Barska AX12660 Manual
Læs nedenfor 📖 manual på dansk for Barska AX12660 (2 sider) i kategorien Kluis. Denne guide var nyttig for 2 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/2
User’s Manual for Key Safe
WARNING
Read all instructions before using this safe.
A. Handle
B. Key Access
C. Key Pad
D. Indicator Lights
E. Key Drop Slot
- Located on the side of the safe
- For security purposes, change the factory default
code as soon as possible. Factory default code
is 159 and 011223.
-Test registered pin code a few times before closing
the safe door.
- Avoid leaving door open and unattended; it will allow
unauthorized individuals to reprogram the safe,
gaining full access to the safe and its contents.
- Store emergency keys in a secure place; NOT inside
of the safe.
- To maximize security and performance of the safe,
test pin code every 6 months.
L
o
c
k
U
n
l
o
c
k
See reverse side for more information
GETTING STARTED
Remove emergency keys and other included
accessories from packaging.
KEY ACCESS
1. Remove grey key cover located on the safe to expose
key hole.
2. Use emergency key and insert into key hole, turn key
counter clockwise and turn handle clockwise.
BATTERY
Battery compartment is located on the inside of the door
safe.
1. Remove battery compartment cover.
2. Insert four AA alkaline batteries into the battery
compartment and restore battery compartment cover.
Note: Do not mix new and old batteries
PIN CODE REGISTRATION
1st Safe Default Pin Code : 159
2nd Safe Default Pin Code : 011223
1. Press “* *”, then yellow indicator light next to warning
will light up.
2. Input current user code that you want to change, and
press “#”.
3. Input your new pin code you want to change it to and
press “#”.
4. Input your new pin code one more time to confirm
registration and press “#.” Yellow light will turn off,
meaning code has been registered.
Repeat steps above to change second pin code
TESTING REGISTERED PIN CODE
With safe door open turn handle counter clockwise to
extend the bolts. Enter registered pin code and press “#”
safe should unlock. Turn handle clockwise and bolts
shall retract; if safe unlocked then registration is
complete.
Note: If safe does not unlock then pin code registration
was unsuccessful. Please start over with Pin Code
Registration.
DELETING PIN CODES / RESETTING SAFE TO
FACTORY DEFAULT MODE
Please only reset the safe if Pin Codes are lost or
forgotten.
PARTS OF THE SAFE
A
B
E
C
D
1. Open safe and remove screws securing the back
cover to the safe.
2. You will see a small button located on the
circuit board.
3. Press and hold small button until you see all the
lights flash and 2 quick beeps will be heard.
4. All pin codes have been resetted to factory
Default Pin Codes.
Note: 1st Safe Default Pin Code : 159
2nd Safe Default Pin Code : 011223
MOUNTING INSTRUCTIONS
The safe may be mounted to a wall. Be aware of the
load bearing. Failure to do so can result in personal
injury and/or damage to property. Use appropriate
tools when performing work and always use eye
protection.
- Do not mount the safe without anchoring to the
wall.
- Find the studs in the wall, at your desired location.
Most studs are 16 inches or 24 inches apart.
- Check the wall for concealed wires or pipes.
- Measure the location of the pre-set drill holes; mark
their exact position onto the wall ensuring that the
studs or anything else behind will not interfere.
- Drill the appropriate size holes for the anchors you
are using.
- Carefully press the anchor into the holes at
this time.
- Mount the safe by running screws from inside of the
safe and securing to anchors; ensure the safe is
mounted securely.
8/16
BC451
© 2016 BARSKA®
855 Towne Center Drive | Pomona, CA 91767
(t) 888.666.6769 | (f) 909.445.8169 | www.barska.com
Produkt Specifikationer
| Mærke: | Barska |
| Kategori: | Kluis |
| Model: | AX12660 |
Har du brug for hjælp?
Hvis du har brug for hjælp til Barska AX12660 stil et spørgsmål nedenfor, og andre brugere vil svare dig
Kluis Barska Manualer
25 August 2024
25 August 2024
25 August 2024
25 August 2024
25 August 2024
25 August 2024
25 August 2024
25 August 2024
25 August 2024
25 August 2024
Kluis Manualer
- Kluis Philips
- Kluis Nedis
- Kluis Abus
- Kluis Burg Wächter
- Kluis Dometic
- Kluis Honeywell
- Kluis Topcraft
- Kluis Master Lock
- Kluis Yale
- Kluis Olympia
- Kluis Olymp
- Kluis Perel
- Kluis Fluke
- Kluis SentrySafe
- Kluis Avanti
- Kluis SereneLife
- Kluis First Alert
- Kluis Kidde
- Kluis Toolland
- Kluis Salvus
- Kluis Hard Head
- Kluis Guzzanti
- Kluis Phoenix
- Kluis Conrad
- Kluis Varo
- Kluis Sentry
- Kluis Filex
- Kluis Kreator
- Kluis Handson
- Kluis Nauta
- Kluis Jewel
- Kluis Sistec
- Kluis Rottner Tresor
- Kluis Oxloc
- Kluis Winholt
- Kluis Protector
- Kluis Homak Security
- Kluis NOFIRE
- Kluis Technomax
- Kluis Kreator-Varo
- Kluis M-Locks
- Kluis Fichero
- Kluis EasySafe
- Kluis ROMA
Nyeste Kluis Manualer
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024
1 Oktober 2024