Audio-Technica AT8035 Manual


Læs nedenfor 📖 manual på dansk for Audio-Technica AT8035 (2 sider) i kategorien Mikrofon. Denne guide var nyttig for 15 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
broadcast & production microphones
AT8035
Line + Gradient Condenser Microphone
Features
Designed for video production and broadcast (ENG/EFP) audio
acquisition
Provides the narrow acceptance angle desirable for long-distance
sound pickup
Smooth, natural-sounding on-axis audio quality
Offers the convenience of battery or phantom power operation
Rugged design and construction for reliable performance
Switchable 80 Hz high-pass lter minimizes pickup of undesired
low-frequency sounds
Description
The AT8035 is a xed-charge condenser microphone with a line +
gradient polar pattern. It is designed for video production, broadcast
(ENG/EFP) audio acquisition, wildlife recording and high-quality sound
reinforcement.
The microphone requires 11V to 52V phantom power or a 1.5V AA
battery for operation. A battery need not be in place for phantom power
operation.
The microphone's highly directional polar pattern provides a narrow
acceptance angle along with crisp, intelligible audio reproduction
desirable for long-distance sound pickup.
The output of the microphone is a 3-pin XLRM-type connector.
A switch permits choice of at response or low-frequency roll-off (via
integral 80 Hz high-pass lter) to help control undesired ambient noise.
The microphone is enclosed in a rugged housing. The included AT8405a
stand clamp permits mounting on any microphone stand with 5/8"-27
threads. A windscreen, two o-rings, a battery and a protective carrying
case are also included.
Operation and Maintenance
The AT8035 requires 11V to 52V phantom power or a 1.5V AA battery for
operation. A battery need not be in place for phantom power operation.
To install the battery, unscrew the lower section of the microphone body,
just below the nameplate. Insert a fresh 1.5V AA battery in the handle
compartment (“+” end up), then reassemble the microphone. Alkaline
batteries are recommended for longest life. Remove the battery during
long-term storage.
Output is low impedance (Lo-Z) balanced. The signal appears across Pins
2 and 3; Pin 1 is ground (shield). Output phase is Pin 2 hot”— positive
acoustic pressure produces positive voltage at Pin 2.
To avoid phase cancellation and poor sound, all mic cables must be wired
consistently: Pin 1-to-Pin 1, etc.
An integral 80 Hz high-pass lter provides easy switching from a at
frequency response to a low-end roll-off. The roll-off position reduces
the pickup of low-frequency ambient noise (such as trafc, air-handling
systems, etc.), room reverberation and mechanically coupled vibrations.
To engage the high-pass lter, use the end tip of a paperclip or other
small pointed instrument to slide the switch toward the “bent” line.
Avoid leaving the microphone in the open sun or in areas where
temperatures exceed 110° F (43° C) for extended periods. Extremely high
humidity should also be avoided.
Note: To use the microphone with a camera-mount microphone holder
whose diameter is too large to secure the microphone, slide the two
supplied o-rings onto the microphone handle, spaced so that one ts
just in front of, and the other ts just behind, the rubber nubs inside the
microphone holder. When the top of the microphone holder is closed and
tightened down, the o-rings should hold the microphone securely in place.


Produkt Specifikationer

Mærke: Audio-Technica
Kategori: Mikrofon
Model: AT8035

Har du brug for hjælp?

Hvis du har brug for hjælp til Audio-Technica AT8035 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Mikrofon Audio-Technica Manualer

Mikrofon Manualer

Nyeste Mikrofon Manualer

Shure

Shure MoveMic Manual

17 November 2024
Comica

Comica DUAL.LAV D03 Manual

17 November 2024
BOYA

BOYA BY-PM500W Manual

17 November 2024
Elgato

Elgato Wave Panels Manual

16 November 2024
Warm Audio

Warm Audio WA-8000 Manual

15 November 2024
Pyle

Pyle PDWM3100 Manual

15 November 2024
Behringer

Behringer TM1 Manual

15 November 2024
Yamaha

Yamaha RM-WCH-8 Manual

14 November 2024
Yamaha

Yamaha RM-WOH Manual

14 November 2024