnoise

will now be heard, and you may use

thistosettheVOL/PWRknobforthe

desiredaudiolevel.

BefOre YOu Begin

Battery Pack inStallatiOn and remOval

 To install the battery, hold the transceiver with your left hand,

soyourpalmisoverthespeakerandyour

thumbisonthetopofthebeltclip.Insert

thebatterypackintothebattery

compartmentonthebackofthe

radio while tilting the Belt

Clipoutward, thenpush

thebottomsideofthe

batterypackuntil

thebatterypack

lockswiththeBat-

teryPackLatch.

 Toremovethebattery,turntheradiooffandremoveanyprotec-

tivecases.Slide the BatteryPackLatch onthebottom ofthe

radio, then slide the battery downward and out from the radio

whileholdingtheBeltClip.

Caution

Do not attempt to open any of the rechargeable Lithium-

Ion packs, as they could explode if accidentally short-

circuited.

lOw Battery indicatiOn

Asthebatterydischargesduringuse,thevoltagegraduallybecomes

lower.Whenthebatteryvoltagebecomestolow,substituteafreshly

charged battery and recharge the depleted pack.When the battery

voltageislow,theLEDindicatoronthetopoftheradiowillblink

red.Furthermore,ifyourDealersetsthe“LowBatteryAlert”feature

intothetransceiver,analertbeeperwillsoundwhenthebatteryvolt-

ageislow.

 PressandholdintheProgrammable

keyassignedto“SQL OFF”formore

thanonesecond(orpressthekey

twice)toquietthe noiseandresume

normal(quiet)monitoring.

 Totransmit,monitorthechannelandmakesureitisclear.

THIS IS AN FCC REQUIREMENT!

 Totransmit,pressandholdinthePTT

switch.Speakintothemicrophone

area of the front panel grille (lower

right-hand corner) in a normal voice

level. To return to the Receive mode,

releasethePTTswitch.

Do not transmit the radio without

an antenna connected.

 IfaSpeaker/Microphoneisavailable,removetheplasticcapand

its two mounting screws from the right side of the transceiver,

theninserttheplugfromtheSpeaker/MicrophoneintotheMIC/

SPjack;securetheplugusingthescrewssuppliedwiththe

Speaker/Microphone.Holdthespeakergrilleupnexttoyourear

whilereceiving.Totransmit,pressthePTTswitchontheSpeak-

er/Microphone,justasyouwouldonthemaintransceiver’sbody.

Note: Save the original plastic cap and its mounting

screws.Theyshouldbere-installedwhennotusingthe

Speaker/Microphone.

Microphone

Speaker

MIC/SP Jack

(ExternalMic/Earphone)

VOL/PWR Knob

CH (Channel) Selector

Side 1 Switch

Push To Talk

(PTT) Switch

Antenna

LED Indicator

Battery Pack Latch

Side 2 Switch

SafetY training infOrmatiOn

ThisRadiohasbeentestedandcomplieswiththeFederalCommu-

nications Commission (FCC) RF exposure limits for Occupational

Use/Controlledexposureenvironment.Inaddition,itcomplieswith

thefollowingStandardsandGuidelines:

 FCC 96-326, Guidelines for Evaluating the Environmental Ef-

fectsofRadio-FrequencyRadiation.

 FCCOETBulletin65Edition97-01(1997)SupplementC,Eval-

uatingCompliancewithFCCGuidelinesforHumanExposureto

RadioFrequencyElectromagneticFields.

 ANSI/IEEEC95.1-1992, IEEEStandardfor SafetyLevelswith

Respectto Human ExposuretoRadio FrequencyElectromag-

neticFields,3kHzto300GHz.

 ANSI/IEEE C95.3-1992, IEEE Recommended Practice for the

Measurement of Potentially Hazardous Electromagnetic Fields-

RFandMicrowave.

WARNING:ThisradiogeneratesRFelectromagneticenergy

duringtransmit mode.Thisradio isdesigned forand classi-

edasOccupational Use Only,meaningitmustbeusedonlyduring

thecourseofemploymentbyindividualsawareofthehazards,and

thewaystominimizesuchhazards.Thisradioisnotintendedforuse

bytheGeneral Populationinanuncontrolledenvironment.

CAUTION:ToensurethatyourexposetoRFelectromagnet-

icenergyiswithintheFCCallowablelimitsforoccupational

use,alwaysadheretothefollowingguidelines:

Please read this manual carefully to become familiar with the

features of this transceiver.

 Do not transmit the radio without an antenna connected.

This radio is NOT approved for use by the general popula-

tion in an uncontrolled environment. This radio is restricted

to occupational use, work related operations only where the

radio operator must have the knowledge to control its RF ex-

posure conditions.

When transmitting, hold the radio in a vertical position with

its microphone 1 to 2 inches (2.5 to 5 cm) away from your

mouth and keep the antenna at least 1 inch (2.5cm) away

from your head and body.

The radio must be used with a maximum operating duty

cycle not exceeding 50 %, in typical Push-to-Talk (PTT) con-

gurations. DO NOT transmit for more than 50 % of total

radio use time (50 % duty cycle). Transmitting more than

50 % of the time can cause FCC RF exposure compliance re-

quirements to be exceeded.

To keep the Body Worn conguration with the Vertex Stan-

dard CLIP-18 belt-clip, reduce the maximum operating duty

cycle still more.

The radio is transmitting when the red LED on the top of the

radio is illuminated. You can cause the radio to transmit by

pressing the PTT button.

When operate the radio with the Vertex Standard CLIP-18

belt-clip, make the transmission time as short as possible, to

keep the Body Worn conguration.

Always use the FNB-V103LI, FNB-V104LI, FNB-V131LI-

UNI or FNB-V132LI-UNI Lithium-Ion Battery.

 Risk of explosion if battery is replaced by an incorrect type.

Dispose of used batteries according to the instructions.

 Perform the battery charging where the ambient tempera-

ture range +50 °F to +104 °F (10 °C to +40 °C). Charge out

of this range could cause damage to the battery pack.

 Battery Pack shall not be exposed to excessive heat such as

sunshine, re or the like.

Vertex Standard LMR, Inc.

 Always use Vertex Standard authorized accessories.

Vertex Standard shall not be liable for any damage or ac-

cidents such as fire, leakage or explosion of batteries, etc.,

caused by the malfunction of non-Vertex Standard accesso-

ries.

 This radio generates RF electromagnetic energy during

transmit mode. This radio is designed for and classified as

occupational use only, meaning it must be used only during

the course of employment by individuals aware of hazard-

ous, and the ways to minimize such hazardous. This radio is

not intended for use by the General Population in an uncon-

trolled environment.

Theinformationlistedaboveprovidestheuserwiththeinformation

neededtomakehimorherawareofRFexposure,andwhattodoto

assurethat thisradio operateswith theFCC RFexposurelimitsof

thisradio.

Electromagnetic Interference/Compatibility

During transmissions, this radio generates RF energy that can

possibly cause interference with other devices or systems. To

avoid such interference, turn off the radio in areas where signs

are posted to do so.

Do not operate the transmitter in areas that are sensitive to elec-

tromagnetic radiation such as hospitals, health care facilities,

aircraft, and blasting sites.

FCC LICENSE INFORMATION

This radio operates on communications frequencies which are

subject to FCC (Federal Communications Commission) Rules

and Regulations. FCC Rules require that all operators using Pri-

vate Land Mobile radio frequencies obtain a radio license before

operating their equipment.

acceSSOrieS & OptiOnS

FNB-V103LI

7.4V1380mAhLithium-IonBattery

FNB-V104LI

7.4V2300mAhLithium-IonBattery

FNB-V131LI-UNI

7.4V1380mAhLithium-IonBattery

FNB-V132LI-UNI

7.4V2300mAhLithium-IonBattery

VAC-300

DesktopRapidCharger(forFNB-V103LI/-V104LI)

VAC-6300

6-unitMultiCharger(forFNB-V103LI/-V104LI)

CD-58

DesktopCharger(forFNB-V131LI-UNI/-V132LI-UNI)

PA-55

ACAdapter(forCD-58)

VAC-6058

6-unitMultiCharger(forFNB-V131LI-UNI/-V132LI-UNI)

MH-37A4B

Earpiece/Microphone

MH-45B4B

Speaker/Microphone(NoiseCancelling)

MH-360S

Speaker/Microphone(SmallType)

MH-450S

Speaker/Microphone(MiniatureType)

VH-115S

Lightweightheadsetw/Boommic

VH-215S

Lightweightpaddedheadset,SingleSpeaker

VH-225S

Lightweightpaddedheadset,DualSpeaker

VCM-2

VehicleChargerMountAdapter(forVAC-300)

DCM-1

DesktopChargerBracket(forVAC-300)

ATV-8A

RubberAntenna134-151MHz

ATV-8B

RubberAntenna150-163MHz

ATV-8C

RubberAntenna161-174MHz

ATV-6XL

RubberAntenna134-174MHz(Untuned)

ATU-6A

RubberAntenna400-430MHz

ATU-6B

RubberAntenna420-450MHz

ATU-6C

RubberAntenna440-470MHz

ATU-6D

RubberAntenna450-485MHz

ATU-6F

RubberAntenna485-520MHz

CLIP-18

BeltClip

LCC-230

LeatherCase

CE99

ProgrammingSoftware

FIF-12

USBProgrammingInterface

CT-27

RadiotoRadioProgrammingCable

CT-106

PCProgrammingCable(forFIF-12)

Tilt the Belt Clip

Insert the Battery Pack

Push the bottom side

of the Battery Pack

vX-230 SerieS

OPerating manual

cOntrOlS & cOnnectOrS

Green Monitoron(orSide1orSide2switchisactivated)

Blinking Green BusyChannel(orSQLoff)

Glows Red Transmitting

Blinking Red BatteryVoltageisLow

Yellow ReceivingaSelectiveCall

Operating temperature range

(FOr eurOpean user)

Operation:–20°Cto+55°C

Battery Charging:+10°Cto+40°C

(Turntheradiooffwhilechargingthebattery)

Produkt Specifikationer

Mærke:	Vertex Standard
Kategori:	Radiokommunikation
Model:	VX-231

Har du brug for hjælp?

Hvis du har brug for hjælp til Vertex Standard VX-231 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Radiokommunikation Vertex Standard Manualer

Vertex Standard VX-451 Manual

8 Juli 2024

Vertex Standard VX-4500 Manual

7 Juli 2024

Vertex Standard VX-354 Manual

6 Juli 2024

Vertex Standard EVX-534 Manual

6 Juli 2024

Vertex Standard EVX-539 Manual

5 Juli 2024

Vertex Standard EVX-531 Manual

5 Juli 2024

Vertex Standard VX-231 Manual

4 Juli 2024

Vertex Standard VX-351 Manual

4 Juli 2024

Vertex Standard VX-454 Manual

4 Juli 2024

Vertex Standard VX-350 Series Manual

4 Juli 2024

Radiokommunikation Manualer

Nyeste Radiokommunikation Manualer

Rexon RM-03N Manual

20 September 2024

Simrad RS8400 Shipmate Manual

17 September 2024

Intek MT-5050 Manual

25 August 2024

Intek RP-600 Manual

25 August 2024

BaoFeng UV-3R-Plus Manual

25 August 2024

Icom IC- F3260 Series Manual

25 August 2024

Icom IC- F4260 Series Manual

25 August 2024

Wouxun KG-833 Manual

24 August 2024

Wouxun KG-UV6D Manual

22 August 2024

Team CB Mobile MiniCom Manual

22 August 2024