Yorkville C120P Manual


Læs nedenfor 📖 manual på dansk for Yorkville C120P (4 sider) i kategorien Højttaler. Denne guide var nyttig for 18 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/4
Printed in China
w w w . y o r k v i l l e . c o m
Quality and Innovation Since 1963
Yorkville Sound
550 Granite Court
Pickering, Ontario
L1W-3Y8 CANADA
Yorkville Sound Inc.
4625 Witmer Industrial Estate
Niagara Falls, New York
14305 USA
Yorkville C120P Loudspeaker
*This Product is Warranted against
manufacturing defects for a period of one year
hank you for choosing Yorkville's Coliseum C120P powered
monitors for your sound reproduction needs. We hope you
will take the time to read this brief manual and if you have any
questions we can be reached online at info@yorkville.com.
Blue LED - indicates power ON.
Orange LED - indicates "clip/limit." The built-in non-defeat-
able LIMITER helps to prevent distortion. It operates
continuously and has minimal effect on sound quality,
however its operation does indicate that the C120P is
at maximum volume and may be on the verge of dis-
tortion if the Orange LED is on more of the time than
simply flashing on peaks.
TREBLE Control - adjust this control clockwise
or counter-clockwise to increase or decrease
high frequency emphasis. A center setting is
neutral. (See BASS control.)
GAIN Control - turn this control clockwise to
increase the volume, or counterclockwise to
reduce volume. If the orange "clip/limit" LED on
the front of the enclosure illuminates, reducing
the GAIN setting will decrease its activity.
BASS Control - adjust this control clockwise
or counter-clockwise to increase or decrease
the emphasis in the low frequency region. A
center setting is neutral.
Tip: if the orange "clip/limit" LED is illuminating
overtly at comparatively low sound levels, it may
be a result of the BASS being turned up too far.
Reducing the BASS setting will help to compen-
sate. This also applies to the TREBLE control.
¼-Inch BALANCED LINE Input - this is for monophon-
ic, Tip-Ring-Sleeve (balanced), line-level signals and is
not internally connected to the STEREO LINK OUTPUT.
Its main purpose is to provide the mixing technician with
the ability to isolate mixer outputs, or patches, through a
dedicated monitor.
Balancing code is; Tip= (+) 0° phase, Ring= (-) 180°
phase, and Sleeve=Ground.
Tip: if you want to add-on a second C120P, connect
your signal source via the 1/8-inch CD STEREO
LINE IN jack, not the ¼-inch BALANCED LINE input.
Now you can interconnect the second C120P as
stated below.)
1/8-inch STEREO LINK OUTPUT Jack - use a 1/8-inch
stereo cable here to connect an additional C120P. Make
sure the MONO/STEREO button is in the STEREO posi-
tion (down) otherwise the additional speaker will not work.
MONO/STEREO Pushbutton - regulates the signal com-
ing in through the 1/8-inch CD/STEREO LINE IN jack.
Use the STEREO setting when the audio signal is stereo
and/or interconnecting an additional C120P. Use the
MONO setting when no other C120P is linked and you
want Left and Right blended.
Tip: if you are adding another C120P via the
STEREO LINK OUTPUT jack, be sure the MONO/
STEREO pushbutton is in the STEREO position so
that the additional speaker will work
1/8-inch CD/STEREO LINE IN Jack - this is where you
connect your stereo tuner/amplifier, CD player or tape
deck. When used in the recording studio, you may run a
mono line from the mixer to this input rather than the ¼-
inch BALANCED LINE IN jack.
Your C120P can be painted. We suggest that you remove
the front grill and mask off the speakers and rear connector
panel to avoid getting paint on them. If you want to paint
the C120P without removing the grill, a small amount of
overspray will not hurt the components. However, too much
paint will destroy your speakers permanently.
MAD E IN
CHI N A
FABR IQ U É EN CHI
NE
YOR
KVILLE SOUN D
T ORO NT O
, CANADA
BALANC ED
LINE IN
CD /ST ERE O
LINE IN
(fr om LINK o f
SO URCE C120P)
SE CO ND
C120P
FO R MINI-JACKS (1/8-in ch )
WHEN LINKING US E O NLY ST EREO CABLE S
C120P
CD /ST ERE O
LINE IN
LINK OU T
8 0 Wa t t s
C120P
York vil le
230V
50Hz
0.15A
120 CVA
60Hz
0.3A
T YPE YS1025:
1v2
WARNING S HOCK HAZARD DO NOT OPEN
AVIS RIS QUE DE CH OC ELECTRIQUE NE PAS OUVRIR
RIS K O F EL ECT RIC S HOC K
DO NOT OPEN
NOT S UITAB LE FOR IN-WALL MOUNT ING
WARNING: THE BONDING CONDUCTOR IN THIS S UPPLY CORD
IS PROVI DED F OR PER FOR MANC E REAS ONS ONL Y
LE CONDUCTEUR DE T ERRE DE PROTECTION DANS CE CORDON
D'ALI ME NT AT ION EST SEUL EM
ENT POUR RAIS ONS DE PE RF ORM ANC E
AVIS RIS QU E DE CH OC
EL ECT RIQ UE NE P
AS OU VRIR
Gain
Treble
Bass
Balanced Line In
Link Out
Mono
CD/Stereo Line In
Stereo
Frequency response: 65Hz to 19KHz +/-3dB
Power: 80 Watts burst avg. power
Max SPL: 101dB @ 1 meter
Connectors: 1/4-inch Phone and 1/8-inch Mini Jack
Dimensions: W 17.8 x D 6.5 x H 10.25 inches
W 17.8cm x D 16.5cm x H 26cm
Weight: 8.8 lbs (4.0 kg.)
T
DOC-c120p-spec-00-2v0.pdf


Produkt Specifikationer

Mærke: Yorkville
Kategori: Højttaler
Model: C120P

Har du brug for hjælp?

Hvis du har brug for hjælp til Yorkville C120P stil et spørgsmål nedenfor, og andre brugere vil svare dig




Højttaler Yorkville Manualer

Yorkville

Yorkville NX8P Manual

8 September 2024
Yorkville

Yorkville NX12P Manual

6 September 2024
Yorkville

Yorkville EF10P Manual

5 September 2024
Yorkville

Yorkville NX35 Manual

4 September 2024
Yorkville

Yorkville C2891 Manual

4 September 2024
Yorkville

Yorkville C12CW Manual

3 September 2024
Yorkville

Yorkville NX10C-2 Manual

3 September 2024

Højttaler Manualer

Nyeste Højttaler Manualer