Barska AX11970 Manual
Læs nedenfor 📖 manual på dansk for Barska AX11970 (2 sider) i kategorien Kluis. Denne guide var nyttig for 2 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/2
PARTS OF THE SAFE
Parts of the Safe
A. Key Entry
B. Indicator Light
C. Fingerprint Scanner
D. Wake Up Button
E. Initialization Button
F. Battery Compartment
and Cover
G. Cable Slot
H. Mounting Holes
(located under the safe)
See reverse side for more information
A
B
C
D
FG
E
8/12
BC239
H
OPENING THE SAFE WITH ACCESS KEY
1. Insert access key into key entry, turn clockwise to open,
partially lift lid of safe and remove access key by turning it
counter clockwise
2. Open safe by lifting the lid of the safe
NOTE
Store access keys in a secure place. NOT inside of safe
When calling for replacement or additional access keys have
the access key code number ready. The access key code is
etched in the key entry and on the access keys.
BATTERIES
1. Locate the battery compartment and remove battery cover
2. Gently slide battery holder out of the compartment
3. Place 4, AA batteries and pay attention to the polarity of
each battery
4. Gently slide battery holder back into place
5. Replace battery cover
REPLACING BATTERIES
The red indicator light will start flashing and a continuous
beeping sound will be heard. This indicates that the batteries
are low.
1. Open safe by using the access key; turn clockwise
2. Repeat steps 1-5 of “Batteries” and replace old batteries with
new batteries
3. Close safe and ensure that the safe is locked
NOTE
After replacing the batteries safe retains registered fingerprints
REGISTERING A FINGERPRINT
The safe is in demo mode, ANY fingerprint can open the safe
1. With the safe open press and release the initialization button
2. A beep will be heard and scanner will flash red
3. Immediately place desired finger on the scanner
- Hold finger still, until registration process is complete
4. Registration process is complete when a total three beeps
are heard. See below
Successful Save
- Indicator light will flash green, followed by one beep,
indicator light will flash green twice and two
consecutive beeps
- Registration has been successful
Unsuccessful Save
- Indicator light will flash green, followed by one beep,
indicator light will flash red and two consecutive beeps
- Repeat registration process again
NOTE
- To add more fingerprints/users repeat steps above
- Stores up to 120 fingerprints
- For security purposes wipe fingerprint off scanner
For Accurate and Consistent Fingerprint Scanning
- Use scanner in low light conditions
- Use the index finger
- Place and hold finger firmly on the scanner
- Each user should register 2-3 different fingerprints
TESTING A REGISTERING A FINGERPRINT
1. With safe lid open, press the wake up button
2. Place registered finger on the scanner
Successfully Saved Fingerprint
- Indicator light will flash green indicating a valid fingerprint
- You will hear the safe unlock
Unsuccessful Fingerprint
- Indicator light will flash red and green consecutively
indicating that the fingerprint in not valid
- Repeat steps in “Registering A Fingerprint”
4. Close safe and ensure that the safe is locked
5. For security purposes wipe fingerprint off scanner
OPENING THE SAFE USING A FINGERPRINT
1. Press the wake up button
2. Place registered finger on the scanner
3. The indicator light will flash green indicating a valid fingerprint
4. Gently lift the door of the safe
5. Close safe and ensure that the safe is locked
6. For security purposes wipe fingerprint off scanner
DELETING ALL FINGERPRINTS
1. With the safe open locate the battery compartment and
remove battery cover
2. Gently slide battery holder of out of the compartment
3. Remove all 4, AA batteries from battery holder
4. Press wake up button a few times to release remaining
electronic power
5. Re-insert 3, AA batteries and pay attention to the polarity of
each battery
6. Press and hold down the initialization button
7. Re-insert the last AA battery you will hear 2 beeps, release
initialization button
8. Gently slide battery holder back into place and replace
battery cover
WARNING
Avoid leaving safe door open and unattended; it will allow
unauthorized individuals to add their fingerprint and/or
reprogram the safe, gaining full access to the safe and the
contents.
User Manual For Portable
Biometric Compact Safe
Produkt Specifikationer
Mærke: | Barska |
Kategori: | Kluis |
Model: | AX11970 |
Har du brug for hjælp?
Hvis du har brug for hjælp til Barska AX11970 stil et spørgsmål nedenfor, og andre brugere vil svare dig
Kluis Barska Manualer
25 August 2024
25 August 2024
25 August 2024
25 August 2024
25 August 2024
25 August 2024
25 August 2024
25 August 2024
25 August 2024
25 August 2024
Kluis Manualer
- Kluis Philips
- Kluis Nedis
- Kluis Abus
- Kluis Burg Wächter
- Kluis Dometic
- Kluis Honeywell
- Kluis Topcraft
- Kluis Master Lock
- Kluis Yale
- Kluis Olympia
- Kluis Olymp
- Kluis Perel
- Kluis Fluke
- Kluis SentrySafe
- Kluis Avanti
- Kluis SereneLife
- Kluis First Alert
- Kluis Kidde
- Kluis Toolland
- Kluis Salvus
- Kluis Hard Head
- Kluis Guzzanti
- Kluis Phoenix
- Kluis Conrad
- Kluis Varo
- Kluis Sentry
- Kluis Filex
- Kluis Kreator
- Kluis Handson
- Kluis Nauta
- Kluis Jewel
- Kluis Sistec
- Kluis Rottner Tresor
- Kluis Oxloc
- Kluis Winholt
- Kluis Protector
- Kluis Homak Security
- Kluis NOFIRE
- Kluis Technomax
- Kluis Kreator-Varo
- Kluis M-Locks
- Kluis Fichero
- Kluis EasySafe
- Kluis ROMA
Nyeste Kluis Manualer
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024