Audio-Technica U853RW Manual


Læs nedenfor 📖 manual på dansk for Audio-Technica U853RW (2 sider) i kategorien Mikrofon. Denne guide var nyttig for 22 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/2
CARDIOID CONDENSER
HANGING MICROPHONE
- Designed for suspension over choirs, in-
strumental groups and the theater stages.
- Superior off-axis rejection for maximum
gain before feedback.
- UniGuard™ RFI-shielding technology offers
outstanding rejection of radio frequency
interference (RFI).
- UniSteep® lter provides a steep low-
frequency attenuation to improve sound
pickup without affecting voice quality.
- Accepts interchangeable elements to per-
mit angle of acceptance 90° to 360°.
- Low-prole design with low-reectance n-
ish for minimum visibility.
- Available in two colors: black (U853A / U853R) and white (U853AW /
U853RW).
The U853A requires 11V to 52V DC phantom power or a 1.5V AA battery for
operation. A battery need not be in place for phantom power operation.
Alkaline batteries are recommended for longest life. Remove the battery dur-
ing long-term storage.
The U853R requires 11V to 52V phantom power operation only.
A uniform 120° angle of acceptance provides well-balanced audio pickup.
The microphone should be located forward of the front-most source, above
the rear-most source, and "aimed" between them (Fig.1). Increasing the
height of the mic above the sources will tend to equalize sound levels be-
tween them, but may also increase from the mic to the rear-most pickup
should be no more than twice the distance to the front source, to maintain
front-to-rear balance (Fig.1).
Width of pickup is approximately three times the distance to the closest per-
former. If additional mics are needed for wide sources, they should be posi-
tioned apart laterally at least three times the distance to front source, to avoid
phase cancellation (Fig.2).
To orient the microphone in the proper direction, twist the housing slightly in
its wire holder. (Clockwise rotation moves the microphone to the right; coun-
terclockwise rotation moves it to the left.)
Output from the power module's XLRM-type connector is low impedance
(Lo-Z) balanced. The signal appears across Pins 2 and 3; Pin 1 is ground
(shield). Output phase is "Pin 2 hot" - positive acoustic pressure produces
positive voltage at Pin 2.
At integral 80 Hz high-pass UniSteep ® lter provides easy switching from a
at frequency response to a low-end roll-off. The roll-off position reduces the
pickup of low-frequency ambient noise (such as trafc, air-handling systems,
etc.), room reverberation and mechanically coupled vibrations.
Avoid leaving the microphone in the open sun or in areas where tempera-
tures exceed 43°C for extended periods. Extremely high humidity should also
be avoided.
10 dB
20k10k5k2k1k50020010050
8 kHz
200 Hz
1 kHz
5 kHz
330°
300°
270°
240°
210°
180°
150°
120°
90°
60°
30°
Polar Pattern Frequency Response
SCALE IS 5 DECIBELS PER DIVISION
LEGEND
Frequency in Hertz
LEGEND 12” or more on axis
Roll-off
Response in dB
FORM No. ATGC-L0010-05-E
Machida Tokyo Japan
SPECIFICATIONS
ELEMENT Fixed-charge back plate
permanently polarized condenser
POLAR PATTERN Cardioid
FREQUENCY RESPONSE 30-20,000 Hz
LOW FREQUENCY ROLL-OFF 80 Hz, 18 dB/octave
OPEN CIRCUIT SENSITIVITY (re 1V at 1 Pa)
U853A (Phantom / Battery) -42 dB (7.9 mV) / -43 dB (7.0 mV)
U853R -39 dB (11.2 mV)
IMPEDANCE
U853A (Phantom / Battery) 200 ohms / 270 ohms
U853R 250 ohms
MAXIMUM INPUT SOUND LEVEL (1 kHz at 1% T.H.D.)
U853A (Phantom / Battery) 133 dB / 123 dB SPL
U853R 139 dB SPL
DYNAMIC RANGE (typical) (1 kHz at Max SPL)
U853A (Phantom / Battery) 109 dB / 99 dB
U853R 115 dB
SIGNAL-TO-NOISE RATIO
U853A 70 dB, 1 kHz at 1Pa
U853R 70 dB, 1 kHz at 1Pa
PHANTOM POWER REQUIREMENTS 11-52V DC, 2 mA typical
SWITCH
U853A Off, on-at, on-roll-off
U853R Flat, roll-off
BATTERY TYPE (U853A) 1.5V AA/UM3
BATTERY CURRENT / LIFE (U853A) 0.4 mA / 1200 hrs typical (alkaline)
WEIGHT
MICROPHONE (U853A / U853R) 14 g / 14 g
POWER MODULE (U853A / U853R) 139 g / 81 g
DIMENSIONS
MICROPHONE 34 mm - long, 12.2 mm - diameter
POWER MODULE (U853A) 84 mm(H) x 63 mm(W) x 22 mm(D)
(U853R) 92.9 mm -long, 18.9 mm diameter
OUTPUT CONNECTOR Integral 3-pin XLRM-type (power module)
CABLE 7.6m long (permanently attached to mi-
crophone), 3.2mm diameter, 2-conductor
shielded cable with TA3F-type connector.
OPTIONAL INTERCHANGEABLE ELE-
MENTS
UE-C cardioid (120°)
UE-H hypercardioid (100°)
UE-O omnidirectional (360°)
UE-UL UniLine™ (90°)
ACCESSORIES FURNISHED
U853A / U853R AT8153 two-stage foam windscreen;
AT8451 steel hanger
U853AW / U853RW AT8153(WH) two-stage foam windscreen;
AT8451(WH steel hanger;
Battery (U853AW)
OTHER Battery (U853A / U853AW),
AT8531 power module(U853A / U853AW),
AT8538 power module(U853R / U853RW),
AT8438 ⅝"-27 stand adapter.
3 TIMES
DISTANCE "X"
MIC A MIC B
120° 120°
120°
ANGLE OF
ACCEPTANCE
DISTANCE "X"
LESS THAN 2 TIMES "X"
Fig.2Fig.1


Produkt Specifikationer

Mærke: Audio-Technica
Kategori: Mikrofon
Model: U853RW

Har du brug for hjælp?

Hvis du har brug for hjælp til Audio-Technica U853RW stil et spørgsmål nedenfor, og andre brugere vil svare dig




Mikrofon Audio-Technica Manualer

Mikrofon Manualer

Nyeste Mikrofon Manualer

Shure

Shure MoveMic Manual

17 November 2024
Comica

Comica DUAL.LAV D03 Manual

17 November 2024
BOYA

BOYA BY-PM500W Manual

17 November 2024
Elgato

Elgato Wave Panels Manual

16 November 2024
Warm Audio

Warm Audio WA-8000 Manual

15 November 2024
Pyle

Pyle PDWM3100 Manual

15 November 2024
Behringer

Behringer TM1 Manual

15 November 2024
Yamaha

Yamaha RM-WCH-8 Manual

14 November 2024
Yamaha

Yamaha RM-WOH Manual

14 November 2024