Audio-Technica AT4047/SV Manual

Audio-Technica Mikrofon AT4047/SV

Læs nedenfor 📖 manual på dansk for Audio-Technica AT4047/SV (2 sider) i kategorien Mikrofon. Denne guide var nyttig for 24 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Download PDF

Side 1/2

CARDIOID CONDENSER MICROPHONE

- Transformer-coupled output and a specially tuned element provide

warm sonic characteristics reminiscent of early F.E.T. studio microphone

designs

- Exceptionally wide dynamic range, low self-noise and high SPL

capability for maximum versatility

- Dual-diaphragm capsule design maintains precise cardioid pattern

denition across the full frequency range of the microphone

- Precision-machined, nickel-plated brass, acoustic element bafe

provides enhanced element stability and optimal sensitivity

- State-of-the-art surface-mount electronics ensure compliance with A-T’s

stringent consistency and reliability standards

The AT4047/SV is intended for use in professional applications where

remote power is available. It requires 48V DC phantom power, which may

be provided by a mixer or console, or by a separate, in-line source such

as the Audio-Technica AT8801 single-channel or AT8506 four-channel

phantom power supplies.

Output from the microphone’s XLRM-type connector is low impedance

(Lo-Z) balanced. The signal appears across Pins 2 and 3; Pin 1 is

ground (shield). Output phase is “Pin 2 hot” – positive acoustic pressure

produces positive voltage at Pin 2.

To avoid phase cancellation and poor sound, all mic cables must be wired

consistently: Pin 1-to-Pin 1, etc.

An integral 80 Hz hi-pass filter provides easy switching from a flat

frequency response to a low-end roll-off. The roll-off position reduces the

microphone's sensitivity to popping in close vocal use. It also reduces

the pickup of low-frequency ambient noise (such as trafc, air-handling

systems, etc.), room reverberation and mechanically-coupled vibrations.

In use, secure the cable to the mic stand or boom, leaving a slack loop at

the mic. This will ensure the most effective shock isolation and reduce the

possibility of accidentally pulling the microphone out of its mount.

Avoid leaving the microphone in the open sun or in areas where

temperatures exceed 43°C for extended periods. Extremely high humidity

should also be avoided.

FORM No. ATGC-L0145-08-E

Machida • Tokyo • Japan

SPECIFICATIONS

ELEMENT Externally polarized (DC bias)

condenser

POLAR PATTERN Cardioid

FREQUENCY RESPONSE 20-18,000 Hz

OPEN CIRCUIT SENSITIVITY -35 dB (17.7 mV) re 1V at 1 Pa

IMPEDANCE 250 ohms

MAXIMUM INPUT SOUND LEVEL 149 dB SPL, 1 kHz at 1% T.H.D.

156 dB SPL, with 10 dB pad (normal)

NOISE 9 dB SPL

DYNAMIC RANGE (typical) 140 dB, 1 kHz at Max SPL

SIGNAL-TO-NOISE RATIO 85 dB, 1 kHz at 1Pa

LOW FREQUENCY ROLL-OFF 80 Hz, 12 dB/octave

PHANTOM POWER REQUIREMENTS 48V DC, 3.0 mA typical

SWITCHES Flat, roll-off; 10 dB pad (nominal)

WEIGHT (less accessories) 410 g

DIMENSIONS 170.0 mm - long,

53.4 mm - maximum body diameter

OUTPUT CONNECTOR Integral 3-pin XLRM-type

ACCESSORIES FURNISHED AT8449/SV shock mount for

5/8”-27 threaded stands;

microphone dust cover;

protective carrying case

10 dB

20k10k5k2k1k50020010050

8 kHz

200 Hz

1 kHz

5 kHz

0°

330°

300°

270

240°

210°

180°

150°

120°

90°

60°

30°

Polar Pattern

Frequency Response

SCALE IS 5 DECIBELS PER DIVISION

LEGEND

Frequency in Hertz

LEGEND 12” or more on axis

Response in dB

Optional Accessories:

AT8506 four-channel 48V phantom power

supply (AC powered).

AT8801/EU single-channel 48V phantom

power supply (AC powered).

Roll-off

Produkt Specifikationer

Mærke:	Audio-Technica
Kategori:	Mikrofon
Model:	AT4047/SV
Type:	Studiemikrofon
Produktfarve:	Sølv
Husmateriale:	Brass, Nickel
Forbindelsesteknologi:	Ledningsført
Enhedsgrænseflade:	mini XLR (3-pin)
Bæretaske:	Ja
Mikrofonindgangsimpedans:	250 ohm (Ω)
Mikrofon frekvens:	20 - 18000 Hz
Mikrofonretningstype:	Kardioid
Mikrofon sensitivitet:	-35 dB
Mikrofon vægt:	410 g
Antal produkter inkluderet:	1 stk
Svingspole type:	Forpolariseret kondensator
Mikrofon dimensioner (DxH):	53.4 x 170 mm
Mikrofon, signal-til-støjforhold:	85 dB
Mikrofonholder:	Ja
Mikrofon dynamikområde:	140 dB
Garantiperiode:	5 År
Lavskåret filter:	80 Hz