Aruba 7008 Manual
Læs nedenfor 📖 manual på dansk for Aruba 7008 (2 sider) i kategorien Joystick. Denne guide var nyttig for 20 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/2
Aruba 7008 Controller
Installation Guide
The Aruba 7008 Controller is a wireless LAN controller that connects,
controls, and intelligently integrates wireless Access Points (APs) and Air
Monitors (AMs) into a wired LAN system. The 7008 controller includes eight
PoE/PoE+ Ethernet ports, one Console port, one USB 2.0 port, and one USB
3.0 port. This device supports up to 16 APs and 1024 users.
Package Contents
Aruba 7008 Controller
7008 Controller Power Adapter
Installation Guide (this document, printed)
Quick Start Guide (Printed)
End User License Agreement (Printed)
7008 Components
This section introduces the different components and their location in the
Aruba 7008 controller.
Figure 1 show the front panel of the 7008 controller and Figure 2 shows the
back panel of the 7008 controller.
Figure 1 Front Panel of the 7008 Controller
Figure 2 Back Panel of the 7008 Controller
Power and Status LEDs
The front panel includes power and status LEDs that provide basic
monitoring of the overall status of the 7008 controller. The following table
describes the power and status LEDs behavior:
Reset Config
The front panel of the 7008 controller also includes a recessed button for
resetting the 7008 controller configuration. Insert a pin into the Reset
Config hole until you feel the pin is touc
hing a surface. Push and hold the
pin for two seconds to reset the controller configuration.
PoE/PoE+ Ethernet Ports
The back panel of the 7008 controller is equipped with eight 10/100/
1000BASE-T Gigabit Ethernet ports (0 to 7). The orange numbering on all
ports indicate that these are PoE/PoE+ ports.
Gigabit Ethernet uses all eight wires and each pair is bi-directional, which
means, the same pair is used for both data transmission and data
reception. Figure 3 illustrates the Gigabit Ethernet port pin-out for an RJ-45
connector. The pins paired on a 10/100/1000BASE-T Gigabit Ethernet port
are: 1/2, 3/6, 4/5, and 7/8.
Figure 3 Gigabit Ethernet Port Pin-Out
Ethernet Port LEDs
Each 10/100/1000BASE-T Ethernet port is equipped with two LEDs that
allow basic monitoring of link/port status and activity.
LINK/ACT: Placed on the left side of the port, this LED displays the link
status and activity of the port.
STATUS: Placed on the right side of the port, this LED displays the status
of the port based on the speed.
The following table describes the LED behavior for each mode:
Console Port
The back panel of the 7008 controller includes a serial console port that
allows connecting the controller to a serial terminal or a laptop for direct
local management. This port is an RJ-45 female connector with the pinouts
described in rminal or terminal server Figure 4. Connect it directly to a te
using an Ethernet cable.
Figure 4 Serial Console Port Pin-Out
The communication settings for the Console port is shown in the following
table:
Serial Console Port Adapter
A modular adapter can be used to convert the female RJ-45 connector to a
male DB9 connector. See Figure 5 for complete details.
Figure 5 RJ-45 (Female) to DB9 (Male) Modular Adapter Conversion
USB 2.0 and USB 3.0 Interface
The back panel of the 7008 controller is equipped with one USB 2.0 and one
USB 3.0 interface. A USB storage device can be used to save and upload
configurations to the controller.
Grounding Point
The back panel of the 7008 controller is equipped with grounding points. To
meet safety and electromagnetic interference (EMI) requirements and to
ensure proper operation, the controller must be adequately grounded
before power is connected. Connect a grounding cable to earth ground and
then attach it to the chassis grounding point using a grounding screw.
Comply with electrical grounding standards during all phases of installation
and operation of the product. Do not allow the controller’s chassis, network
ports, power supply, or mounting brackets to contact any device, cable,
object, or person attached to a different electrical ground. Also, never
connect the device to external storm grounding sources.
DC Power Socket
The back panel of the 7008 controller is equipped with AC-DC adapter kit
with 54V/ 2.78A power interface is used to power the controller.
Kensington Security Slot
The 7008 controller is equipped with a Kensington security slot for device
security on the right side while looking from the front.
Installing the 7008 Controller
Installation Recommendations
For proper air circulation, leave at least 10 cm (4 inches) clearance on the
left, right, front, and rear side of the controller.
Leave additional space in front and rear side of the controller to access
power cords, network cables, and indicator LEDs.
Avoid placing anything on top of the controller because it can lead to
overheating of the controller.
Avoid placing this controller on any other device because the heat
dissipated from the other device may overheat the controller.
Installation Using the Integrated Wall-Mounting Slots
The keyhole-shaped slots on the bottom of the controller can be used to
attach the device upright (back panel facing downwards) to an indoor wall
or shelf.
Since the ports are on the back of the device, make sure to mount the
controller in such a way that there is a clear path to the Ethernet port, such
as a predrilled hole in the mounting surface.
1. At the mounting location, install two screws on the wall or shelf, 100 mm
apart. If you are attaching the device to drywall, it is recommended that
you use appropriate wall anchors (not included). See Figure 6.
Figure 6 Mounting Using the Integrated Wall-Mounting Slots
2. Align the mounting slots on the bottom of the controller over the screws
and slide the unit into place. See Figure 7
Figure 7 Wall Mounting Aruba 7008
Product Specifications
Physical
Device Dimensions (HxWxD): 4.2 cm x 20.32 cm x 20.32 cm
Device Weight: 2.204 lbs (1 kg)
Electrical
Ethernet:
8 x 10/100/1000BASE-T auto-sensing Ethernet RJ-45 Interfaces
MDI/MDX
PoE support on ports 0 to 7 (IEEE 802.3af or IEEE 802.3at compliant),
54 V DC (maximum)/ 550 mA (see Figure 3 for pin configuration)
Power:
54V DC power interface, supports powering through an 54V DC, 2.78A
AC-to-DC power adapter
Environmental
Operating:
Temperature: 0° C to +40° C (+32° F to +104° F)
Humidity: 10% to 90% (RH) non-condensing
Storage and transportation:
Temperature: -40° C to +70° C (-40° F to +158° F)
For additional specifications on this product, please refer to the data sheet.
The data sheet can be found at www.arubanetworks.com.
The 7008 controller requires ArubaOS 6.5.0.0 or later.
Optional accessories are available for use with the Aruba 7008 controller
and are sold separately. Contact your Aruba sales representative for
details and assistance.
Table 1 Power and Status LEDs
LED Function Indicator Status
Power System powers Green (Solid) Powered from DC adapter
Off Power Off
Status System status Green (Solid) Operational
Green (Blinking) Device is loading software
Amber (Blinking) Major Alarm
Amber (Solid) Critical Alarm
Off No power
Table 2 10/100/1000BASE-T Ethernet Port LEDs
LED Function Mode Indicator Status
LINK/ACT Link
status
N/A Green (Solid) Link has been
established
Green
(Blinking)
Port is transmitting or
receiving data
Off No link on port
STATUS Port
status
Speed Green (Solid) 1000 Mbps
Off 10/100 Mbps
Table 3 Console Terminal Settings
Baud Rate Data Bits Parity Stop Bits Flow Control
9600 8 None 1 None
!
!
!
!!
The CONSOLE port is compatible only with RS-232 devices. Non-RS-232
devices, such as APs, are not supported.
!
!
!
!!
Do not connect the Console port to an Ethernet switch or a PoE power
source. This may damage the controller.
1000Base-T Gigabit
Ethernet Port
RJ-45 Female
Pin-Out
Signal Name
1
2
3
4
5
6
7
8
BI_DC+
BI_DC-
BI_DD+
BI_DD-
BI_DA+
BI_DA-
BI_DB+
BI_DB-
Function
Bi-directional pair +C
Bi-directional pair -C
Bi-directional pair +D
Bi-directional pair -D
Bi-directional pair +A
Bi-directional pair -A
Bi-directional pair +B
Bi-directional pair -B
Serial
Console Port
1
2
3
4
5
6
7
8
TxD
GND
RxD
RJ-45 Female
Pin-Out
Direction
Input
Output
GND
Service to all Aruba, a Hewlett Packard Enterprise company products
should be performed by trained service personnel only.
3
4
5
2
5
6 3
RJ-45 DB-9
Internal
Connections
TxD
GND
RxD
1
2
3
4
5
6
7
8
TxD
GND
RxD
RJ-45 Female
Pin-Out
DB-9 Male
Pin-Out
TxD
RxD
Ground
5
4
3
2
1
9
8
7
6
Produkt Specifikationer
| Mærke: | Aruba |
| Kategori: | Joystick |
| Model: | 7008 |
Har du brug for hjælp?
Hvis du har brug for hjælp til Aruba 7008 stil et spørgsmål nedenfor, og andre brugere vil svare dig
Joystick Aruba Manualer
23 November 2023
9 December 2022
29 November 2022
21 November 2022
1 November 2022
Joystick Manualer
- Joystick Sony
- Joystick Panasonic
- Joystick Philips
- Joystick Nintendo
- Joystick Pioneer
- Joystick TOA
- Joystick Carat
- Joystick Logitech
- Joystick Behringer
- Joystick HP
- Joystick Carel
- Joystick Roland
- Joystick Asus
- Joystick Pyle
- Joystick Tracer
- Joystick Denon
- Joystick One For All
- Joystick Yamaha
- Joystick Nedis
- Joystick Da-Lite
- Joystick Hama
- Joystick Thomson
- Joystick Belkin
- Joystick JBL
- Joystick AKAI
- Joystick DataVideo
- Joystick Trust
- Joystick Honeywell
- Joystick Razer
- Joystick Speedlink
- Joystick Tangent
- Joystick Cisco
- Joystick Huawei
- Joystick König
- Joystick Gembird
- Joystick Bose
- Joystick Netgear
- Joystick Parrot
- Joystick Danfoss
- Joystick Tripp Lite
- Joystick Mad Catz
- Joystick Microsoft
- Joystick Vaddio
- Joystick SteelSeries
- Joystick Thrustmaster
- Joystick Genesis
- Joystick Krüger&Matz
- Joystick Dell
- Joystick Schneider
- Joystick DJI
- Joystick Cooler Master
- Joystick PreSonus
- Joystick MSI
- Joystick Ikan
- Joystick Irritrol
- Joystick Rain Bird
- Joystick Tascam
- Joystick Datalogic
- Joystick Velleman
- Joystick Marshall
- Joystick Sonance
- Joystick Zoom
- Joystick JUNG
- Joystick Fostex
- Joystick HQ Power
- Joystick Teac
- Joystick Sven
- Joystick Thermaltake
- Joystick SBS
- Joystick ART
- Joystick Monacor
- Joystick ION
- Joystick Spektrum
- Joystick Numark
- Joystick RCA
- Joystick Keith MCmillen
- Joystick Chamberlain
- Joystick DBX
- Joystick Jumbo
- Joystick Asustor
- Joystick Aquatic AV
- Joystick IK Multimedia
- Joystick Saitek
- Joystick Nyko
- Joystick Senal
- Joystick Movistar
- Joystick Xantech
- Joystick Krom
- Joystick Contour Design
- Joystick Oculus VR
- Joystick L-Link
- Joystick Chauvet
- Joystick 8BitDo
- Joystick Crestron
- Joystick Kogan
- Joystick RGBlink
- Joystick Inovonics
- Joystick Hitec
- Joystick Nektar
- Joystick GMB Gaming
- Joystick Bigben
- Joystick Ewent
- Joystick Auray
- Joystick Gamesir
- Joystick PDP
- Joystick Ltech
- Joystick Logic3
- Joystick Gioteck
- Joystick Steca
- Joystick Icon
- Joystick Highpoint
- Joystick IVT
- Joystick Dragonshock
- Joystick PCE Instruments
- Joystick COLBOR
- Joystick Audibax
Nyeste Joystick Manualer
11 December 2024
10 December 2024
10 December 2024
10 December 2024
10 December 2024
29 November 2024
26 November 2024
26 November 2024
26 November 2024
26 November 2024