Bobrick B-164 Manual
Læs nedenfor 📖 manual på dansk for Bobrick B-164 (3 sider) i kategorien Spiegel. Denne guide var nyttig for 17 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere
Side 1/3
Mark the location of the mounting holes. See individual product
specications on page two for mounting hole locations.
1.
PARTS/TOOLS NEEDED:
Backlit Mirror Mounting Hardware Electric Drill Wiring Kit
IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS
Read all instructions before using this mirror.
MIRRORS SHOULD ONLY BE INSTALLED USING THE FOLLOWING INSTRUCTIONS. FAILURE TO
FOLLOW THESE INSTRUCTIONS WILL VOID THE WARRANTY.
WARNING - To reduce the risk of burns, fire, electric shock, or injury to persons:
• Unplug power before putting on or taking off parts.
• Close supervision is necessary when this mirror is used by, or near children, invalids, or disabled persons.
• Use this mirror only for its intended use as described in these instructions. Do not use attachments not recommended by Bobrick.
• Never operate this mirror if it has a damaged cord, if it is not working properly, if it has been dropped or damaged, or dropped
into water. Contact Bobrick for a replacement mirror.
• Keep the cord away from heated surfaces.
• Never drop or insert any object into any opening.
• Do not use outdoors.
• Exposing the mirror edges to liquids may cause a permanent discoloration to the mirror etching that is NOT covered by Bobrick warranty.
• Risk of electric shock - Connect this mirror to a properly grounded outlet only. See grounding instructions. WARNING:
CLEANING INSTRUCTIONS
• Clean mirrors with warm water and a soft, lint free cloth, do not allow liquids to seep under the edges. Don’t use abrasive,
acid or alkali cleaners or products with ammonia or vinegar.
• Apply mild cleaners directly to a cloth, do not spray directly on the mirror. Applying liquids directly to the mirror’s surface may allow the
liquid to seep/wick between the layers on the edge of the mirror. If this occurs there may be a permanent discoloration on the mirror
etching which is NOT covered by Bobrick warranty.
• Dry mirror immediately following cleaning and make sure all joints and edges are dry.
ADA requires that “Mirrors shall be mounted with the bottom edge of the
reecting surface no higher than 40 in (1015mm) above the nished oor
1.”
For lit mirrors this means the dimension is to the inner most edge of the lit portion.
40"
Finished oor
INSTRUCTIONS FOR INSTALLATION
BOBRICK MODEL B-164 BACKLIT MIRROR
Produkt Specifikationer
| Mærke: | Bobrick |
| Kategori: | Spiegel |
| Model: | B-164 |
Har du brug for hjælp?
Hvis du har brug for hjælp til Bobrick B-164 stil et spørgsmål nedenfor, og andre brugere vil svare dig
Spiegel Bobrick Manualer
23 August 2024
23 August 2024
23 August 2024
23 August 2024
Spiegel Manualer
- Spiegel Ikea
- Spiegel Beurer
- Spiegel Medisana
- Spiegel BaByliss
- Spiegel JYSK
- Spiegel Livarno
- Spiegel Miomare
- Spiegel Haier
- Spiegel Innoliving
- Spiegel Valera
- Spiegel Orbegozo
- Spiegel Homedics
- Spiegel Lanaform
- Spiegel Carmen
- Spiegel Rotel
- Spiegel Boss
- Spiegel Livarno Lux
- Spiegel Conair
- Spiegel V-TAC
- Spiegel Rostra
- Spiegel Sanexo
- Spiegel Personal Care
- Spiegel Fenomé
- Spiegel Viidako
- Spiegel Kristall Form
- Spiegel Coaster
Nyeste Spiegel Manualer
17 December 2024
17 December 2024
17 December 2024
17 December 2024
17 December 2024
17 December 2024
17 December 2024
8 December 2024
8 December 2024
8 December 2024